Question about 2001 Ford Explorer Sport Trac
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Before I pulled anything off I would start checking fuses. More than likely the fuse you'll be looking for will be under the hood. But I'd go ahead and check all of the fuses just to be sure. ( A blown fuse will either be smokey looking, or you'll be able to see a broken piece of wire in the middle of it). If that is not the problem then more than likely a relay or the control computer for the 4x4 is messed up. Generally, if there is a mechanical problem with the transfer case, or the servo motor that changes it's gears, the 4x4 indicator lights will flash. Since they are not flashing I believe your problem is in the electrical system. If it is not a fuse, I recommend having a mechanic look at it. Merry Christmas!
Posted on Dec 24, 2008
Start the car
put in " N"
turn the 4X4 switch on
Then put in gear..
What do you see now?
Do the same in reverse when you take out of 4X4
Posted on Jan 19, 2009
Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.
The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.
Posted on Apr 02, 2009
Well, the best way is to place the vehicle on a hoist and raise all 4 wheels off the ground and put it in 4WD and see if all the wheels start turning.
Another way is to make a really sharp (slow) turn while the unit is in 4 wheel high or 4 wheel low on dry pavement. You should be able to feel the driveline wrap-up caused by the front wheels trying to grab during the hard turn.
4 Low should be easily distinguishable from 4 High as well as 2 Whl when you accelerate and it feels like the transmision is stuck in low gear and the engine starts screaming for mercy at high RPM and you are only doing 30 MPH.
Posted on Oct 18, 2009
Testimonial: "thanx i was able to get in in 4low,it just takes a few seconds as it goes from 4h then to 4l. I f I had the manual it probably would have told me that"
Check in your Owners Manual or download this document from this link: Ford/maintenance/owners_manuals
Hope helps (remember to rate this answer).
Posted on Apr 11, 2011
Testimonial: "yes thank you, i went to the web site ford gave me and didnt help at all. this was very useful since i didnt get a manual with my truck. "
Tips for a great answer:
Jan 10, 2016 | 2001 Ford Explorer Sport
Dec 25, 2012 | Cars & Trucks
Nov 09, 2012 | 2001 Ford Explorer
Oct 19, 2012 | 2001 Ford Explorer Sport Trac
Jan 03, 2011 | 2001 Ford Explorer Sport Trac
Oct 03, 2010 | 2001 Ford Explorer Sport Trac
Jan 31, 2010 | 1992 Ford Explorer
Mar 10, 2009 | 2001 Ford Explorer Sport Trac
Jan 19, 2009 | 1999 Ford Ranger SuperCab
Sep 04, 2008 | 2004 Ford Explorer Sport Trac
Dec 13, 2016 | 2001 Ford Explorer Sport Trac
1,261 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: