Question about 1994 Chevrolet K2500

Open Question

1994 chevrolet cheynbne k2500 wont start... i was sitting in my garage for 6 months due to a faulty starter....today i bolted the new starter.....but i notoced that the battery was dead....so i bought a new battery....i put it on the truck.....and here i go.....just when i wanted to hear the engine cranking.......all i heard was a ticking sound.....very fast ticking sound.....and it wont start...... i need help........could it be the alternator.....or faulty wiring.?,,,,,, i will be taking it to a shop....but i need to know some so i dont get ripped off.... thanks.,,,

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 124 Answers

SOURCE: 1994 Chevrolet s-10 pickup won't start.

If the tach was dropping then the motor was dying not the accelerator. The accelerator cable is a cable so it can not have intermitent problems. There is nu under hood fuse panel or box. The only fuse box is on the drivers side od the dash and the relays are in the glove box behind an access panel and if they are not in the glove box they are hanging on the firewall or inner fender. I do not know what your problem is but i am hoping to clarify some of the previous discussion for you. Now some questions. Are the dash lights coming on when you turn on the key? What motor? If is a 4.3L is it a vortec or throttle body? Give me more info and i will see if i can help. Remember I am not with the vehicle so I do not know what it is doing so the more info the more answers.

Posted on Dec 19, 2008

Ad
  • 1 Answer

SOURCE: '96 Chevy Tahoe won't start

i had similar problem. hard to start in morning but once started, would start everytime until next morning. i changed fuel pump, filter, fuel pressure regulator, coil, cap, rotor, pickup coil, battery. i was finally told the '96 had a recall on the fuel injection assemby. i changed that out with the new mpf system and it solved the problem. runs like a striped ape. hope this helps.

james bentley

Posted on Apr 29, 2009

adve1958
  • 246 Answers

SOURCE: what size motor does my stock 1990 CHEVROLET K2500 have

if you want to be especific(after converting liters to cubic inches is about 5.7 liter equals how many cubic inches? 347.8 exact, nominal 350.

Posted on Sep 08, 2009

  • 1 Answer

SOURCE: 1999 chevy silverado 4.3 new

I just replaced the fuel pressure regulator and now I am hearing a vibrating noise from the fuel line under the truck. What do you think the problem is.

Posted on Jan 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Just got 1994 s-10 v-6 pu ran for two weeks.always had a ruff time to start replaced battery and cables along with fuel filter.now wont start and already drained 3 new battteries.


If your still having a hard time starting, then it's probably the starter. They can short out and will **** the life out of batteries.

Feb 10, 2011 | 1994 Chevrolet S-10

1 Answer

Engine cranks and is getting spark but wont start it kicked back hard enough to break a starter mounting bolt i replaced the crank sensor and starter maount bolt it cranks but still kicks back and will not...


The timing is out . you can check this by getting #1 to TDC, pull the cap off and see where the rotor is pointing. It should be pointing to the # 1 cylinder. Gas engine

Feb 08, 2011 | 1998 Chevrolet K2500

1 Answer

New battery, new alternator, new starter, still won't start, 1994 chevy cheyenne 5.57 v8 ck2500


Get a fuel pressure gauge and measure on the fuel supply line on the rear of the inlet manifold. In my experience you need close to 4Bar while cranking. Priming pressure should be about 4.4Bar. This test will eliminate a variety of possible problems. I need more history to be more specific.

Oct 09, 2010 | 1994 Chevrolet K2500

1 Answer

I need to replace a starter in a 1999 chevy k2500. It was replaced but the starter is faulty and doesn't work only worked for a little while. Is there a manual out there to show me how to remove the...


First thing disconnect the battery terminal.There is a postive wire that is attached to the starter that should be a 13 mm, and pull of the negitive connectio to the starter. There will be no more than two to three bolt to remove on the starter. Problem solved, in less then a half hour.

Oct 08, 2010 | 1995 Chevrolet K2500

1 Answer

94 chev k2500 revs up and then dies- has new throttle position sensor, new alternator, new starter


YOU MOST LIKELY HAVE A 5.7 LITER ENGINE WITH TBI.
THE FIRST THING TO CHECK IS FUEL PRESSURE. SOME OF THESE ENGINES HAVE FUEL PORTS ON THE LINES RIGHT BEHIND THE THROTLE BODY THAT YOU CAN HOOK UP A FUEL GAUGE TO AND CHECK PRESSURE. IF IT DOESN'T, HAVE SOMEBODY WITH THE RIGHT TOOLS CHECK THE PRESSURE. SOME OF THESE ENGINES START WITH AS LITTLE AS 9PSI, BUT WHEN YOU STEP ON THE GAS THE FUEL PUMP CAN ONLY DELIVER 9PSI AND IT STALLS
GOOD LUCK

Jun 08, 2010 | 1994 Chevrolet K2500

1 Answer

1999 blazer wont start??


Your battery is either faulty or ther is a parasitic drain, have it checked out at parts house. With a good battery installed, spray some starter fluid into intake housing. If it starts, then dies, you have fuel pressure/delivery problems. Can you hear the fuel pump run when you turn on the key? Hope this helps.

Dec 18, 2008 | 1999 Chevrolet Blazer

1 Answer

Won't start after sitting for 6-8 months


First,try to get engine to fire and eliminate the ignition as the problem.While cranking squirt start fluid into intake and see if engine trys to start if it does you will probably need to fix the fuel system as sitting for that long will ruin it due to stale fuel turning corrosive.Pump filter etc and injector cleaner to try to clear gummed up injectors.

Oct 23, 2008 | 1994 Nissan Sentra 4-Door

Not finding what you are looking for?
1994 Chevrolet K2500 Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...