Question about 1987 GMC R3500

Open Question

Code P0219 (overspeed condition) how do i fix it? It is on a GMC 7500 year 1981 with 202 motor.

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I ran the computer on my 2006 Chrysler touring and it said po219, does anyone have a clue as to what I need to fix to get my car going. It won't start at all


P0219 is engine over speed condition. Usually pops when the transmission slips. It doesn't keep the engine from starting though. What happens when you try to start it?

May 01, 2016 | Chrysler Cars & Trucks

1 Answer

Fuel pump relay on gmc 7500 2003 with gas engine?


images for Fuel pump relay location on gmc 7500

GM Fuel Pump Relay Testing - YouTube

? 27:40
https://www.youtube.com/watch?v=McnXLcJNVfI
Mar 14, 2012 - Uploaded by ScannerDanner
How to manually jump a fuel pump from the fuse box ... Is this the same on the 2003 cavalier chevy? ... I go through fuel pumprelays often on my 99 GMC Yukon Denali. ... Finally, fuel pressure totally drains after motor turns off. ... run right, it would sputter when you hit the gas and finally just would not start.Missing: 7500

Dec 10, 2015 | GMC Cars & Trucks

1 Answer

Keeps throwing up trouble codes p1506,p1151,p0302,p0171


Definition of Diagnostic Trouble Code P1506 Audi: Closed Throttle Position Switch Does Not Open/Short to Ground BMW: Idle-Speed Control Valve Opening Solenoid Control Circuit Signal High Ford: Idle Air Control Overspeed Error (see P0507) Jaguar: Idle Air Control System RPM Lower Than Expected - B Bank Kia: IAC Valve Opening Coil Voltage High Lincoln: Idle Air Control Overspeed Error (see P0507) Mazda: Idle Air Control Overspeed Error Mercury: Idle Air Control Overspeed Error (see P0507) Porsche: Throttle Jacking Unit Lower Mechanical Stop, Signal Implausible Volkswagen: Closed Throttle Position Switch Does Not Open/Short to Ground Volvo: IAC Valve Opening Signal
------------------------
Definition of Diagnostic Trouble Code P1151 Audi: Bank1, Long Term Fuel Trim, Range 1 Leanness Lower Limit Exceeded BMW: Oxygen Sensor Heater Circuit Signal Intermittent (Bank 2 Sensor 1) Ford: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Lean Jaguar: Lack of H02S-21 switch, sensor indicates lean Land Rover: Lambda control limit bank 2.Implausible signal/condition Lincoln: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Lean Mazda: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Lean Mercury: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Lean Subaru: HO2S-12 Heater Circuit High Input Toyota: Coolant Path Clog Up for Coolant Heat Storage System Volkswagen: Bank1, Long Term Fuel Trim, Range 1 Leanness Lower Limit Exceeded
------------
Definition of Diagnostic Trouble Code P0302 Category: Powertrain Definition: Cylinder 2 Misfire DetectedNote: This definition of P0302 is applied to all manufacturers
--------------------------
Definition of Diagnostic Trouble Code P0171 Category: Powertrain Definition: System Too Lean Bank 1Note: This definition of P0171 is applied to all manufacturers

Jun 17, 2015 | Cars & Trucks

1 Answer

Good Evening, my 1997 GMC Suburban transmission started slaming into gear and code 1846.


That code is for an encoder motor(shift motor) on the transfer case.Not difficult to change but expensive to buy(200 dollars).Check all the wires and make sure none are nicked and that everything is plugged up good before replacing.You will need to remove front drive shaft to get the encoder motor off the transfer case.The hard shifts are due to a limp condition set by the code being stored.

Mar 27, 2011 | 1997 GMC Sierra

2 Answers

93 gmc k2500 4x4 runs like its missing when warmed up. cat.converter? pulled someone out of mud,hard. over tacked engine


a bad cat will cause it not to rum faster than 45mph. usually miss at warm after over taxing is bad camshaft. you probably knock the lobe down. you need to do a compression test on all cylyinders. they need to be reading close to each other. also just make sure plugs and wires are good. cap and rotor also

Dec 27, 2009 | 1993 GMC Sierra K2500

1 Answer

Just a simple question: on a 2001 Galant with a 2.4 engine is the oil change interval 7500 miles under normal conditions?


You can go that long, but good ole 3000 miles is better insurance then 7500. If you are using a synthetic motor oil like Mobil 1 rated for that then yes it will be fine. If normal off the shelf is being used then every 3000.

Dec 14, 2009 | 2001 Mitsubishi Galant

1 Answer

How do I fix a coolant fan overspeed?


it`s your cooling fan relay look in your owners manual to locate wher it`s @

Oct 07, 2009 | 2003 Chevrolet Trailblazer Ext

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

244 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...