Question about 1995 Mitsubishi Eclipse

1 Answer

Where is the starter location on a 95 eclipse gst turbo

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 347 Answers

Beside the flywheel of the engine. follow +wire from the battery this will point to the starter solenoid

Posted on Oct 02, 2009

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
dustyboner
  • 338 Answers

SOURCE: 95 eclipse MAF bypass?

if you want to get rid of your MAF sensor, you will need to upgrade your engine management. there are a few piggy-back systems like MAP-ECU . you could also go with a stand-alone system like the AEM EMS

Posted on Nov 06, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

TIMING BELT SCHEMATIC ON A 1999 MITSUBIHI ECLIPSE 2.0


Since you didn't specify if you had the turbo or non-turbo engine, i'll give you links to both.
2.0L non-turbo (420a) RS/GS
2.0L turbo (4g63) GST/GSX

Sep 04, 2010 | 1999 Mitsubishi Eclipse

1 Answer

I cant find where the egr solenoid plugs in 95 mitsubishi eclipse gst trubo


egr transducer solenoid,,located at underhood, beside a/c idle up solenoid control, take alook at the vaccum hose at egr valve, its goes through the egr solenoid treansducer valve, picture later

Jun 25, 2010 | 1995 Mitsubishi Eclipse

2 Answers

How install the timming belt in my mitsubishi eclipse gst turbo 98


this link has a step-by-step DIY for changing the timing belt on your car. 2G TURBO TIMING BELT PROCEDURE

Jun 20, 2010 | 1998 Mitsubishi Eclipse

2 Answers

95 gst leaking antifreeze from line to turbo . Car was overheating and antifreeze was spraying out but stopped and temp went back down


are u getting steam from your exhaust system if so you could have a blown gasket or cracked head on the exhaust side ive just had the same problem

Mar 06, 2010 | 1999 Mitsubishi Eclipse

1 Answer

ON MY 97 ECLIPSE GST WON'T


Is there oil in the turbo?

Feb 26, 2010 | 1997 Mitsubishi Eclipse

3 Answers

Where do I connect a code reader to a 95 eclipse gst


Look under the dash on the drivers side. There should be a port. Some have a plastic or rubber cover on them to keep them clean. It will be the same size as the end of the plug on the reader.

Feb 25, 2010 | 1995 Mitsubishi Eclipse

1 Answer

Change the engine computer


before i start to explain how to replace this i cant stress this enough MAKE SURE THAT IS THE RIGHT COMPUTER FOR THAT ECLIPSE. the 95 non turbo eclipse has a different computer from the 96 to 99. and the gst and the gsx computers are different from eachother. the gst and the gsx computers are also different from the 95 and the 96-99 non turbo eclipses. when you get the computer i would bring your vin number to any local parts store or the dealer and they should know what to do with it. now that that is said. which computer do you need replaced. if your talking about the one inside the car it is located under the center console right behind the e-brake. removing that can be a challenge due to the several bolts that holds it on. you can use a phillips head screw driver but i wouldnt recommend it. i believe it is a 10mm socket that they will fix. after you get that off i would disconnect your battery. wait a few minutes than ground yourself out to the bracket holding the shift bar on(just grab ahold of it) after that is said and done there should be 4 bolts holding it on. (i believe 10mm cant remember) and a clip with several wires going to it. before installing. clean up the area around where the computer sat. remove any dirt or anything that may be there. check the clip that plugs into it for any damage, broken or burn wires, or if the plastic clip in itself is damaged. if not the dealer would be the only place to replace this at and i would strongly recommend a garage putting it in. if all is good installation is the opposite of removal. after you get everything together turn the car to the on possition with out starting the motor and let it sit for about 10 min. this will allow that computer to learn the way your car is set up. after that you should be able to start the motor with out a problem.
if you want the computer under the hood than its simple disconnect 1 or 2 clips and 3 to 4 bolts holding it on. inspect everything before installing the new computer along with cleaning up and dirt or rust in the area. and do the same process i explained about the other computer

Oct 05, 2009 | 1998 Mitsubishi Eclipse

1 Answer

Motor swap


If your planing on swaping the 2.0 non-turbo(420a) to the 2.0 turbo(4g63t) your problem will be that the motor and transmission are on opposite side of one another. My GST has the trans on the passenger side and the motor on the driver. The 420a is just the opposite. If your serious about it you should get the motor rebuilt with higher performance crank, pistons, rods, exc.  And they make turbo kits for the 420a.  But you'll need better fuel delivery and some mild tuning.

Dec 23, 2008 | 1997 Mitsubishi Eclipse

1 Answer

95 eclipse MAF bypass?


if you want to get rid of your MAF sensor, you will need to upgrade your engine management. there are a few piggy-back systems like MAP-ECU . you could also go with a stand-alone system like the AEM EMS

Nov 03, 2008 | 1996 Mitsubishi Eclipse

Not finding what you are looking for?
1995 Mitsubishi Eclipse Logo

Related Topics:

468 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8725 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...