Question about 1991 Chevrolet Camaro

1 Answer

I was reading about a 3 wheeled vehicle called a roadstercycle that uses a chevy 350 engine and 700r4 transmission, but drives a single rear wheel with a chain. How do they connect the back of the trans to a sprocket turning 90 degrees perpendicular to the driveshaft?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 574 Answers

Right angle drive

Posted on Oct 01, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Move auto to a dolly to take to shop?


Using an automotive dolly can be risky, If the vehicle is front wheel drive then dolly the front, if it is rear wheel drive then dolly the rear. If it is 4 wheel drive and late model with no neutral shift position dolly the front and remove the rear drive shaft at the rear axle. If the vehicle is older 4 wheel drive with neutral selection for the transfer case then simply shift to neutral and dolly the front axle. Most transmissions whither automatic or manual will be damaged if the engine is not running while the vehicle is in motion.
the engines crankshaft or the transmissions input shaft must turn to lubricate the transmission unless the transmission is automatic and has a rear pump that can lubricate the transmission if the transmissions output shaft is turned in normal rotation for forward direction of travel. This is the only way to to assure there is no damage to the drive train. Be sure to follow all recommended tie down procedures. remember the dolly rotates under the vehicle so one or the other of the wheels must be able to move forward and back to allow for corners. Try to always choose a path that allows forward direction unless you are an expert driver with experience and able to back a farm wagon type axle trailer (like covered wagon) going backward will be a challenge even for someone experienced pulling a bumper pull trailer.
To get the vehicle onto a dolly have some friends help push or use a cable puller to move the vehicle onto the dolly.

Feb 15, 2015 | Cars & Trucks

1 Answer

What is a differential on a 1997 Ford Escort


The differential is inside and part of the transaxle. A transaxle has both the transmission and the differential together as a single unit. On rear wheel drive cars, the differential would be in the rear end- the large center case on the rear axle. With front wheel drive, the differential is incorporated within the transaxle. It is used to keep the front drive wheels turning properly during steering turns.

The differential uses the same oil or fluid as in the transmission/transaxle case-it is all the same piece, not serviced or flushed separately from the transmission, or transaxle as front wheel drive cars are called.

May 17, 2014 | Ford Escort Cars & Trucks

1 Answer

Will a 1988 chevy scottsdale transmission enterchange with earlier model transmissions like 1983 or 1984 with 350 or 305 engines


Three different transmissions could be in either the 88 or the 83 or84. The 4 speed auto 700r4, the 9 inch tail t-350, or the 9 inch tail t-375. as long as it is the same type transmission, they will interchange. The 4 speed 700r4 has some internal internal differences between the years, but will still work. The 350 or 375 trannys are identical from that year range.

Aug 17, 2011 | Chevrolet C1500 Cars & Trucks

1 Answer

Clutch installation maual for 2000 ford focus ZX3


Don't have manual but here;

the clutch is located between the engine and transmission. Therefore you must separate the engine from the transmission to gain access to the clutch.

This is much more difficult on a front wheel drive vehicle.

On most front wheel drive vehicles the easiest way to this is to remove the engine and transmission as a unit. However on a front wheel drive vehicle the engine and transmission come out from the bottom. You disconnect all of the hoses, wiring, linkage, etc just like on a rear wheel drive vehicle. You disconnect the suspension and steering. You disconnect the front "K" member (front sub frame). Then if you have everything disconnected properly you lift the body off of the drive train. You can then separate the engine from the transmission and service the clutch. You reverse your steps to reinstall the engine.

As you can see this is much more involved than accessing the clutch on a rear wheel drive truck where the transmission can be removed without removing the engine.

There are a few front wheel drive GM vehicles I have seen where the "K" member can be removed in pieces. On these vehicles you only remove half of the "K" member and you can remove the transmission without removing the engine. Not sure if this is possible on a Ford.

Nov 23, 2010 | Ford Focus Cars & Trucks

2 Answers

Hello! i have a 1989 GMC sierra 1500 2 wheel drive 350 engine, and i would like to know what size transmission does it take? the one i have in the truck now it will go into reverse but not drive, it leaks...


I would try replacing the transmission filter and fluid. There 2 different transmissions that came in the truck, a THM 400 3 speed, 13 bolt fluid pan, and a THM 700-R4 4 speed, 16 bolt fluid pan.

May 13, 2010 | 1989 GMC Sierra

1 Answer

Does my truck have abs brakes? It is 4x4 1992 chevy 1500


Your truck is equipped with RWAL or rear wheel anti-lock. This just worked on the rear brakes(duh) but the speed sensor was taken from the speedometer drive at the transmission tailshaft, and would allow one rear wheel to lock as long as the speedo kept turning. Later models were improved with wheel speed sensors at each wheel.

Apr 06, 2010 | 1992 Chevrolet K1500

2 Answers

Does my pickup have a 700r4


Yes it is a 700R4. They went to a 4L60E in 1993. Good Luck

Jun 05, 2009 | 1990 Chevrolet K2500

1 Answer

What size engine and transmission do i need for 24inch rims?


best bang for your buck 350 cid with a turbo 350 or 700r4 ... the 350 engine can be stroked out to 383 using the internals:pistons and crank from a 400 in big block... but just stroking a 350 on a hot tranny with low gears to drive those big wheels is important get a 4;11 low gear ratio you ll be able to drag that monster.

May 08, 2009 | 1987 Oldsmobile Cutlass Salon

Not finding what you are looking for?
1991 Chevrolet Camaro Logo

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...