Question about 1993 Cadillac DeVille

1 Answer

I took my cat to the shop and they said my transmssion is fine but I am getting any power to it ( electrical). Is threr a fuse or relay I need to replace. If so? Where is it.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 11,896 Answers

There is no fuse or relay for a tranny There is a sensor that attaches to the ecm and control module.

Posted on Oct 01, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

AC not working

Apparently the local shop did not trace the clutch wiring back to the power source to find out why no voltage was getting through.

Aug 11, 2017 | Lincoln LS Cars & Trucks

1 Answer

1995 GMC Sierra fan blower not working.

In the beginning you should check for voltage and ground.
The 50amp fuse marked AC powers the blower motor and the motor is grounded.
The high speed relay bypasses the resistor. So you should have power coming from the fuse and thru the high relay. Then the resistor for the other speeds gets power from the heat and ac control module which also controls the blend doors.
You may need a shop manual or repair book to get the diagrams.

Jan 12, 2013 | 1995 GMC Sierra C1500

1 Answer

My 1999 Chrysler 300m has had two starter fires. Replaced starter twice in 6 months help!

Yes sir. The ignition switch/relay is not releasing the "start" connection when key is released after starting thereby solenoid remains on with stater running. If threr is a relay check and replace if necessary. If it's got no relay replace ignition switch.

Dec 14, 2012 | Chrysler 300M Cars & Trucks

1 Answer

Blower motor not working. took out blower and tested out good. are there relays or fuses that could be bad?

Yes, a fuse or relay could be bad, but the hard part is finding it. Maybe try an auto electric shop to determine where the relay is from a schematic.

Jan 02, 2011 | 2000 Ford Escort

1 Answer

My blower for the heat worked fine i took it to a shop to get the alternator replaced an when they were done i had no blower for the heat what can be the problem

Hmm ... Open your user manual, and look for a relay and a fuse on the fuse panel for the blower. Check the fuse, and if you have an extra, replace the relay. If that's not it, you might have to run through the wires to the fan.

Dec 19, 2010 | 1996 Ford Taurus

1 Answer

Is threr a fuel line reset button on a '95 CHEROKEE WRANGLER.? The fuel pump will not kick in.

There is no "re-set" on that system. power comes from the fuel pump relay in the power distribution center and that relay is also fed by the auto shutdown relay in the same location. At the point you are at, you need to check those,as well as fuses and power at the pump harness to begin narrowing down the problem. Hopefully it will turn out to be something simple. If not I do suggest you get a decent manual (chiltons is pretty good on wiring diagrams).
If you need help with anything specific that you find, just ask and I'll try to help.

Sep 19, 2010 | 1995 Jeep Cherokee

3 Answers

99 volkswagen beetle 2.0 engine problem

Cat is usually damaged from vehicle misfiring, Those codes you posted are a MAF, idle control, and 02 sensor codes. The MAF sensor could be reading incorectly causing the car to run rich or lean, and giving the 02 sensors bad readings, i would deffinetly look into the MASS Air Flow sensor, which is located on the intake tuping near the airbox

You can also try cleaning it with MAF sensor cleaner

Apr 06, 2010 | 2000 Volkswagen Beetle

1 Answer

Electrical problem 1992 dodge 250 van

yes there is a horn and buzzer relay under the hood

Aug 21, 2009 | 1992 Dodge Ram 250

3 Answers

Replacing a starter and starter relay on a 1994 Nissan Pathfinder

Starter relay is located in a "fuse box" these rearly go out. Check your starter to make sure you are getting power to it when you turn your key. if so then worry about the relay or the Starter Solenoid.

Jul 18, 2008 | 1996 Nissan Altima

Not finding what you are looking for?
1993 Cadillac DeVille Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts


Level 3 Expert

79024 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides