Question about 2003 Dodge Caravan

2 Answers

Front fan moor is not wotking, the 40amps fuse burn i replace it but wen i turn the switch on the lite dimers . Could it be the motor that have a probleme. tks.

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Dodge Master
  • 2,050 Answers

I would say yes. A 40 amp fuse is a lot of ampres. If the fan motor is dimming your lights, unplug the motor and try again to see if the switch isn't the issue.

Posted on Oct 01, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,865 Answers

Yes the motor is bad and must be replaced.

Posted on Oct 01, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Citroen xsara picasso 2.0hdi battery fuse keeps blowing.


If it's the main Fuse, rated above 40Amps, then usually only two components are directly connected to this circuit. The starter motor and the alternator. Both can get critical short to ground, that may blow such fuse.The thick battery cable goes directly to the starter motor and a smaller high amp wire is looped from there to the alternator. Third less likely would be main supply to ignition key switch.

Mar 21, 2014 | 2001 Citroen Xsara

1 Answer

Blower fan not working, WHERE IS THE FUSE


blower fuse. lost the operators guide>? get one.?

under hood box
fuse 56
its marked, heater motor, 40amps

Nov 19, 2013 | 2003 Acura MDX

1 Answer

My dash lights are goin when I start to drive the car it's not the fuse because they on wen it start prolly ghetto wiring it just broke yesterday


my guess its the switch does it have a dimer to raise and lower light level? mess with it roll the switch see if it comes on accidently and if it does start with that switch.. auto supply probably not to expensive good, luck

Dec 14, 2012 | Cars & Trucks

1 Answer

Heater fan has sto pped working. The car still lets heat in the cabin when control is turned up. Blower is not wotking. 2008 VW Rabbit.


First look to see if you have a fuse for the blower motor...then you will want to disconnect power to the fan an jump 12 volts to the fan motor to see if it works...if ok, then there is a speed control resistor that sometimes goes bad located on the heater assembly...It is usually right past the fan so the fan can keep it cool and has 4 or more wires on it. if all else ok then last would be the switch inside car

Dec 27, 2010 | 2008 Volkswagen Rabbit

1 Answer

Have a 2002 durango and the front fan does not work but rear does


it is possibly the switch, fuse, wires, or fan motor. use a test lite to check for power at the front fan connector with key on and fan switch on high. if you have power, fan is bad. if no power, check fuse, if good, you will need a wiring diagram and a bottle of prozac

Jul 07, 2010 | 2001 Dodge Durango

1 Answer

Fan blower stopped working


Hi Retta_roche,
This circuit is controlled through the switch. In the high position,it by-passes the blower resistor.So if the blower is off in the high position, and the fuse is good, you need to check the switch,blower motor or the wiring.Since the switch physically feels different,start there. Pull the switch and ground pin #4 blk/org wire with the key on. If the fan works,the switch is bad. You need to check the connector at the blower motor for evidence of a burn. If you find the connector burned,you will need to replace the motor and the connector. I am sending the wiring diagram to help you. If you need anything else,drop me a line. Thanks,Chuck d442985.gif

May 16, 2010 | 2000 Ford Focus

1 Answer

Heater fan motor quit working already checked all fuses and relays


check the fan switch in the dash and the fan motor connector for burning, if u find burned connectors replace them and the heater blower switch.

Mar 08, 2010 | 2003 GMC Sierra 1500

3 Answers

1992 Dodge stealth cooling fans wont work


Unplug you're fans.. Take some wires, ( i used speaker wire2.gif. ) Have someone help you, :) connect it to you're fan and then to the battery one to ground one to power. If you're fan doesn't turn on then you're motor in the fan is dead.

2nd.Check you're relays, Easy way to do this is switch them around one byone... They can't all be bad :P and if it turns on.. then you have abad relay:P

3rd. Does you're Temp gauge work? There are a few sensors That could need to be replaced.

Sep 05, 2009 | 1992 Dodge Stealth

1 Answer

Where is the front fan resistor unit?


Look under the van,on the drivers side near the radiator,it should be in that area.Follow the wires from the fans,they should go right to the module.This is for the cooling fans for the radiator.For the resister module for the blower motor look near the blower motor in the blower box.It is near the blower fan.It can be under hood,but it will be mounted with two screws.Remove the two screws,but you need to remove the wire plug in first.Pull it out .It goes inside of the blower box.If you replace this module,replace the blower motor also,because the blower motor is what causes the resistor to burn out.Did you check voltage at fuse with key on?If you did not check the fuse with key on,you got a false reading.If you checked the fuse with key on,look for a bad ignition switch,or a fusible link burned into coming off a pos. terminal post where the battery cable goes to under the battery.If the blower will not work at all even on high blower,the resister most likely not the resistor.The blower motor relay is most likely the problem.

Aug 29, 2009 | 2005 Dodge Caravan

2 Answers

98 Grand Cherokee blower fan works sparatically on all settings except low


chrysler blower motors pull alot of amps replace motor and resistor card

Aug 25, 2009 | 2000 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...