Question about 1995 Ford Escort

Open Question

How to wire headlight connectors

My head light went out and i have replaced the bulb but no joy. i checked the wiring on the connectors and one of them has popped out. Are they easy to re- wire? if so how do you do it?

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: head light switch wiring

I hope this diagram works...I'm not great with MS Paint.
f14da54.jpg

Posted on Aug 30, 2008

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I fix HI beam headlights?


your switch is not good try to double check your switch.

Mar 09, 2015 | Kia Spectra Cars & Trucks

2 Answers

Blown headlight bulb


check if you have a loose ground wire thats short circuit your light bulb
or any wires thats touching metal

Mar 23, 2013 | 1992 Chevrolet K1500

1 Answer

My head light on my 1998 Chevy malibu went out but when I replace the bulb it still wont work


When you replaced bulb,all wiring and bulb connector looked good,no corrusion,wires not burned or strayed.With dim lights,means just a little power going to light bulb.Did you check the fuse in fuse box,could be a loose connectoion,check both fuses,left and right headlight.swap them out and see,if fuses are good then,it may be the headlight switch,which cost the most.Here's a link on how to replace.Here's the part.

Dec 07, 2012 | 1998 Chevrolet Malibu

1 Answer

Driver headlight not working and changed the bulb


Check backshell of connector and make sure there is not corrosion inside of connector. Wire could also be broke. Right and left headlights are on same fuse and run through same wire. I would suspect no current to connector.

Dec 02, 2011 | 1999 Chrysler Concorde

1 Answer

Have 96 ford explorer Eddie Bauer. Passenger headlight is not working. Replaced bulb and still doesn't work. When I turn on bright lights it does light up but not when its the regular light.


Sounds like a bad connection in the head light wiring. Check for a poor/loose Earth wire bolt inside the engine bay near the head lights. Also check any of the plastic block connectors in the wiring loom for the head lights and also where the connector plugs onto the rear of the headlight globe itself. Sometimes the metal spade connections are not secured properly within the plastic block and can be pushed back when the plastic blocks are joined together. Check the security of these connectors in the plastic blocks by gently pulling then pushing each wire in the connector block. There should be little or no movement. Any loose ones will be obvious if they pull out some distance. If there has been a bad connection in any of the plastic connection blocks there may be signs of the plastic having been melted by the heat produced by the bad connection.

Oct 25, 2010 | Ford Explorer Cars & Trucks

3 Answers

How do you remove the headlight assembly on a 05 Pontiac G6 GT to replace headlight bulb? When unlocking car, the bulb works, but when starting or putting car in drive light goes off. Is the bulb the...


real interesting... there should be no relation to the "drive" and the head light. current drawn by the starter causes the lights to go out or dim. Check the headlamp relay and for corrosion on connector to lamp assemblies in the engine compartment. On back of assemblies there is a large diameter plastic retainer after you remove the wire clip. Turn counter clockwise and pull back. a wire clip should retain the bulb itself

Oct 02, 2010 | 2005 Pontiac G6

1 Answer

On a 2005 Jeep Liberty, the passenger headlight went dim. I replaced the bulb but no improvement. I switched the bulb with the driver side, and still no improvement. No the passenger light is out. The...


there is a ground wire for both sides. follow the wire from the connector to body and clean, Test the 12 volt wire to make sure it has 12 volts. If not bad switch or bad wire or contact in the connector. Wiggle the connector first with the lights on to see if it changes.

Nov 24, 2009 | 2005 Jeep Liberty

1 Answer

Passenger Headlight keeps going out. While


sounds like the head light switch may be defective.

Aug 14, 2009 | 1987 Nissan Pickup

1 Answer

Headlight wont work, doesn't seem to be the bulb


no it will not
it sounds like the bulb is bad
clean the corrosion with a small wire brush
and try a new bulb

Apr 13, 2009 | Honda Civic Cars & Trucks

3 Answers

CHANGE HEAD LIGHT


you change the bulb from inside the engine compartment . raise the hood and feel for a plastic retaining ring in the back of the headlite. Loosen 1/4 turn and bulb socket and old bulb will pull out from the headlite assembly Unplug the old bulb and replace with new one . assemble in reverse order.

Nov 02, 2008 | 2004 Mitsubishi Endeavor

Not finding what you are looking for?
1995 Ford Escort Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...