Question about 2001 Chrysler Town & Country

1 Answer

The horn only works sometimes if i wiggle the fuse center it will work

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

For 19.99

Posted on Oct 03, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My horn does not work which breaker is it e350 1998 5.7 litter triton


Fuse # 27 15 amp. under hood fuse box. If the fuse isn't blown check the horn relay , located in the same under hood fuse box . Relay is J center top . Do you know what a relay is and how it works ?
VEHICLE RELAYS Operation Diagnosis

Aug 16, 2017 | Cars & Trucks

1 Answer

Horn wont work 95 Land Rover Discovery, Please help!


1 Check fuse.
2 Check connectors at the horn. Wiggle them to try and get it working.
3. Using a multimeter, check for 12V at the horn terminals when the horn button is pressed. If yes, then use a flat screwdriver to adjust the screw on the front of the horn. If no go, then you need a new horn. If you don't get 12V at the horn terminals, check the button contacts.

Sep 05, 2013 | 1995 Land Rover Discovery

1 Answer

My 1995 toyota camry horn works sometimes


Most horn sytems on vehicles have power to the horn, and the horn
button simply completes the circuit to earth.
Check to make sure the earth lead bolted to the front panel is clean and tight, check also that there isn't a horn relay under the fuse box cover, it may be faulty.
You will need to make sure that at least one of the wires to the horn has 12 volts going to it, if not, the fuse may have blown.
Hope this helps.

Jun 08, 2012 | 2005 Toyota Camry LE

2 Answers

My 1990 honda civic horn does not work


Check the fuse and connectors.

Apr 03, 2010 | 1990 Honda Civic

2 Answers

I have a 89 golf, horn doesn't work but it makes a clicking noise when the horn button is pushed any ideas to get it to work?


Your horn buzzer is either broken, or it is not getting power. The click you hear is the horn relay. It is good that you can hear it.

To diagnose the problem, locate the horn module. It should be behind the grill in the front of the car. Remove the power wire. Get an assistant to press the horn button while you measure voltage in the connector. If you have voltage, replace the horn. If not, find out why there is no voltage. It could be a blown horn fuse or a broken wire. Good luck.

Feb 23, 2010 | Volkswagen Golf Cars & Trucks

1 Answer

2005 sebring convertible- horn goes off by itself for 30 seconds


FIrst off the horn's ground works through the steering wheel,so the wire is bare or the end is broken and grounding in a place where it should not. You will have to check the wires for the horn from the fuse box up to the wheel.
your power feed to the headlights and the door locks has an open ( the power is not connected somewhere ) Perform a wiggle test turn on the headlights and lift the hood,find the power distribution box and begin to wiggle the wire harness.Sometimes the chrysler fuse box under the hood get loose inside the power distribution box,it will have to be broken down all the way to the heavy wires comming out of hte box,you can tighten these connections your self.

Aug 08, 2009 | 2006 Chrysler Sebring

2 Answers

2005 Jeep Liberty Horn wont shut off


wiggle the horn on the colum if it stops then the spring on the horn pad has gone bad

Aug 08, 2009 | 2005 Jeep Liberty

1 Answer

Heater fan quit working


Horn fuse should be labeled on the fuse block. If it's not, easiest way to check is to just check them all. Use a test light and probe the back side of each fuse on both ends, till you find one that only has power on one side. Horn works with key off but I generally check with key on. Also, you have a horn relay (should be in the power distribution center (basically another larger fuse box, usually on the right fender under the hood. If all else fails, run a "hot" wire right to the horn & make sure it works. Horn "switch" is actualliy part of the signal mechanism and internal parts within the steering column...though these sometimes develop dead spots, it's least likely that it is the source of your problem.

Jan 27, 2009 | 1997 Jeep Grand Cherokee

Not finding what you are looking for?
2001 Chrysler Town & Country Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...