Question about 1997 Lexus ES 300

1 Answer

Lock cylinder is stuck at a angle and can't get the key in all the way on driver side door. key goes in on passenger side but will not unlock the doors

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 185 Answers

Cylinder has failed on inside. you will need to replace both lock cylinders

Posted on Oct 03, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why wont my drivers side door unlock with the key?


If it works from the inside but not with the key, it could be a broken link between the lock cylinder and the door latch.

Jul 26, 2014 | 2003 Toyota Avalon

1 Answer

Door locks unlocks


Sounds like the main wiring loom into the door has been damaged.
Check near the hinges, where the door swings, to see if any damaged wires. Does the door lock and unlock from the drivers side switch?

Jan 04, 2014 | Toyota Cars & Trucks

1 Answer

When I attempt to use the key to unlock the driver's side door the key just spins


there is a linkage rod on the back of the key cylinder it sounds like it fell off

Aug 14, 2012 | Dodge Stratus Cars & Trucks

1 Answer

The driver's side door lock will not unlock using my ignition key for my 97 honda civic


Try lubing the lock cylinders with dry (never use wet lubes like WD40) spray comes in a little tube you just squeeze it and spray the dry lube into the lock to see if it frees up the lock cylinder. You can buy dry lock lube at any hardware store.

Jun 27, 2012 | Cars & Trucks

1 Answer

Power locks don't work with remote or control from


The door lock/unlock input from the driver's key switch goes to the Door Multiplex control unit (main switch), the Door multiplex control unit then sends a signal on the BUS (CAN) circuit to the passenger's multiplex control unit; the passenger's multiplex control unit then controls all the door locks. The passenger's door lock key switch inputs to the passenger's multiplex control unit, if the locks work from the passenger's side key switch but not the driver's side key switch, the most likely cause is the driver's multiplex control unit (main switch) not sending the signal to the passenger's side multiplex control unit. This could also be the drivers side door lock actuator. Hope this helps!

Jan 07, 2010 | 2003 Honda Pilot

1 Answer

Key lock on drivers door won't unlock the door


you need to take the door panel off, there is a rod in there that connects to the lock cylinder it frequently pops off, there is a little plastic clip that should hold it on to the cylinder it may be broken!!

Jun 25, 2009 | 1998 Dodge Ram 1500 4WD

1 Answer

98 camry door lock will not turn....


really sounds like the tumbler pins are stuck in the cylinder of the lock. mite want to spray some lubricant like(PB Blaster)or WD-40 in the cylinder key hole and push key in and out to see if tumblers will release..gd luck..chris

May 12, 2009 | 1998 Toyota Camry

1 Answer

Wont go off


Try unlocking from the passenger door. Some of these had a key cylinder switch on the back of the lock cylinder which deactivates the alarm. If it works ok from passenger side then the switch inside driver door would need replaced

Mar 22, 2009 | 2001 Jeep Grand Cherokee

Not finding what you are looking for?
1997 Lexus ES 300 Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

881 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...