Question about 2005 Chrysler Town & Country

1 Answer

Had the transmission flushed now the check engine light is on the light was not on before the car has 87000 miles

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 530 Answers

When did you first notice the light? Has been on since the work on the transmission?
If this is the case it's possible that the vehicle was started before all the electrical connections were reattached. It's also possible that a connection was forgotten or has came loose after the work. For example if you unplug the one of the fuel injector connection's and start the car it will give you the check engine light and generate an error code. That will stay active even after you plug the injector back in until the code is cleared.

This however is only an assumption due to the recent work. Any engine light and or code should be taken seriously until you can positively ascertain it's cause. Your recourse should be to retrieve the code and identify it's cause.
There are several ways you can do this. First is to retrieve the codes yourself. The steps for this are as follows.

  • 1. Insert the ignition key into the ignition switch.
  • 2. Turn the key 3 times to the on position with in 5 seconds. Do not turn it to the start position.
  • 3. With pen and paper handy record what appears in the odometer window. An example of a code is P0302 or P1479.
If you have any trouble with this you can also get these codes read at places like Auto Zone for no cost. After you have the code or codes you can repost here for a complete definition of the codes and an opinion weather they might be related to the recent work.
I hope this helps.

Posted on Sep 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

07 ford focus check engine light on. O/D light blinks. 68000 miles. Automatic. Codes po972 shift solenoid . PO972 flush transmission fluid. PO972 replace transmission. Fluid looks correct color. Car...


Hi, I suggest you take the vehicle to a Ford agent, car needs diagnostic tuning to check errors and cancel them. This may be your safest choice in terms of protection of the vehicle operation.

Mar 05, 2015 | Ford Cars & Trucks

1 Answer

1994 chev cavalier v-6


There could the short in the wiring which is causing the sensor to malfunction on the car check the sensor if they are good in the car...





Aug 06, 2008 | 1994 Chevrolet Cavalier

1 Answer

2005 chevy impala.. transmission slipping or something. this car has about 193,000 miles on it.. im wondering why its slipping (transmission) and if its even worth fixing...???


HI,
First, verify the transmission fluid level is correct - look in the Owner's Manual for info. 2nd get a transmission fluid replacement - do NOT do a 'chemical flush' it could make it even worse....just have them drain out ALL the old fluid and put in new fluid. Shouldn't cost more than $100. If you have any Check Engine Lights or other unusual lights on, get those checked out, too.

Per KBB.com car is worth about $2500 if you sell it yourself; dealer might give your $1500 but only $500 w/a bad transmission. A rebuilt transmission would likely cost $2000....do NOT fix it. 193K miles is a lot on any car especially an Impala. Time a for another car.

GL,
TD

Mar 14, 2014 | Cars & Trucks

1 Answer

Car is a 2003 PT Cruiser with 87000 miles on it and yesterday the check engine light came on and the car seemed to kick itself out of drive (its an automatic) the car drives ok sometimes but seems to lack...


The P0700 is a general transmission control fault. It would be very difficult for an individual lacking expensive equipment to figure this out, I would take the vehicle to a transmission shop or chrysler dealer.

Mar 27, 2011 | Chrysler PT Cruiser Cars & Trucks

1 Answer

87000 miles. Was driving back...20 miles. On the way there, no problems, then the "check engine" light came on the way back home. Nothing audible to recognize any probs. Any...


Well when the check engine come on that means the computer stored a code and you need to scan the computer to get the code. Go to an auto part store like Auto zone and they will scan it for you for free and give you the code then bring it here and i will tell you what it is. take care

Dec 30, 2010 | 2002 Chevrolet Cavalier Coupe

1 Answer

Should a 2002 jetta tdi- automatic at 87,000 miles


That specific transmission is known for failure. Sometimes it's premature failure (in your case) and sometimes they have 150k miles, but that specific automatic transmission will always fail.
There are plenty of stories online about premature failure of the 01M VW transmission...

May 10, 2010 | 2002 Volkswagen Jetta TDI

1 Answer

2000 GS300 LEXUSVSC OFF AND CHECK ENGINE LIGHTS KEEP COMING ON


disconnect negeative (-) battery cable for 20 seconds....reconnect and start car. Check engine light should now be off. I

May 19, 2009 | 2000 Lexus Gs 300

3 Answers

Transmission Service Required message


They are correct as to the Location of the Sensor and, It would be a Time Consuming and Expensive Repair But, If you are not getting the Red Caution Light I would have the Tranny Flushed and Filled and see if it is not Just Buildup on the Sensor. It could actually Release itself. If not you will eventually have to get a Rebuild Buut, Try the Flush and Fill First.

Jan 20, 2009 | 2002 Volvo S80

Not finding what you are looking for?
2005 Chrysler Town & Country Logo

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...