Question about 2005 Infiniti G35

Open Question

G35 sedan Throttle problem (VDC, SLIP)

As i was driving my G35 (Sedan, Automatic transmision) the throttle suddenly was not responding and no matter how hard i press on the throttle padel the rpm will only rev to about 1200 max the SLIP & VDC lights on my dash board lights up as well as the SERVICE ENGINE SOON light. i will have to pull over and turn the car off start it again and everything goes back to normal again. This happened several times usually when the car speed is around 40 mph or less.
Nissan dealership couldn't find errors on their computer. They think replacing the throttle box might fix the problem....
What is wrong with my car??

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
kcmetal9901
  • 102 Answers

SOURCE: How do I get the fuel door unlocked - 2003 G35 Infinity Sedan

there is a small cable in the trunk behind the carpet that,when pulled, is a manual release. Look behind the carpet on the side of the cars gas tank. hope this helps. Don't forget to rate my answer.

Posted on Dec 10, 2008

Ad
jmassengill
  • 345 Answers

SOURCE: replaced braked pads - now VDC and Slip Lights are on

I would take the car to almost any auto parts store and ask them to check the ODB II computer for codes and to reset the "Check engine light". Get the code that they tell you and it should go a long way to pointing you in the right direction to fixing this problem. It might also be that when you pumped the brakes that you somehow set a code in the computer from the ABS system and now that you have the brakes pumped up and working correctly resetting the Check engine light might fix your problem.

Good luck! Write back with any code you get and I'll see if I can help you figure out what the problem might be.

Posted on Jan 06, 2009

  • 1 Answer

SOURCE: I have a 2004 infiniti sedan g35... the pass side seat does not

i just fixed this problem - the switch is bad - take out the seat - 4 bolts on the bottom 4 corners and then remove the whole switch - either buy a new one around $200 or unsauter the switch and clean it but be careful as there are a lot of parts inside that can fall out. i cleaned mine and it works fine beats spending the money.

Posted on Apr 24, 2009

isaid
  • 302 Answers

SOURCE: where is the starter located on a 2004 g35

ACESS DA STARTER FROM UNDER THE CAR, IF U STILL CANT LOCATE IT JUST FOLLOW DA POSITIVE BAT. CABLE FROM BAT TO STARTER

Posted on Oct 04, 2009

  • 86 Answers

SOURCE: 2003 Infiniti G35 - VDC, slip and brake lights on

The abs sensor may have been damaged when the repair was done.

Posted on Feb 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2012 hyundai sonata accelerates on its own


Just keep foot close to brake peddle. Hahaha. Jk. Spray some wd-40 on your throttle body and throttle cable. If not that then take of throttle body and clean butterfly.

Mar 24, 2016 | 2012 Hyundai Sonata Hybrid Base Sedan 2.4L...

1 Answer

2007 Infiniti G35


These solenoids are two trip detection items now computer is in limp in mode these solenoids are oil controlled also so make sure the oil is full and no over due for replacement.

May 06, 2014 | 2007 Infiniti G35 Sedan Sport Sedan

1 Answer

How do I find or adjust the gas peddle sensor on a 2003 infinity g35 sedan


Follow the air intake back until you get to the throttle body. the throttle position sensor is mounted directly next to the actual throttle spring linkage. should be about 2"long with a 2 prong shrouded connector plug

Jun 16, 2012 | Infiniti Cars & Trucks

1 Answer

Infinity g35 sedan slip, vdc lights


When ever you get these waring lights it means the computer control module has sensed a fault in the systems many parts or wiring, in order to begin the diagnostics to repair the fualt the system must be scanned for fault codes. this is the number 1 first thing that must bwe done.

Feb 15, 2012 | 2005 Infiniti G35

1 Answer

I drive G35X - 'VDC OFF' and ''SLIP" lights are


VDC OFF light will always be off unless you turn it off (this is for traction control). The slip light should not be on however, unless you are driving in rain/snow and the VDC is activated.

Feb 09, 2011 | 2007 Infiniti G Sedan

2 Answers

My vdc,slip & brake lights is on


Same thing happened to my 2003 Infiniti G35 Sedan. My mechanic has adjusted my brake booster (above the brake pedal) and so far it has been ok.

Jan 25, 2011 | 2005 Infiniti G35

1 Answer

Vdc,slip,abs comes on my g35 and while i drive it stops suddenly so what is the problem


Recently had the same issue one week ago. I had to replace the cam and crankshaft position sensors. Which were about $600 in repairs. You can always take your car to AutoZone and let them put it on diagnostic machine for free.

Dec 18, 2010 | 2005 Infiniti G35

1 Answer

1998 Dodge caravan AWD transmision slips at full throttle


Have you serviced the transmission latley? fluid, filter, band adjustment

Usually under heavy throttle causing the slip is caused by a seal in the pump leaking off hydraulic pressure letting the clutches slip.

Does it slip in all gears or just 1st.?
Does it slip in reverse?
The reason I ask this is because 1st and reverse use different fluid pathways,

also you can take it to a tranny shop and have them check the fluid pressure at the accumlator port to determine what the exact problem is,but my advice is to just drive it easy and make it last as long as you can,a new or rebuild tranny from a dealer would run 2500 or more.

there is a website www.car-part.com that you can use to find a replacement transmission

Mar 31, 2010 | 1998 Dodge Caravan

1 Answer

Replaced braked pads - now VDC and Slip Lights are on


I would take the car to almost any auto parts store and ask them to check the ODB II computer for codes and to reset the "Check engine light". Get the code that they tell you and it should go a long way to pointing you in the right direction to fixing this problem. It might also be that when you pumped the brakes that you somehow set a code in the computer from the ABS system and now that you have the brakes pumped up and working correctly resetting the Check engine light might fix your problem.

Good luck! Write back with any code you get and I'll see if I can help you figure out what the problem might be.

Jan 06, 2009 | 2004 Infiniti G35 Sport Coupe

Not finding what you are looking for?
2005 Infiniti G35 Logo

Related Topics:

487 people viewed this question

Ask a Question

Usually answered in minutes!

Top Infiniti Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14363 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...