SOURCE: 5 amp fuse in passengers fuse panel keeps blowing
It also feeds the overhead console.Suspect that is were your problem is.
SOURCE: No cold air when A/C on but climate control works in controlling heat
Your problem is most likely that the AC system is low on refrigerant. Your Explorer takes R-134A refrigerant which is available over the counter. It's not a very difficult process to add refrigerant but if your uncomfortable doing it yourself, most service centers will service your AC for under $100 assuming no leaks are detected. Best of luck on your AC problem.
SOURCE: climate control system only blow air out defrost vent
there is a good chance that you blend air door is stuck closed over your heater core and therefore not allowing the heat to flow, also your door that opens and close your direction of flow from the floor ,das,vent and defrost.your going to have to remove the lower cowling of the dash on the passenger side analso some of the center dash to actually check to see if the cable,servo motors. are acuating the doors.the issue could be just a stuck door or a misaligned cable or that it came off. that falls under the mechanical side of probabilities. electrical would most likely be a faulty selector switch or a servo motor
SOURCE: climate control is on defrost only the auto
Check your vacuum pump located on the right side fenderwell. see if its running. Check the vacuum hose at the hubs for leaks or damage. repair if damaged. check for other vacuum leaks such as the grey hose going to the heater control valve.
SOURCE: climate control will only blow
your blend door actuator gear is slipping. remove actuator and check blend door for free movement. If jammed, you may have to open the system to unjam. If door is free to moe, replace actuator. See procedure below to access blend door. Not sure you need a lift, as long as you can get the 2 nuts off under the truck.
Fig. Blend door actuator - auxiliary
(1) Auxiliary line floor pan bracket nut (2 req'd)
Removal & Installation
(2) Auxiliary housing bolt
(3) Auxiliary housing bolt
(4) Auxiliary housing nut
(5) Auxiliary harness electrical connector
(6) Blend door actuator electrical connector
(7) Screw (3 req'd)
(8) Blend door actuator
To install:
Auxiliary line floor pan bracket nut (2 req'd), 71 inch lbs. (8 Nm)
Auxiliary housing bolts, 62 inch lbs (7 Nm)
Auxiliary housing nut, 62 inch lbs (7 Nm)
115 views
Usually answered in minutes!
×