Question about 2004 Audi A6

1 Answer

There bright red covers over the spark plugs. They look like they are the spark plug wires themselves but I can not figure out how to unclip or remove them for 2004 audi a6 3.0

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Those bright red covers you see are the tops of the coil packs. You just pull them off they are easy to replace and the plugs are beneath them

Posted on Nov 04, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does anyone know the spark plug wire order on a d15b7


Oil is leaking into your spark plug holes from the valve chamber. It's not a good idea to leave the oil in the spark plug holes, as it can pool high enough to damage the rubber boots of your spark plug wires, will make the plug hole really messy, and it may eventually become a fire hazard. Below is how to fix it.

Honda's preferred spark plug location means that the plugs (and their wires) must pass through deep recesses in the top of the valve covers to get to the combustion chamber. This gives better plug placement in the combustion chamber, and more zoom for your Honda. It creates a small problem though: Under the valve cover, all around the spark plug recesses, is an open space that is constantly being showered with oil, and that oil will get into the spark plug recesses unless something is done to keep it out. Honda does this by sealing any joins between parts with little rubber donuts (AKA "grommets").

The rubber donuts eventually get old and stop sealing, letting oil seep into the spark plug holes and puddle there. The cure is replacement of all four (or six), along with the valve cover gasket itself (themselves) at the same time. It's an easy project for anyone who's done more than just oil changes.

However, there's a fly in the ointment here: Certain Honda engines, specifically the 4-valve-per-cylinder, single-overhead-cam ones (such as the D15B that's used in many Civics), have an additional rubber seal under the one I just mentioned! This one also gets old and starts leaking, but these are a LOT harder to replace! Not a job for a beginner!

NOTE: The rubber parts under discussion here are not actually red and orange, they're black, I just used colors to make it clearer which was what.

Sep 28, 2016 | Cars & Trucks

1 Answer

Headlamp wiring


I'm going to start out by saying I don't know. But between the two of us we should be able to figure it out. I don't know how the wires are coming out of the new plug.
On the truck, the left headlight harness is white green, red black, and green black. White green is power, red black is the ground for the high beam, and green black is ground for the low beam.
On the right side, dark blue light green is power, and the other two are the same color as the left side.
If you look at the right side and figure out which terminal on the headlight the dark blue light green wire goes to, that is the same terminal you use on the left side for power. Then the other two wires are the same for both sides.
I can post a wiring diagram if you think it will help.

Jun 10, 2013 | 2002 Ford Escape

1 Answer

No spark in the coil now


You need to look up how to replace the valve cover seals

You obviously know you have an oil leak on the plugs

Using a screw driver may have ruined the ignition module,
at least use a spark plug in the cable, when you ground it
Check the other wires for spark

You always find info for doing any testing on electrical or
electronics,were not living in the 1960's any more,bad things happen

Need Valve Cover Gasket Set
Need New Ignition Wires
May as well do the Spark Plugs

The ignition components will sort themselves
out when you do take care of the oil leak,plugs
& wires

Mar 27, 2013 | Cars & Trucks

1 Answer

Make a little engine noise and shake a little.


Change spark plugs After checking. Open hood in the dark of night and look for sparking
along the plug wires and at the spark plugs themselves. If you can see sparking (or hear it) replace the wires.

Jan 27, 2011 | 1998 Honda Accord

1 Answer

Where are the spark plugs located?


The spark plugs will be in the engine compartment going to each cylinder.

If you look at your engine, you should see on the sides of it, a thick cable
going into each cylinder base. These will be your spark plug wires, and they
will be connected to the Distributor or Coil packs on the other end.

If your car is twin cam, you will see the plug wires will go through the Valve cover.
The spark plug wires will generally be black or red and have some little writing on them.

-Jackson
http://urbanscooters.com/

Oct 13, 2010 | 2001 Kia Sportage

1 Answer

Cant find spark plugs


Unclip, then remove the air plenum covering the coil packs, separate ignition coils for each cylinder, on either side of the main air plenum section.
Then remove each of the coil packs, they will look like long thin black strips that cover and connect the spark plugs. Replace the plugs after determining the specs for the proper gap.
Dab a bit of corrision resistant grease to the plug tips prior to reinstalling the coil packs.
After the coil packs are reinstalled you will then reinstall the plenum sections.
Good luck. :)

Apr 27, 2009 | 2001 Saturn L-Series

2 Answers

Need to change the spark plugs and cannot figure out how to remov


you just pull them off the plugs hope this helps regards Jim

Mar 29, 2009 | 2004 Audi A6

1 Answer

Where are the spark plugs and wires on a 2001 Lincoln Continenta?


This engine has coil on plug ignition. Ontop of each valve cover is an access plate with bolts you remove. After gaining access you will see the 4 seperate wires on each cylinder bank. At the end of each wire is the spark plug boot. Pull each one off one at a time while replacing the spark plugs. The wires themselves at the other end each have a seperate coil. I have not had to replace my wies and coils but did replace the sparkplugs at 100K miles.

Mar 22, 2009 | 2001 Lincoln Continental

2 Answers

Ihave changed the spark plugs but i dont know if put the caps in


Not sure what you're asking. The only order that matters is the order of the spark plug wires. There isn't an order for the spark plugs themselves. So are u looking for the order of the spark plug wires?

Nov 12, 2008 | Honda Civic Cars & Trucks

2 Answers

R32 2004


their is a high tension lead removal tool you can buy.if its coil per cylinder ther is a clip that you squeeze to remove the wires off the coil

Oct 15, 2008 | 2004 Volkswagen R32

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

189 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14251 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...