Question about 1990 Nissan 300ZX

1 Answer

I have a a class clutchless auto it will not go into gear but if i jack the front off the ground it goes into all gears perfectly. any ideas thanks

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 16 Answers

When the clutch was installed did you use a clutch alignment tool. is the trans and clutch torqued properly. is the shifter support bracket in place and torqued properly......here is a write up that i followed when i replaced my clutch/flywheel/trans last year....hope this helps

http://www.ttzd.com/tech/clutch/clutch.html

Posted on Aug 10, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My SV6 VE 6 speed auto commodore holds 3rd gear longer than other gears peak traffic - any advice greatly accepted. At the front of the queue - the gearbox changes through all gears perfect - thanks


I would try servicing the transmission, that means a new fluid filter and a fluid drain and refill, it may help. You may have a sticking pressure check valve.

Feb 09, 2017 | Cars & Trucks

1 Answer

I have a 2007 Cyclone 3795, I have had issues with the front jacks since day one. While unit was still under warranty the motor burned up and gears stripped. The dealer replaced front landing gear.


thats a big RV

motorized jacks burning out and gears stripping ?
i would look at upgrading
to larger kg capacity lift motor jacking system

front and back


does loaded "mean still hooked up to the tow vehicle
Jacks will not raise trailer when loaded"



26348636-g30ioc3djl54xt4sh5ag1odt-1-0.jpg

Nov 10, 2016 | Cars & Trucks

1 Answer

Accerleration sluggish


Try cleaning the fuel injection system with seafoam and replacing the fuel filter. Look up seafoam on youtube. BTW really really really really bad idea running a vehicle on jack in gear.

Jun 27, 2013 | Chrysler Town & Country Cars & Trucks

2 Answers

There is a serious howl in the front end,i have tryed to go to 4hi and nothing happens,is this a front tramission problem or a bearing.


let's see, firing up my long distance vision..........its...its...darn blocked by a piece of lead. J/K. What you can do is jack up your truck on four jack stands, make sure NOTHING is touching the ground. start it up, put it in gear, and get out and look for the noise location. if noise near front wheels,its bearings, if near middle of front axle, its gears.., if near or under seats, its trans.

Jun 21, 2010 | 1998 GMC Jimmy

1 Answer

Abs light is on my 2002 saturn vue...scanner showed it has something to do with the right front braking system...any idea what it could be?


the sensors for the ABS are on each wheel, it is a geared wheel which sends pulses to the computer from a magnetic coil in close proximity to the gear.....sometimes debris from the road or old brake lining foul up the gear...that causes the magnet to not put out any pulses. your computer then sends a signal indicating a fault because of no signal condition.....solution.....check and clean debris from ABS gear. if this fails....check for bad or corroded or broken wires from magnet to computer....I mean continuity......also bad grounds cause many different problems in autos...so it's also a good idea to check for bad grounds....good luck
silvio

Jul 05, 2009 | 2002 Saturn VUE

1 Answer

1996 Nissan Maxima no 2nd gear on auto transmission?


do not flush the trans, that will make it worse.
My friend you have no second gear, you need trans rebuilt.
If you flush it now you can cause more damage.

Feb 25, 2009 | 1996 Nissan Maxima

1 Answer

Mercedes c 180 elegance (1994) auto gear box fault


you need to change band clean valve body so box has to come out of the car

Nov 29, 2008 | 2000 Mercedes-Benz C-Class

1 Answer

Mercedes a class gearbox fault.no gears


Its a part inside the gearbox called the k1 clutch assembly, that has gone faulty. Unfortunately no quick fix.

Apr 30, 2017 | 2003 Mercedes-Benz C-Class

2 Answers

Mercedes a class gearbox fault.no gears


If you take it to mercedes they will charge £3500 and will replace the gearbox, Alternatively you can change the shifter valve £25, new sump and filter as they have changed, fit a magnet inside the gearbox as the early A didnt have one. Fresh oil and see how you get on, the control unit for the gearbox sits inside the gearbox £1000 roughly for a new one but it has to come from mercedes in germany where it is coded to your chassis number, 2nd control units are not an option!!!!!!!
jib
www.mercanic.co.uk

Oct 18, 2008 | 2003 Mercedes-Benz C-Class

1 Answer

Volvo v70 est auto 1999 2.4


thats an easy one mate. jack one side of the car up so one of the front driving wheels is off the ground. then run the engine in gear and your wheel which is lifted off the ground will turn. you can then check eachside individually. i thought your mechanic would know this, ask him why, or is it he just he wants to become rich with people like yourself who dont know these things? try finding either an honest mechanic or a one who knows more about cars !!!

Jun 16, 2008 | 1999 Volvo V70

Not finding what you are looking for?
1990 Nissan 300ZX Logo

Related Topics:

125 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...