Question about Chrysler PT Cruiser

1 Answer

2005 pt cruiser turbo keyless entry no longer unlocks the trunk, the trunk release inside the glovebox just clicks when pushed and does not release either..please help!

Posted by on

  • sugarbear107 Oct 02, 2009

    spray what with lubricant? lol..sorry

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 101 Answers

Check for any manufacturer recalls on problem. if not spray with lubricant/

Posted on Oct 02, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is my emergency release for my trunk on my 2010 pt cruiser


There is a emergency release on the left rear seat latch that allows you when pulled to push the seat open to gain access that way, not through the trunk hatch

Feb 24, 2017 | 2010 Chrysler PT Cruiser

1 Answer

My 2004 pt cruiser shut off and will not even try to start. Shut the car up and came back next day and the alarm will not stop sounding. What can be the cause and how can i fix these problems?


2001 PT Cruiser Cuts Out, Engine dies for no reason ...

? 2:04
www.youtube.com/watch?v=cG9qCHfBhGw
Jan 10, 2014 - Uploaded by michelle salazar
2001 PT Cruiser Cuts Out, Engine dies for no reason ... picked it up on October 18, 2013 only to have it die on me while on the interstate. After it ...

Turn off alarm on 2009 PT Cruiser - PT Cruiser Forum - PT Cruiser ...

www.ptcruiserlinks.com > ... > Sound and Security Forum
Aug 18, 2013 - 10 posts - ‎8 authors It's not an add-on alarm, it's just the factory alarm. ... then I go in to panic mode (because it's horribly embarrassing when it goes off and won't shut off) and try everything else - like pressing the lock button, ... 2004 Pt Cruiser GT Car alarm installation, operation, problems and solutions ...
8 posts
May 17, 2013
KEYLESS ENTRY stop working
8 posts
Nov 1, 2009
How to reset Security.....
9 posts
Apr 26, 2009
Programming the keyless Remote
10 posts
Mar 13, 2005
More results from www.ptcruiserlinks.com

Oct 02, 2015 | Cars & Trucks

1 Answer

Need help with FOB not responding to commands to lock/unlock doors or open trunk and panic alarm won't work? Replaced battery (CR2032) already. The doors, trunk and starting the car will still function...


Your best bet would be to have the vehicle scanned for DTC'S - diagnostic trouble codes first . Do you know which of these your vehicle has ?
Keyless Entry System Inoperative (Active)
Keyless Entry System Inoperative (Passive)
Does the customer complain about other symptoms related to this, such as poor range when the key fob buttons are pressed or intermittent Tire Pressure Monitoring issues? (It's possible the RF External Antenna at the RCDLR may have a poor connection.)
YES - Go to Step 3
No - Go to Step 4
3
Inspect the external RF antenna connection at the RCDLR. First, gently pull on the coax connector at the module. If the coax comes out, then it wasn't seated properly. Remove and carefully inspect the coax connection for bent blades or a bent center pin. Fix coax connection if necessary and re-seat connector until a "click" is heard. Gently pull on the coax connection to make sure it is seated properly. Was the inspection made?

Press each button of the transmitter one at a time.
Does the system operate normally?
YES - Go to Testing for Intermittent Conditions and Poor Connections
NO - Go to Step 5
5
Lock and unlock the door locks using the controls inside the vehicle.
Do the locks operate properly?
YES - Go to Step 6
NO - Go to Symptoms - Doors

6
Operate the rear compartment release and the fuel door release from the controls inside the vehicle.
Do the rear compartment release and the fuel door release operate properly?
YES - Go to Step 7
NO - Go to Symptoms - Body Rear End

Important: Ensure that the keyless entry transmitter is the correct model for the vehicle remote system. A wrong model transmitter may pass this test, but will not activate the keyless entry system.
Turn on the J 43241 Keyless Entry Tester.
Place the transmitter on the J 43241 test pad.
Press each button of the transmitter one at a time.
Does a tone sound and the green light illuminate on the J 43241 after each button is pressed?
YES - Go to Step 12
NO - Go to Step 8
8
Do any of the buttons on the transmitter sound the tone and illuminate the green light when pressed?

11
Replace the keyless entry transmitter. Refer to Transmitter Programming.
Did you complete the replacement?
Go to Step 12
--
12
Perform the programming procedure. Refer to Transmitter Programming.
Did the drivers information center (DIC) beep and display a message ready for next fob?
Go to Step 14
Go to Step 13
13
Replace the remote control door lock receiver (RCDLR). Refer to Control Module References for replacement, setup, and programming.
Did you complete the replacement?
Go to Step 14
--
14
Operate the system in order to verify the repair.
Did you correct the condition?

Feb 21, 2018 | 2005 Cadillac STS

1 Answer

Hi 2005 accord, the keyless entry is not working,. When the button is pushed, it sounds like it wants to work, but it does not unlock the doors. The trunk button also cycles the motor or whatever but...


the battery in your remote entry may be dead. suggest you replace the battery in your remote before you take it to a shop.hope this helps and thank you for choosing fixya.com

Dec 30, 2010 | 2005 Honda Accord

2 Answers

My 2001 pt cruiser auto door locks no longer work nor does the key fob. The door locks were acting like sssharp's - doing their own thing and locking or unlocking on their own and rattling in the back door...


As stated above, it is most likely your RKE (remote keyless entry module). It is easy to find and relatively easy to replace yourself. I just recently did so on my 2002 PT Cruiser. Got a used module from a 2005 at a salvage yard. Put in the module myself. However, you do have to take it to the dealer to reprogram so your remotes work with the module replacement. That cost me $50. If you are interested in doing the labor yourself, email me. K4qts@aol.com

Jul 06, 2010 | 2002 Chrysler PT Cruiser

1 Answer

06 pt crusier wont start


fuel pump has`a`cut-off switch that needs to be reset. Two most common locations are in the trunk on the sides, or on the passenger side kickplate under the glovebox on the right side of the inside passengers right foot.

Apr 25, 2009 | 2006 Chrysler PT Cruiser

1 Answer

Car will not unlock.


To get inside the car .... Use the key in the lock cylinder, unlock the drivers door to get inside. You shouldn't have to reprogram the fob unless it or the keyless module was changed. There may be a blown fuse that supplies the keyless control module (check the owners manual for location). or wires that lead into the Drivers door may be damaged ... The keyless module is located inside the drivers door at the bottom behind the door panel ... do the unlock/lock and trunk release switches on the inside of the drivers door operate the locks and or trunk release? If so it is not the fuse ... and not the wires to it ... And it could be your BCM body control module, located in the dash board to right of your gas petal. Because the number entry keypad (code for that is on the inside of the right passenger trunk bracket arm) also doesn't work I assume it's not the key fobs themselves. Your 98 manual is correct for your car.

Apr 02, 2009 | 1998 Mercury Grand Marquis

1 Answer

The auto door lock feature dose not work.


There is 3 relays in one of the fuse panels that are labeled doorlocks one of them is probably bad. Push the door lock button and find the one that is clicking this is the one that is back. This should fix your problem

Feb 28, 2009 | 2003 Chevrolet Impala

2 Answers

Trunk won't open -1993 audi 90S


if you can drop back seats you can get in and manually flick the lever when it is open you will have to go to dealer to see if you can get a key to match or you might get 1 in a junkyard. if this helps please rate me

Nov 21, 2008 | 1993 Audi 90

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

320 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...