Question about 2002 Chevrolet Silverado 2500HD

1 Answer

No power to roof clearance lights on chevy 2002 hd2500 crew cab diesel can't find which fuse and location also fog lights indicator switch does not light up

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 3,351 Answers

Int pak fuse--10 amp, left i/p fuse block. Not only check the fuse, check for voltage on fuse circuit, head lamp switch on. At the clearance lamps, brown wire is voltage, black is ground.

Posted on Mar 08, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: 7.3 diesel won't start, but turns over no problem. No fuel

this should not have a emergency shut off they are on gas engines not diesel engines 
if you have the electronic injectors it could be the shitch on the high pressuer oil pump is bad or other problems with high pressure oil system pump lack of oil in resovor ect  also check all fuses and relays under hood  these are not as user frendly as the older 7.3 s  were good luck

Posted on Mar 19, 2009

  • 1 Answer

SOURCE: bad sensor on chevy truck

There are 2 both located in the block..

Posted on Mar 20, 2009

jmgldsmth
  • 1869 Answers

SOURCE: Fuse panel diagram for 2003 - F250 Super Duty -

I beleive the diagram is on the inside of the plastic fuse cover, mine is.

Posted on Apr 21, 2009

  • 3600 Answers

SOURCE: how do i change my upper and lower ball joints

Jack up the car remove wheel remove brake caliper and remove rotor rent a ball joint press remover and installer tool (at schucks you get money back when you bring it back) if it's 4 wheel drive you will have to remove the axle shaft next pull the snap ring off on the top side and put tool on the lower tie rod end and press out, next do the top press out top joint next sand ball joint sockets so it is clean lube with WD-40 next press in top ball joint and then lower ball joint. In this order otherwise you will have to un install the top ball joint by removing the pin then nut.

Posted on Aug 19, 2009

  • 1 Answer

SOURCE: speedometer stopped working

Mine did the same thing the speedometer modal went bad. If It has less than 75,000 miles the dealer will replace it for free.

Posted on Nov 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What" the right clearance for td27 engine diesel


what are the valve clearences of a td 27 diesel engine

Feb 21, 2011 | 2007 Nissan Frontier SE Crew Cab

1 Answer

I need the wiring diagram for a 2006 ford f150 xlt super crew headlight in order to wire oem fog light harness to headlight harness to get my fog lights to work.


This is the diagram for the fog lamps ( headlamp is a different cell ).
If you are trying to add them to the existing wiring, do not expect the headlamp switch to cab fuse panel wiring to be there ( that is usually what is missing when you can find the fog lamp connectors under the front of the truck ).

File Save as so you can magnify it with the JPEG viewer you use.

sscullys_90.jpg

Close up of switch
sscullys_91.jpg

Jan 28, 2011 | 2006 Ford F-150

1 Answer

Does a 2000 f 250 have a connection for fog lights in the wiring harness if it did not come with fog lights


There may be a connection in the harness or a place to connect the cabling, but what you'll find out is that the light switch is different for the trucks that have fog lights from the factory. They have a pull-to-activate function for the fog lights and an indicator led on the switch that shows the fogs are illuminated.
I would suggest purchasing an aftermarket fog lamp kit with the entire package...switch, wires, relay etc..cheaper in the long run... not too hard to wire on these either...the toughest part is feeding a wire thru the firewall... but even that's not too difficult.
Hope this helps...

May 31, 2010 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

Can find location of the over drive diconnect fuse


under dash fuse box, middle row, 8th fuse down. That fuse is also for:
Auxiliary Powertrain Control Module
(APCM) (Diesel only), Instrument Cluster,
GEM Module, Overdrive Cancel Switch, Idle
Validation Switch (Diesel only), Overhead
Console, Diesel PCM via Clutch

Mar 10, 2010 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

2004 f350 4x4 6.0 diesel electrical problems


Locate the fuse box under the dash panel. Pull the fuses one at a time and inspect. They are very hard to judge if the fuse(s) are blown unless you pull them out to inspect.

Dec 08, 2009 | 2002 Ford Explorer

1 Answer

2004 Ford f-250 diesel. The hazard lights and turn indicator lights do not work. The fuse is good. The problem is not in the multifunction switch. I can not find a flasher relay.


Ford is notorius about the hazard switch going bad in the column. I have three trucks from 95 thru 02 that have the same problem. we just don't use the hazards and the turn signals work.

Oct 26, 2009 | 2003 Ford F250 Super Duty Crew Cab

1 Answer

2000 Chevy CK, have hazard lights, turn signals,


test your brake switch located on the brake fulcrum. you can unhook the wires and usea paper clip to connect the two wires together if the brake lights come on then replace the switch, if it does not come on and the bulbs are ok then replace turnsignal switch.

Jul 18, 2009 | 1999 Chevrolet 3500

Not finding what you are looking for?
Cars & Trucks Logo

294 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...