Question about 1994 Plymouth Acclaim

Open Question

How do you replace the right front signal bulb on a 94 Plymouth Acclaim?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

davespcr
  • 115 Answers

SOURCE: turn signal will not ''flash'' on /off-cops pulled me over about it

The problem is most likely not a bulb and certainly not a fuse but the 'flasher'. The flasher is located under the driver's side A/C duct above the fuse box. It just plugs in so you shouldn't need any tools.

Posted on Dec 13, 2008

  • 7 Answers

SOURCE: plymouth acclaim ignition repair

the ignition cylinder will run you about 20$ and it is fairly easy to change you can change it yourself buy the chilton book (it will help later) and it will be cheaper than paying for labor although the entire replacement will take less than 30 min

Posted on Feb 19, 2009

  • 396 Answers

SOURCE: 94 Plymouth acclaim speedometer and dash lights wont work

Try replacing light bulbs and flasher which may correct the turn signals. Check all fuses, however as for the speedometer, the plastic clogs or wheels have run their course, If you intend to replace these, suggest you purchase a repair manual for your vehicle.

Posted on Aug 22, 2009

rmoseng
  • 77 Answers

SOURCE: how do i replace the timing belt on my '94 Plymouth Acclaim?

I did it twice and if you are fairly skilled it will take 4-6 hours, if you have the V6.
Here is the steps:
1. Move car to a place that can support a jack and engine stand.
2. Disconnect battery
3. Loosen wheel lugs on passenger side front tire
4. Jack car on passenger side to lift wheel of the ground
5. Put a block under the oil pan to support the engine
6. Block car frame on left side
7. Remove left front tire
8. Remove v-belt
9. Remove idler pulley
10. Remove and support air conditioner compressor
11. Remove PS pump if you have one
12. Remove motor mount on left side and vacuum / gas connections connected to mount ( mark bolts as to locations )
13. Remove metal plate on engine ( mark bolts as before )
Tricky bolts are on the PS pump (Remove them through PS pulley holes)
14. Remove 3 plastic covers over timing belt ( mark bolts as before )
15. Note timing marks on overhead cams and crank.If none, make some.
16. Ease pressure off timing belt tensioner
17. Remove belt and replace with new. Trick here is to make sure you get the belt notches lined up. Head cams will shift when you remove the old belt. Do not tighten the belt tensioner fully or it will not perform as designed, it should be snug but be able to move.
END... replace part is backward order and drive away !!!

Posted on Dec 16, 2009

  • 4 Answers

SOURCE: Right Turn Signal not flashing.

quick fix,try to run jumper wire from solid lime green wire to tail light green/orange wire Your problem is no power

Posted on Apr 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Turn signal bulbs do not flash when turn signal arm is engaged. Bulbs are on but do not flash. car is a 1991 plymouth acclaim


turn signal switch is bad located under dash or in trunk it looks like a big black fuse look on google for location

Aug 16, 2011 | 1991 Plymouth Acclaim

3 Answers

1993 plymouth acclaim turn signal flashes rapidly, new flasher didn't work.


bad earth on a back light i suspect providing their europeon standard lights with yellow seperate indicators and not them funny american ones with a stop and tail and indicators all on the one bulb

Jun 27, 2011 | 1993 Plymouth Acclaim

1 Answer

Front right signal lights come on but don't blink, rear right does not come on at all. Left side is working fine.


That means that the right rear bulb is blown and needs to be replaced and then you should have your turn signals back to working right. I hope this helps you and good luck.

Mar 29, 2011 | 1992 Plymouth Acclaim

1 Answer

Someone hit my left front bumper and now my signal lights don't work


they blow one of the turn signal bulbs out. replace you front turn signals. if that dont do it then your turn signal switch or turn relay is bad.

Jan 05, 2011 | 1992 Plymouth Acclaim

1 Answer

The left turn signal works okay the right turn signal lights stay on won't flash


It sounds like you need to replace a turn signal buln, check both front and rear

Oct 13, 2010 | 1993 Plymouth Acclaim

1 Answer

I have no signals and when brakes lights are on, lose brake light to either side turn signal is set on


Hi!!

If you activate the turn signal switch and you step on the brake pedal, the turn switch (on the steering column) deactivates the brake light to make the signal light more visible. The bulb for the stop and turn lights is the same.

Turn hazard lights ON. If they don't blink, replace turn/hazard flasher, If one or more lights don't come on, replace bulb.

Check fuse and circuit wiring for broken or loose connections. If all looks fine, check following:

If front turn lights work fine, check brake/turn bulbs.

If turn lights come on but don't blink, replace turn signal/hazard flasher.

If front and back turn lights don't come on, replace switch on column.

Let me know how it worked out, Good Luck

Mar 24, 2010 | 1991 Plymouth Acclaim

1 Answer

94 Plymouth acclaim speedometer and dash lights wont work


Try replacing light bulbs and flasher which may correct the turn signals. Check all fuses, however as for the speedometer, the plastic clogs or wheels have run their course, If you intend to replace these, suggest you purchase a repair manual for your vehicle.

Aug 22, 2009 | 1994 Plymouth Acclaim

1 Answer

1990 acclaim signal and brake lights


You need to check for power & ground at left rear socket, and clean it & contacts in it well, and may have to squeeze socket a bit to supply better ground to outside of bulb base. If that doesn't work, poke wires going into back of socket with test light, with signal on, and if power present, replace the socket assy. About $5.00

Feb 12, 2009 | 1990 Plymouth Acclaim

1 Answer

Turn signal will not ''flash'' on /off-cops pulled me over about it


The problem is most likely not a bulb and certainly not a fuse but the 'flasher'. The flasher is located under the driver's side A/C duct above the fuse box. It just plugs in so you shouldn't need any tools.

Dec 13, 2008 | 1991 Plymouth Acclaim

Not finding what you are looking for?
1994 Plymouth Acclaim Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...