2001 Ford Windstar Logo

Related Topics:

Anonymous Posted on Oct 01, 2009

Windstar 2001 heater is not working cold air only no heat

1 Answer

Lee Seliga

Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

  • Expert 239 Answers
  • Posted on Oct 04, 2009
Lee Seliga
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

Joined: Sep 27, 2009
Answers
239
Questions
8
Helped
61114
Points
704

The first thing to check is your fluid level. No heat is one of the symptoms. Lee

Testimonial: "useless "

5 Related Answers

A

Anonymous

  • Posted on Nov 02, 2008

SOURCE: Ford windstar 2001

Replace the heater actuator switch it is not allowing the door to open, Ours did the same thing so I relaced it . it cost 90.00 from ford

Ad

Anonymous

  • 59 Answers
  • Posted on Feb 24, 2009

SOURCE: heater

Likely it has more to do with the door that controlls the airflow. Which should be operated by vacum might check and make sure all thevacum lines are plugged in.

Does the gauge in the car show it warms up?

Anonymous

  • 4669 Answers
  • Posted on Apr 08, 2009

SOURCE: Heater making noise and not blowing hot air.

You need to replace the temp actuator.

Anonymous

  • 4803 Answers
  • Posted on Oct 10, 2009

SOURCE: Why doesn't the heater blow hot air?

If your "Check Engine" or "Service Engine Soon" light is on, you need to have that checked out first.
If not, the next thing you should check is your engine coolant level. (Antifreeze) If the coolant level is low, the engine coolant does not circulate through the heater core and the the heater doesn't work. The coolant level could be low for a number of reasons including a leaky hose, water pump, or head gasket. In any case, if it is found to be low, you need to find out why.
If the coolant level is OK then the thermostat function needs to be checked to make sure that the engine is reaching operating temperature.
If all of the above checks out OK, then the heater control valve and/or the blend air door in the HVAC housing needs to be checked for proper operation. (NOTE: some cars are not equipped with a heater control valve)

Anonymous

  • 1 Answer
  • Posted on Dec 04, 2009

SOURCE: NO heat in front of 2001 windstar van. Thumping

where is the flaaper down located at in a windstar

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

9helpful
1answer

The heat in the front of my 2001 Windstar blows cold air but the rear heat works fine.

The blend door actuator is the most likely cause. It is on the front of the heater box under the dash and looks like the picture below and #14 on the system exploded diagram. Remove the actuator, plug it back into it's cable, turn the key on and change the temperature setting to see if the actutor turns. If not, replace the actuator.

jturcotte_77.jpg jturcotte_538.gif
0helpful
1answer

Blower is only blowing vent air no heat, was working yesterday now is not.

radiator full? Thermistat stuck open. extremely cold and too much air flow on radiator.?Does it over heat at all? Back flush heater core and radiator and replace fluids, block off part of radiator in extreme cold areas. Check controls to be sure they are opening and closing correctly
0helpful
1answer

Have cold air blowing but no heat

Hi there,

Well If you can turn on the heater but only cold air comes out you should check the blend door. It controls the door to switch from cold air to hot. It sits directly behind the heater/AC controls. It is white square plastic piece (approx 3in x 5in half inch thick and has a plastic screw rod that attaches to the heater/AC controls and they strip out

Please post further comments if you need more help or information.....

Good Luck!!

Thanks
3helpful
3answers

2001 Windstar- I have no heat or defrost. I do

I had this problem and noticed a faint clunking sound behind the radio. It was the blend door motor that needed to be replaced. The motor has small fine tooth plastic gears that wear out and won't open to allow heat.
0helpful
1answer

Ford Windstar SE, 3.8L V6, 1999, front seat heat/defrost is cold

the blendor actuators strip out the gear inside the actuator cases on these all the time. replace the actuator.
1helpful
3answers

Heater

Likely it has more to do with the door that controlls the airflow. Which should be operated by vacum might check and make sure all thevacum lines are plugged in.

Does the gauge in the car show it warms up?
0helpful
1answer

Heater blows cold air

maybe the heater matrix could be at fault, thats the bit that controls the temperature in the car.
0helpful
2answers

Ford windstar 2001

have mechanic check out your heater core its under the dash. chances are its pouched.
2helpful
3answers

My heater is not blowing hot air, the air conditioner seems to be working, I replaced the heater and airconditioner switch module but it didn't help

I have a 2001 ford winstar and my heater is not working I slide the ac/heater switch to heat and all it does is let out a thumping sound and blow cold air out and it is starting to get cold in the morning
Not finding what you are looking for?

488 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...