Question about 1998 Volvo C70

1 Answer

How do I replace the fog lights on my 98 C70? I can't figure out how to get the housing off to replace the bulb. Do you have instructions or a diagram showing how it comes apart?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 92 Answers

I could track it down and e/mail it to you, but your best bet is to get a Haynes Manual for your vehicle (free from all libraries) or at most any auto parts store or thru Amazon.

Just a tip:

Odds are they are halogen bulbs.
Handle the bulbs with gloves while installing.
If not, the oil from your fingers can cause them to blow once they get
hot.

Good luck.

Posted on Oct 02, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace a fog light bulb on a 2007 Toyota Camry SE


Should b able to unbolt/unscrew skid plate if it has it and go in behind the light..may b tabs or little bolt/screws holding it on...some fog lights come w interchangeable bulbs that u twist out from the housing...some u have to replace whole housing..not sure of the exact setup but that's where I'd start

Sep 06, 2014 | Cars & Trucks

1 Answer

How do I replace the bi-xenon bulb in my 2007 Volvo C70


I just did this on my 2008 C70, which I believe uses the same type of bulb. It's very easy. By the time you do your second one, you can probably do it in less than 5 minuites.

1) Take careful note of the orientation of the headlight houseing retaining pin, HID transformer, and bulb retention device.
2) Refer to the owners manual to pull the headlight housing retaining pin.
3) Pull the headlight housing forward until you can access the wiring harness plug. Push the clip on the top of the plug to unlock, then remove the plug.
4) At this poing the entire headlight housing is detached from the car. Take it indoors and have a beer before the next step.
5) Push back the two spring clips and remove the access door from the back of the headlight housing.
6) At this point in the owners manual, the instructions tell you to refer the problem to an expert and do not provide further details. Shoot you got the darn thing out. And you have a beer in hand. You look like an expert. Let's continue.....
7) The low beam light has a transforer attached to the back of the bulb. Unplug the wires attached to the transformer.
7) Twist the transformer counter clockwise 1/8 turn, and remove the transformer.
8) The base of the bulb is now visiable, but the bulb is held in by a large retaining knurled plastic knob about 1-3/4 inch in diameter. Twiist that knob 1/8 inch turn counter clockwise and remove.
9) The old bulb is now free, and can be removed. Do not touch the glass on the new bulb, but carefully seat it in the same orientation in the housing.
10) Assembly is a reverse of the previous steps. Hopefully you paid attention to the orientation during removal, as the bulb, retaining knob, transformer, and housing retaining pin all are keyed and will fit in one way only.
11) Have another beer, and bask in the admiration of your family and friends, you expert you! Congratulations!

Jan 27, 2011 | 2007 Volvo C70

1 Answer

How do I change a brake light bulb in a 1999 c70 volvo?


Welcome to FixYa.com
Brake Lamp Replacement

Location of the lights

Image

The illustration shows the locations of the lights on the RH side. The LH side is the same but

mirror-reversed.

The lights have the following functions:

- 1 +1 = Parking light Fail light

- 2 = Reversing light

- 3 = Fog light LH side only (LHD cars)

- 5 = Direction indicator

- 6 = Brake light

Image

Tail light changing bulbs

Ignition off.

Open the cover in front of the tail light

Undo the wing nut and take out the lamp holder.

Change the defective bulb.

Fit in reverse order.

Check that all bulbs lamps are intact and in working order.

Image

Replacement of tail light cluster

Note! If a new tail light is to be fitted, the sleeves must be ground down 1.5 mm.

Open the cover in front of the tail light Undo the panel partly in front of the tail light Unplug the

connector for the tail light Undo the four nuts securing the tail light see illustration.

Pull the tail light straight out. Fit in reverse order

Note! check the sealing and fit on reassembly.

Check that all bulbs lamps are intact and in working order.Thank you for Using FixYa.comKind Regards, LeeYour FixYa Expert and Master Technician

Jan 27, 2011 | 1999 Volvo C70

1 Answer

How do you replace the fog light bulb on 2008 avalanche


    • 1 Open the hood and reach down into the engine bay for the fog light assembly. If you cannot reach the fog light assembly from the top you may need to get underneath the truck to reach it. Remove the electrical plug running to the fog light ballast.
    • 2 Remove the bulb. Unlock the fog light bulb by turning it counterclockwise and pulling it straight out of the assembly.
    • 3 Slide a new bulb into the fog light assembly. The part number you will need for the new bulb will be located on the ballast or base of the old bulb.
    • 4 Turn the bulb clockwise to lock it into the fog light housing.
    • 5 Reconnect the electrical connector to the bulb ballast.

Jan 23, 2011 | 2007 Chevrolet Avalanche LTZ

1 Answer

How do you replace a fog light bulb in a 1998 pontiac grand prix


the fog light bulb in the 98 Grand Prix is easy pull pigtail off light turn light from back and it will come out , replace is reverse obviously , but make sure the orientation is correct on housing as there is one tab bigger than the other 2 have to look at it from underneath to see orientation of the bulb housing.

Dec 04, 2010 | 1998 Pontiac Grand Prix

1 Answer

How to change Ford Explorer fog light


p, li { white-space: pre-wrap; }

Open the hood and remove the electrical plug from the back of the fog light ballast below the headlight assembly.



Turn the fog lamp counterclockwise to unlock it from the fog light housing.



Insert the new fog lamp. Align the notches on the fog lamp housing with the tabs on the new bulb and turn the bulb clockwise to lock it into the housing.



Reconnect the fog lamp electrical plug.

Sep 13, 2010 | 1999 Ford Explorer

2 Answers

I cant get to the lower fog light housing on my 98 trans am


yes u get it at the bottom,,u have to remove the splash guards to get to it,,

Feb 20, 2010 | 1998 Pontiac Firebird

1 Answer

Describe how to change fog lamp (just the bulb) on 2005 subaru forester. As far as I know the fog light assembly is fine, the bulb has just burned out. If you know which bulb to use please let me know,...


2005 Forester - It is easiest to remove the fog assembly.

1. From underneath the vehicle pry out one plastic fastener to be able to bend the light weight plastic mud protector downward. You will see the underside of the fog light assembly with one 10mm bolt directly above you. Remove this bolt.
2. From the front of the vehicle unscrew one 10mm bolt at top of fog light (this is the shorter of the 2 by the way) and pry out one plastic rivet adjacent to it.

3. Carefully remove the fog assembly and disconnect 2-pin power connector by pulling up on the release. Carefully wiggle the housing out (no force req'd).
4. Unscrew the back from the housing and replace H3 bulbs. Take care not to touch the bulb while replacing.

5. Reverse to install.

Should take an hour at most.

Dec 15, 2009 | 2005 Subaru Forester

1 Answer

Put new bulbs in fog lights, now fog lights wont come on. 98 cadi catera. replaced old bulbs with new halogen bulbs now neither fog light will come on


Halogen bulbs are brighter and generally draw more current than standard filament ones.
Have you check that the supply fuse has not popped ?

Jun 21, 2009 | 1998 Cadillac Catera

2 Answers

Changing fog light bulb


I just replaced the fog light bulb on my 2008 Azera. I went under the car and removed two screws from the protective shield. I pulled down the shield and reached up and turned the fog light socket and pulled it out of the housing, remembering which side the wires were on and removed the old bulb (Don't touch the new bulb with your hand) and replaced it with the new bulb. The job took less then 15 minutes

Aug 08, 2008 | 2002 Hyundai Santa Fe

Not finding what you are looking for?
1998 Volvo C70 Logo

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...