Question about 2004 Pontiac Montana

1 Answer

Location of parts for 2004 montana

Ok where do i find the switch and motor relay for power sliding door on 2004 montana

Posted by on

  • Anonymous Mar 27, 2014

    switch is working but motor is not getting power. cant find the control board for motor



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.


    An expert that has over 500 points.

  • Expert
  • 144 Answers

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Can't find switch for rear windows on 2004 pontiac montana

Owner's Manual page 2-26 :

This switch, located in the overhead console switchbank, is used for opening and closing the power rear quarter windows. Press the textured part of the switch to open the windows; both windows will open. The windows will continue to open as long as the switch is pressed, until they are fully opened. Press the part of the switch with the symbol to close both windows. The windows can be closed fully or partially, depending on how long the switch is pressed.

Apr 17, 2015 | 2004 Pontiac Montana

1 Answer

2004 lincoln navigator ,doors will not open rear hatch will not unlock

The door locks are controlled by the vehicle security module (VSM). It gets power from fuses 30, 5, 6, and 40 in the central junction box (CJB). You say you checked these and all are OK. Therefore the problem must be in the door lock actuators, the door lock relays, or the door lock switches. I doubt that all of these are defective, so the VSM may be defective.

The liftgate is controlled by the power liftgate module (PLM), althogh the motor in the liftgate glass actuator is controlled by the VSM. The PLM gets power from fuses 105 and 5 in the CJB. If the PLM is assumed to be OK, the source of the problem could be the liftgate unlatch motor, the liftgate cinching motor, the L/R liftgate obstacle detection strips, the liftgate home position switch, the liftgate fork bolt/detent switch. or the power liftgate open/close switch

Sep 28, 2012 | 2004 Lincoln Navigator 4x4

1 Answer

Changing the window motor driver side


To change the window motor driver side, follow the steps below:
  1. remove 1 visible bolt left side of arm rest
  2. Pop out window switch/door lock/ mirror adjustment control panel with a screwdriver
  3. Use panel remover or just pull on interior panel to remove must slide it off of door handle
  4. Slide control switch panel down through hole you popped it out of
  5. Pull vapor barrier loose bottom right side to expose coiled spring and window motor
  6. Tape window in the up position using masking or package tape
  7. Mark a straight line across coil spring to make sure you can realign it when reinstall
  8. Use tool j-38864 connect it near outer part of coil sprint where it hooks to retainer or in a pinch use pointed vice grips at same location ensuring they are firmly locked on spring ( be very careful, I'm not responsible for any injury if you are not)
  9. Force spring clockwise to disengage it from it's retainer point
  10. Pull spring slightly outward just enough to clear the retainer point and slowly let it uncoil counterclockwise and let it sit there
  11. Disconnect wire connector from right end of window motor
  12. Use your hands and push 3 plastic retainer points outward as you lift up on window motor to disengage from retainers careful not to break the plastic retainers comes out pretty easy
  13. Install new motor into the plastic retainers, make sure filly seated ( lining up plastic Guides into holes in motor (3 points)
  14. Reconnect wire connector to new motor
  15. Use J38864 or vice grips to recoil spring, resit it to retainer point as before you have to be very careful in order not to hurt yourself
  16. Remove tape from window and test up/down switch ( key must be on)
  17. Reseal vapor barrier in place as it was prior to starting
  18. Slide switch control back up through hole in door panel from where it mounts
  19. Slide door over door handle
  20. Align retaining clips to holes and push them home with gentle raps of your hand start at the top and work downward on panel
  21. Replace both bolts in arm rest
  22. Pop window/door lock control panel back in place
That is how to change the window motor of the drivers side of a 2000 pontiac montana.

Take care and good luck

Jan 06, 2011 | 2000 Pontiac Montana

1 Answer

2002 pontiac montana passanger pwr window

I beleive you need to change the Power Window Switches Module in the drivers side door panel, as these connections are interlinked within this module and it is usually the first part that fails. Especially that you already changed the switches & motor in the passenger door and it still does not work. Once you remove the dual switch module in the driver's side door, you will understand what I mean. Plus it is really easy to access. Good luck! I have the same model, Claude

Feb 19, 2010 | 2002 Pontiac Montana

1 Answer

04 pontiac montana sliding doors no longer work

the sliding doors on montana assuming there power have a electrical harness on the bottom track that break and jam the doors but unlikly both have this problem do the doors lock @ unlock if not check switch at drivers door

May 27, 2009 | 2003 Pontiac Montana

2 Answers

I have a 2004 Pontiac Montana - last night I put down the passenger power window and now it will not roll back up - the driver's works so it's not the fuse.

It may be the motor, some times if you have the door open with the key on and hit with your fist the lower towards the front of the inside of the door panel it will jar the motor enough to allow it to go up. (hold the swith in the up position while you do this)

Feb 21, 2009 | 2004 Pontiac Montana

1 Answer

My 1999 pontiac montana rear sliding power door will not work

I went to and looked up the wiring diagram for this vehcle. However, prior to checking this part, I would check to see if you have a blown fuse. It doesn't hurt and only takes a few minutes. There should be a fuse for that either somewhere on the side of the dash or near the brake pedal area. If not it may be under the hood, but it should be inside the vehicle. You may have multiple fuse boxes. If it has (2) sliding doors it will have a wire for the auto doors in each kick panel (under the plastic trim/molding) when you open the door and look down you will see all of the trim/molding it should snap out or may be held in place with a screw or (2). Once you remove that you should see the wires. It says for the left side it is either light blue or black and the right side is definitely light blue. Trace this wire until you find out where it ends (the motor or switch to control the auto doors) Then test the switch/motor to see if it is bad.

Jan 26, 2009 | 1999 Pontiac Montana

1 Answer

2004 Toyota Sienna LE sliding door failed after battery jumpstart

could very well be the relay for the power door and possibly the interior light relay... they are located in the fuse panel under the dash.


Jan 23, 2009 | 2004 Toyota Sienna

Not finding what you are looking for?
2004 Pontiac Montana Logo

Related Topics:

261 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides