Question about 2003 Oldsmobile Alero

1 Answer

Clutch went out and it will not shift.How much should it cost for replacement?

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 4 Answers

Depending on the damage to the transmission will determine the price. To have it rebuilt the low end will be about $800 and go up again based on serverity of damge.

Posted on Sep 30, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Clutch cable replacement

check the ratchet under the dash, you might not need a cable

Sep 01, 2013 | Ford Mustang Cars & Trucks

1 Answer

1990 camry shifting cable went out

your clutch has went out or the slave cylinder to clutch or clutch master cylinder ck master for fluid if low fill and work clutch peddle to pump up slave cylinder if master is full ck at trans to see if slave cylinder is moving if moving clutch in most likely bad and needs replaced.

Jul 15, 2012 | 1990 Toyota Camry

1 Answer

I have Palio which is 3 yrs old.. my clutch is not working suddenly .. what should be the problem ? how much will be the cost of repair ?

Dear Sir,
As you said your clutch is not working , their two types of problem with clutch . one is when you press the clutch and shift the gear if gear shifting is proper but car not moving forward then it is problem with clutch plate assay, and if gear shifting is hard and not able to shift gear then it can be pressure plate or clutch fluid line . if 1st option is same for your problem then it will cost 100to 150$ or it is 2nd option then it will cost 50to 60$. if any issue please let me know thanks.

Jan 18, 2011 | 2006 Fiat 124

1 Answer

My clutch went right to the floor a couple days ago in my '94 Isuzu Rodeo. Now, I am having a hard time getting into reverse and shifting, but I am not having any issues with RPMs or anything like that. Is...

If you can get the transmission down you can replace the clutch assembly on your own. I assume you have original clutch installed in the vehicle. This sounds like a clutch problem and if you have a Hydraulic Clutch assembly it could just need service. You could get a Haynes Repair manual on the vehicle from Auto Zone or most major Auto Repair stores and that would give you the steps involved in doing the repair. Other than getting the Transmission down it's not really that difficult of a job.

Sep 20, 2010 | 1995 Isuzu Rodeo

1 Answer

Yesterday I went on about 10 different errands in my 2004 Saturn Vue (6cyl). As I was to go on another errand my clutch pedal when pushed went effortlessly all the way down and when released did the same...

This is Indicative of A Clutch RELEASE BEARING FAILURE and Requires A Complete Clutch Replacment, As the Transmission Must Be Removed and With ALL the Labor Cost Involved It IS WISE to Replace ALL PARTS Related to the CLUTCH ASSEMBLY, The Disc Is SURELY Sacherated With FLUID Rendering it UNUSABLE. This IS a 99.9% SURE Answer and Solution to your Problem, I Couldnt Catch you Initialy But I Enjoy Helping So $ is No Factor for Me Unless YOU DEEM Nessesary.

Jun 27, 2010 | 2004 Saturn VUE

1 Answer

Sudden clutch failure

Sounds like you have a leak .... a bad master/ slave cylinder .... that car has a hydraulic clutch system you may see oil dripping, much cheaper than a new clutch ... pumping it may help shift until it empties out entirely ... check the reservoir ...

May 09, 2009 | 2000 Nissan Maxima

2 Answers

1987 Suzuki Samurai Clutch problem.

Adjusted Clutch cable assembly under passenger side of vehicle. Had assistance from friend depressing clutch pedal and engaging shift lever. Problem went away

Mar 18, 2009 | 1987 Suzuki Samurai

3 Answers

1996 MX-6 V6 5 Speed: Clutch suddenly goes to the floor but....

It sounds like a fault with the clutch master cylinder or possibly the slave cylinder at the gearbox. With the age of the vehicle and the cost of the parts I'd recommend replacing both. This may not be something you want to tackle yourself, groveling around under the dash removing bolts for the master cylinder is not much fun, and clutch systems can be difficult to bleed up when they get air in them. I'd recommend taking it to a brake specialist (they do clutch work as well) and getting an estimate on costs before going ahead. Get a few estimates from a few garages to ensure that you are getting a good deal.

Hope this helps.

Oct 25, 2008 | 1997 Mazda MX-6

Not finding what you are looking for?
2003 Oldsmobile Alero Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts


Level 3 Expert

79077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides