Question about 2003 Hyundai Tiburon

2 Answers

How to change a brake light on a 2003 tiberon

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

In the trunk there are two panels that are located right behind each light you remove the panel by unscrewing the three butterfly screws that hold each one on.

Next there are three bolts i believe 7mm or 8mm not sure that hold the light assembly to the body these need to come off but be careful because the bolts are hard to find when they fall down behind the molding.

Unplug the harness and push the rubber grommet through the hole so the tail light can be separated from the car

replacing the bulb at that point is pretty straight forward

just repeat the steps when the lights back on but test the lights before bolting them back in save yourself a headache

Posted on Oct 01, 2009

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Replace the bulb ?

Posted on Sep 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Brake lights don't work on a 2003 CAMRY LE


try changing the brake switch in the floor behind brake pedal.... pedal activates in when used, sending power to brake lights

Nov 30, 2012 | 2003 Toyota Camry

1 Answer

Vacuum diagram for a 2004 tiburon


There is only 4 vacuum lines on that engine

1- brake booster line

2- purge line to purge solenoid (top center of throttle body)

3- PCV hose. run straight from PCV to side of intake at base of throttle body

4- fuel pressure regulator line (short small diameter hose runs from #6 intake runner to fuel pressure regulator

5- tube that connects front cam cover to rear cam cover to improve vapor venting

http://www.hyundai-forums.com/attachments/gk-tiburon-coupe-s111-2003-2008/38204d1276396353-vacuum-lines-2004-tiberon-pict0001.jpg

Jun 25, 2012 | Hyundai Tiburon Cars & Trucks

1 Answer

How to replace headlight bulb inn 2003 tiberon


Low beams are easiest to reach. Open the hood, find the locking cap behind the light housing and turn it a half turn to remove. Unplug the bulb. Disengage the spring lock holding the bulb in place and remove the bulb (be sure you don't touch the glass).

The bulb base has three small flanges that seat right into corresponding slots in the bulb housing. Seat the new bulb using these flanges, lock the bulb into place with the spring lock and replace the locking cap.

The high beams are harder to get to. You might need to pull the battery on the driver's side. The windshield washer tank on the passenger side might also give you some problems. Once you have room to maneuver, the procedure for changing the bulbs is exactly the same as for the low beams (they even use the same bulbs: H7).

Oct 04, 2010 | 2003 Hyundai Tiburon

1 Answer

My 2003 hyundai tiberon airbag light is on. There seems to be no reason for this. Any suggestions on how to get it off without getting a diagnostic test ran on it?


unfortunately you need to take it in for service. Only a shop has a scanner to test air bag module and find out what may be wrong. This is a safety thing that you should not ignore.

Aug 20, 2010 | 2003 Hyundai Tiburon

1 Answer

I have a 2003 Hyundai tiberon SE. Recently the


the bulb is not working because the fuse is probably dead. (check by the drivers leg side for the fuse box). Door locks will not work because the alarm system needs to be repaired, or replaced. I donot know what to do with the cruise control. and your seatbelt sensors need to be replaced.

Nov 18, 2009 | 2003 Hyundai Tiburon

1 Answer

Location of the Purge Control Valve for 2003 Hyundai Tiburon


There were two different engines which were installed in the 2003 Tiberon... the 2.0 liter 4 cylinder:
22c99c7.jpg

And the 2.7 Liter V6:
cb31feb.jpg

Jun 06, 2009 | 2003 Hyundai Tiburon

1 Answer

2003 Hyundai Tiburon Gt rear brakes


hi not conversant with the tiberon in uk but will try to help ? if you remove the rear wheel then look at the brake disc (rotor) most hyundai rear discs on uk models are secured to the rear hub by 2x screws posidrive or tork heads ? if this is so on yours then no problem you will have to remove the caliper first from the carrier 2xbolts h/brake off then undo 2xbolts securing caliper carrier tosuspension stub assy your disc /s are most probably vented discs? or may be standard discs? remove the screws then you may have to hit disc from behind with hammer to jolt free as they are sometimes rusted on due to high temps and rain ideal conditions to create rust as you prob know? re assemble is reverse hope this helps ?

Oct 20, 2008 | 2003 Hyundai Tiburon

Not finding what you are looking for?
2003 Hyundai Tiburon Logo

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...