Question about 2004 Infiniti G35 Sport Coupe

1 Answer

How much should it cost to install 2 parking lights on 2004 infiniti g35 4 door sedan

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 92 Answers

Most shops charge 0.1 labor hrs to R&R any bulb on a car. for 2 bulbs it would be 0.2 x their hourly labor rate (let's say an average is $75/hr), and add the cost of the bulbs. so it should cost about $15 for just the installation.

Posted on Sep 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Difference between Air fuel ration sensor to O2 sensor?


usually an O2 code is 3 digits and not this type of code. if it has an mass air flow sensor(MAF) it could be it. I would start with checking the MAF readings then the O2 readings. OBD 2 codes are emission regulated so no matter what car it is the codes represent the same problem.

Aug 04, 2015 | 2005 Infiniti G35

2 Answers

Two codes coming up on car even after fixing alot on car now need to figure out low cost ways to fix P0744 & P0722 code issues spent 1,800 on car & have spent 1,400 already in parts & labor.


you need a better mechanic that traces ALL of the possibilities of each code, not just read the code and trow in a part hoping that it's fixed ~ it can be wiring as well, not just plug in a new part as mentioned on the 2nd trouble code to the vehicle speed sensor

P0744 Torque Converter Clutch Circuit Intermittent


P0722 Output Speed Sensor No Signal

the first of the 2 looks to be more intensive to trace and find out the problem & the 0722 is the easier job for an intermediate mechanic to trace the wiring for continuity

Apr 20, 2015 | Cars & Trucks

1 Answer

Infiniti


Did you check the fuse to see if it blew? If it did check our wiring!

Aug 12, 2012 | 2007 Infiniti G35 Sedan Sport Sedan

1 Answer

I have a 2004 infiniti sedan g35... the pass side seat does not


i just fixed this problem - the switch is bad - take out the seat - 4 bolts on the bottom 4 corners and then remove the whole switch - either buy a new one around $200 or unsauter the switch and clean it but be careful as there are a lot of parts inside that can fall out. i cleaned mine and it works fine beats spending the money.

Apr 06, 2009 | 2004 Infiniti G35 Sport Coupe

1 Answer

Wet rear floorboard and vapor barrier question


The plastic barriers are absolutely essential to prevent water from draining onto the floor. In a 2004 Honda, they would be brittle/torn as a result of aging. The "professionals" who installed the remote start system (in the rear doors?) probably reduced the plastic to shreds and simply remove the remains.

Feb 28, 2017 | 2004 Honda Accord

2 Answers

2003 Infiniti G35 Starter location


Downloaded a PDF detailed service manual online. Gives you diagram and everything else you need.

Feb 16, 2009 | 2004 Infiniti G35 Sport Coupe

1 Answer

I have a infiniti G35 and the car alarm goes off for no reason


I have a 2004 Infiniti G-35 that the car alarm has started going off for no reason.....REPETITIVELY! HELP!!!!

Jan 26, 2009 | 2007 Infiniti G35 Sedan Sport Sedan

1 Answer

How do I change the bulb 2004 infiniti high mount bake light?


Unfortunately, these are not very simple. If you have a factory high mount brake light-meaning not one in a spoiler, you have to remove the rear seats, the rear parcel shelf and then the 3rd brake light. the 3rd brake light I believe is an LED setup which get replaced as an assembly which inserts into the housing. If you need further guidance let me know.

Thanks,

Brian

Dec 10, 2008 | 2005 Infiniti G35

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Infiniti Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14337 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...