Question about 1995 Toyota Tacoma

Open Question

95 Tacoma airbag light

I have a 95 Tacoma pickup, and the airbag light does NOT come on when I turn the ignition on. It is supposed to come on for ~5 seconds and go out to indicate that it is working. I have checked the bulb and verified I have power at the control module. I can jump the light circuit to ground and get the light to come on. How can I troubleshoot/reset the control module?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1996 Toyota Tacoma wont start when the engine is hot and sits a few minutes

I Hope You All Appreciate This FAST and EASY Inexpensive Repair That Even The Toyota Dealers Dont Seem To Know How To Fix !!! The Problem Is The Air filter temp sensor. Look On The Left Side Of the Air Filter Housing and Disconnect The Plug Thats Attached To The Spark Plug Like Plastic Sensor Mounted on The Side Of the Air Filter Housing, Now Go Start Your Truck !!! Your Truck Will Start And RUN Fine Now ! Replace The Sensor Approx $59 at Autozone... This Should Fix 90% Of Your Problems If your In the other 10% and it does not Fix it , Email Me and Ill See If I Can Help ! People Have Spent Hundreds and into The Thousand Dollar Area Trying to Resolve This Intermittant Problem At Inept Shops with Illiterate Mechanics ! If Your Happy With This Fix, BE Generouse ! I Do Accept Donations at Paypal Send to donsgirl89@yahoo.com Thank You JOE Mechaniac

Posted on May 18, 2009

Ad
  • 1 Answer

SOURCE: Need schematic for ignition system-has 4 wire dist. pickup and ignition module is mounted on the R/F fender

Resistive cottection between PIP (pin6) wire and connector at the ignition module. Cleaned and soldered wire to connector pin. Runs fine.

Posted on May 28, 2009

  • 1632 Answers

SOURCE: 2001 Toyota Tacoma- turn lights not working and cruise control

fuses???
Check relays.....
Harness grounds, engine ground,
Check the trailer harnes for short.
Vitally

Posted on Jun 02, 2009

  • 454 Answers

SOURCE: rear lights not working

Toyotas sometimes have multiple power wires coming off of the battery to fuse blocks. One of these wires may be broken. Electrical schematics are available on-line or in repair manuals. If you don't have one, go to the library and look in the repair manual section.

Posted on Oct 02, 2009

  • 1 Answer

SOURCE: toyota tacoma 2007 stereo wiring

Radio 12v blue/yellow + radio harness
Radio Ground brown - radio harness
Radio Ignition gray + radio harness
Radio Illumination green + radio harness
Factory Amp Turn-on N/A
Power Antenna N/A
LF Speaker +/- pink - purple +,- radio harness or amplifier
RF Speaker +/- lt. green - blue +,- radio harness or amplifier
LR Speaker +/- black - yellow +,- radio harness or amplifier
RR Speaker +/- red - white +,- radio harness or amplifier

Notes: If equipped, the amplifier is on the passenger side rear cabin wall.

Posted on Oct 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does SBS mean, it is lite up on my dashboard


I think you mean either ABS or SRS.
ABS refers to the braking system so this would need investigation....I.e.check brake fluid reservoir and for signs of leaks round brake pipes and wear on pads.
SRS supplemental restraint system...usually airbag warning light. They should go out after 5 seconds on start.sometime they can be reset by using various techniques like leaving the driver door open...turning the ignition on but not starting the car... Then pressing the door light switch button on bottom of driver door opening 5 or 6 or 7 times and turning off ignition All within 10 seconds.(you may need to experiment with this number )always hold the door light button in on last count whilst turning ignition off.then close door restart car.wait 5-7 seconds then it will reset unless there is actually a problem with airbag.this can occur when you disconnect battery or replace battery.the interruption can
alter airbags sensor.also some sensors are housed in the horn component of car horn and the spring on horn can interfere with the sensors normal operation.So did you recently remove battery or use horn excessively ?finally if it is an airbag fault and the light remains on it may mean your airbag will not deploy and your seat belts won't lock in a collision scenario.best in that event to get to a garage.if thus is of help please vote thank you.

Feb 11, 2015 | Cars & Trucks

1 Answer

95 toyota tacoma Airbag lights comes on stay on


that is s telling there is a problem. On some vehicles require a OBD2 code scanner for the diagnosis. Once you know the code, you can most likely repair it yourself. There are fairly easy procedures that most people are capable of repairing.
________________
GM tech2 scanner

Feb 22, 2013 | Cars & Trucks

1 Answer

2007 toyota tacoma truck- 4 cyl. Dog threw up into air vent- how do I clean out the vent on passenger side?


