Question about 1991 Jeep Wrangler

2 Answers

Gas gage always reads full untill i turn off car

I have a 1991 jeep wrangler yj turn key on gas goes to full and stays there untill i turn car off

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 114 Answers

Most common problem is the fuel module(fuel sender) which is located in the gas tank. Have a tech check it first cause it's about $500 -$700

Posted on Sep 30, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 691 Answers

The fuel sending unit is probably stuck and need to replacing. common problems to many older vehicle it tend to read sometime correctly and sometime not at all. the sending unit will be in your gas tank.

Posted on Sep 30, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Free belt diagrams


http://serpentinebelthq.com/1991-jeep-wrangler-yj-4-0l-serpentine-belt-diagram/ her is a link for you to a diagram. I hope this helps

Jul 08, 2014 | 1991 Jeep Wrangler

1 Answer

1987 jeep shuts down when switching gears or off gas pedal


wrangler? YJ? 4WD"?
what engine, what fueling system. Carb. or EFI?
2.5 L AMC 150 I4 Complete engine specs[show] 4.0 L AMC 242 I6 Complete engine specs[4][show] 4.2 L AMC 258 I6 Complete engine specs some 87s have a carb. does yours, (nobody can fix enigine not kwowing both facts above and what transmission,.


stalls , moving, only. at stop lights or between gears.
but never just parked idling.
if its random , that would be the EGR valve sticking open.
if EFI , bad idle switch.
if Carb bad dash pot. on carb.

Jan 10, 2014 | 1987 Jeep Wrangler

1 Answer

Oil pressure gage is dropping when engine get on 95 yj 2.5


this is normal as the oil thins out when it gets hot.provided its not dropping below about 2bar or 28psi when on tick over.then you could be in trouble

Apr 06, 2010 | 1995 Jeep Wrangler

1 Answer

1995 Jeep YJ with a new engine. No power going to coils.


sounds like you are working on a car FSM free?
why do that?
95 YJ
early wrangler
i have 95 yj fsm and 93, the 93-95 are a year class range.
very simular.
here is a free 93 fsm with full schematics in chapter 8w
wiring chapter, clik
pdf 76 is page YJ 19 actual
and as you can see its cave man simple 2 wires.
minus to ECU ignitor driver. transistor (inside ecu)
and
+ goes to
a142 sheet 5 (pdf 62)

im not sure what part A<B<C is, a fuseable link, is my guess
and is blown. but that be a bingo spot for sure.
the full manual is there.
see spark chapter.
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

posted over 100 times, this link, its not new.

Feb 13, 2010 | 1995 Jeep Wrangler

1 Answer

Gas gauge always shows above full with key on . key off goes to empty.


there is a short in the wire going from the gauge to the tank. ck the wiring under the truck from the tank going forward, and ck if anything looks like its rubbing on the wiring harness.

Sep 23, 2009 | 1991 Jeep Wrangler

1 Answer

How do i clear the stored codes on my 91 Jeep YJ with 4.0


A few ways 1. unhook battery for a bit then reconnect. 2. turn key on and off three times, on third time leave on and wait for codes to finish flashing on dash 3. last but not least, and probably most effective, go down to local parts store and borrow code reader that you will also be able to clear codes with. And as always, if they come back on , it aint' fixed yet.

Sep 12, 2009 | 1991 Jeep Wrangler

1 Answer

Check Gages light comes when driving


sounds like you have a possiable alternator issue or a loose or corroded battery cable, have that checked.

Aug 08, 2009 | 1998 Jeep Wrangler

3 Answers

Looking for Service Repair Manual Jeep Wrangler YJ


i have a 1988 jeep wrangler 6cyl with 5 speed transmission. I was shifting the jeep and it got stuck in third gear. We opened it up and saw that the linkage is aligned and everything is in place. I dont know what is wrong and what to do next. please help ....

Jul 10, 2009 | 1992 Jeep Wrangler

1 Answer

95 jeep yj wont start


have you checked the fuel pump ? the fuel pump is in the fuel tank and it may be that the fuel guage inside the tank is broken and or not attached to the pump. This is a big job but with a little help from buddys and a bit patients it can be repaired.

Jan 31, 2009 | 1995 Jeep Wrangler

1 Answer

1991 Jeep Wrangler


Test....Test reply. Sorry for any inconvenience. Your question is still active.

Jun 16, 2008 | 1991 Jeep Wrangler

Not finding what you are looking for?
1991 Jeep Wrangler Logo

Related Topics:

239 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...