Question about 2008 Mitsubishi Lancer GTS CVT Sedan

Open Question

How do i bleed a 2008 lancer gts clutch - 2008 Mitsubishi Lancer GTS CVT Sedan

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 6 Answers

SOURCE: Lancer IPod connect cord

I own a 2007 Eclipse.
You can purchase the cord from the dealership, with the instructions for the I-Pod cord. Not hard to install on the Eclipse, takes about 30 minutes to install. This is the only known place to get this I-Pod connector.

Posted on Feb 18, 2009

  • 5 Answers

SOURCE: Service the brakes

yes and you can go to autozone to get the parts and a step by step brake service manual with illustrations

Posted on Jun 12, 2009

bschilz
  • 2049 Answers

SOURCE: I am trying to change the serpentine belt on my

First, you need to have the diagram for how the belt is routed when you replace it.

Serpentine routing diagram...

9c37528.jpg
Here is a link to a video on how to replace the serpentine belt. I hope it helps!

http://www.wonderhowto.com/how-to-inspect-replace-cars-serpentine-belt-267229/

Posted on Feb 20, 2010

  • 9 Answers

SOURCE: Which is the tensioner pulley on the 2008

Its usually the one with the 3/8" square hole in it.

Posted on Feb 20, 2010

Testimonial: "Perfect. Thank you!"

dncholas
  • 222 Answers

SOURCE: what are the steps to bleed the clutch on a

On most cars it's pretty much the same. Make sure the reservoir is full and leave cap off it. Get a small crescent, dot3 fluid and another person. Have them pump up the clutch and hold it to the floor. You open the bleeder on the slave cylinder and let it squirt until stops. Close bleeder. Check reservoir and add if needed. Repeat. Do this about 3 times and will do the trick unless you have a leak in the line.

Posted on Sep 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 Mitsubishi lancer radio from loud squealing noise


What is causing that irritating noise? ' DSMtuners

www.dsmtuners.com > ... > Articles: Miscellaneous
Jun 1, 2009 - 2 posts - ‎1 author Check the ECU power relay in the console, under the radio. ... You hear a loud clicking type noise from under the hood when you try to start the car. .... You hear a squealing, grinding, or rubbing noise in the lower timing belt .... The Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, Mitsubishi Galant VR-4, ... LOUD squeak when turning steering wheel (Video Inside)
22 posts
Mar 5, 2011
Why does my alternator belt squeal so much on initial ...
25 posts
May 14, 2010
More results from www.dsmtuners.com

Lancer Troubleshooting [Archive] - evolutionm.net

www.evolutionm.net/forums/mitsubishi-evolution-forums/f-203.html
NEED RADIO HELP! ... Help not start Lancer GT 2012 EngineOverheating STOP SAFELY warning on ... AC ISSUES 2011 Mitsubishi Lancer ES · 2008 Lancer GTS no start please ... 2011 lancer no sound · Driver/Passenger side floor squeaky? ... plastic piece of rear shelf rattles a lot · Very loud noise on Lancer ES 2008 ...

Dec 03, 2015 | 2008 Mitsubishi Lancer GTS CVT Sedan

1 Answer

Could it be the booster


check your push rod going from the pedal to the booster a quick way is to pull the vaccum hose and see if they release the vaccum not being released can cause sticky problems also check your vaccum hose also

May 26, 2014 | 2008 Mitsubishi Lancer GTS CVT Sedan

1 Answer

Bleeding brakes


2 person process. Start with the passenger rear first. then the driver side rear. Then passenger front and driver front. Very important for whoever is pumping the pedal not to release the pedal before you close the bleeder. If this happens you will have to start all over again due to letting air in the system. An air bound system is dangerous.

Jan 28, 2014 | 2008 Mitsubishi Lancer GTS CVT Sedan

1 Answer

How do I replace a tension pulley on a 2008 Mitsubishi lancer GTS


Remove drive belt. Remove bolt and belt tensioner assembly. Reverse procedure to install

Mar 23, 2012 | 2008 Mitsubishi Lancer GTS CVT Sedan

1 Answer

Service the brakes


yes and you can go to autozone to get the parts and a step by step brake service manual with illustrations

Jun 09, 2009 | 2008 Mitsubishi Lancer GTS CVT Sedan

1 Answer

Lancer IPod connect cord


I own a 2007 Eclipse.
You can purchase the cord from the dealership, with the instructions for the I-Pod cord. Not hard to install on the Eclipse, takes about 30 minutes to install. This is the only known place to get this I-Pod connector.

Jan 21, 2009 | 2008 Mitsubishi Lancer GTS CVT Sedan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...