DISARM AIRBAGS FIRST TURN OFF RADIO.DISARM AIRBAGS DISCONNECTING NEGATIVE BATTERY CABLE WAIT 10 MINUTES BEFORE WORKING ON DASH AREA.TRY REMOVING THE GLOVE BOX.SEE CAN YOU REACH AND REMOVE VENT DUCT WHERE VOMIT IS REMOVE VENT FROM DASH AREA.LOOK INSIDE VENT OR AROUND OUTSIDE VENT DUCT FOR NUTS HOLDING IT IN PLACE.IF YOU HAVE ANY TROUBLE REMOVING DUCT LET GARAGE DO IT.IF ALL GOOD WHEN RECONNECTING NEGATIVE BATTERY REARMING AIRBAGS WAIT 2 MINUTES BEFORE STARTING VECHICLE LET AIRBAGS LIGHT TURN OFF FIRST THEN ITS ARMED AND READY.

Oct 07, 2010 | 2007 Toyota Tacoma

2 Answers

What does it mean when the airbag light comes on?


Either the sensor in the bumper has lost communication with the airbag module, or the airbag module is bad, or the airbag package itself is damaged somehow.

Sep 09, 2010 | 1995 Lexus ES 300

3 Answers

Air bag light always blinking?


Mine came on when my car hit 120K mi. I also reset it using a sequence within the car.

Problem Scenerio: turn car motor on, car conducts self test, during which time airbag light stays on for 5-second (or 5 or 6-beeps)..it turns off for a second then flashes 'off and on'...and annoys the hell out of you as you drive...especially at night.

Solution 1: put black electrical tape (band-aid) over airbag light indicator...annoying problem gone.

However, in VA the airbag light can't be flashing to pass the annual car inspection, so....

Solution 2: Reset the Airbag light using the following sequence I discovered and heard about:

1. Turn key / ignition to 'ON' (Do Not Start). and await for the self-testing procedure to end (Air Bag Light stays on for about 5-seconds or '6-beeps')
2. As soon as the Airbag light turns off - turn the ignition to OFF position and count 5-Mississippi's (that's 5-seconds).
3. Then turn ignition back to 'ON' Position and repeat step 1 & 2 again.

Conduct Steps 1 & 2 - Three times in a row.

After the 3rd or successful timed sequence, allow the car to go through it's complete self testing stage and as soon as its done the airbag light will flash...but at a slower pace (That is good!) That means the cpu is resetting. Once you observe the slow flashing airbag light, turn the car off, then start it normally and the airbag light 'should' reset (not flashing and bugging the **** out of you).

Then, take the black electrical tape off the dash panel and throw it away.

This is no joke and it really works!! if you have any questions, contact me. carl@sat-tel.com

Apr 28, 2010 | 2001 Nissan Maxima

1 Answer

I have a 95 jeep cherokee and i can't find the airbag light inthe dash for a state inspection where is it located can you help


Have the vehicle scanned for codes .See If SRS is one of the codes in memory. If it is repair it.
To locate the SRS light aka airbag system, putkey in ignition turnto on position and look at dash for SRS light. it will go out within 30 sec of vehicle being turned on.
Lastly go to a different station for Inspection.

Apr 08, 2010 | 1995 Jeep Grand Cherokee

1 Answer

Installed new rack ,have air bag light on


The steering wheel needs to be prevented from rotating when it is disconnected from the steering linkage. The airbag system uses a rotational sensor that is just below the steering wheel mounted airbag. (Often called a clock-spring)
I suspect is was damaged during your repair.
The airbag fault codes need to be read to confirm.
Good luck.

Mar 24, 2010 | 2006 Toyota Tacoma

1 Answer

My brother"s '95 Ext cab V-6 Nissan, I believe he said LE but I am not sure, the trucks igination sticks/locks up but sometimes he can get it out then but sometimes he has to wait. My husband was going to...


I'm not sure if your talking about the ignition switch or not(where the key goes to start it), but I can tell you that there is no airbags on a 1995 Nissan Pickup. If you need anymore help please let me know.

Feb 02, 2010 | 1995 Nissan Pickup

1 Answer

Need to replace blower motor in 98 b2500


(1)If vehicle is equipped with airbags, disarm the airbag system. To do this, turn the ignition switch to OFF position. Detach the cable from the negative battery terminal, then detach the positive cable. Wait two minutes for the electronic module backup power supply to be depleted. To enable the system, turn the ignition switch to OFF position. Connect the positive cable first, then connect the negative.
(2)Disconnect the blower motor connector.
(3) Remove the blower motor mounting screws and remove the motor.
(4)Remove the blower motor wheel hub pushnut and the clamp from the shaft. Pull the blower motor wheel from the shaft.
(5) Installation is the reverse of these steps.

Aug 29, 2009 | 1998 Mazda Pickup

Not finding what you are looking for?
1995 Toyota Tacoma Logo

Related Topics:

237 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...