Question about 1995 Jeep Wrangler

1 Answer

The fan motor does not work in my 1995 Jeep Wrangler. The previous owner pressured washed under the hood, and the A/C blower has not worked since. What is the problem and how do i fix it?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,187 Answers

The pressure may have knocked the electrical connector on the fan motor. Re-seat it.
I doubt that the motor is burned-out.

If that doesn't work,
Disconnect fan motor connector and turn ON engine & A/C compressor.
Check for 12 volts at the fan motor connector. If it's there, the motor is burned-out. If no voltage at the connector, then replace the "cooling fan" relay in the fuse box under the hood.

Posted on Sep 29, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

06 wrangler blower fan stops working


I'm not following your story.
Does the blower motor stop working from time to time ?
Have you checked the motor for power and ground when it is not working ?

Feb 11, 2013 | 2006 Jeep Wrangler

1 Answer

I have changed the resistor and the fan switch on a 1997 jeep 4.0 wrangler, but only the high fan speed still works. what else could it be.


Sounds like its a bad blower motor connector,Find blower motor connector and perform a wiggle test while turning fan switch up and down.Also look at connector for melted wires or the connector itself.Hope this helps!!

Apr 20, 2011 | 1997 Jeep Wrangler

2 Answers

I have a 1999 Jeep Wrangler and the heater fan stopped working for all the fan speeds. The fuses are fine. How do you know if it is the blower resistor or the blower motor?


If you bypass the resistor pack and connect the motor directly to the fused 12v supply then the fan should run at maximum speed. If so, it's the resistor pack that's blown: a very common fault on a huge number of makes and models.

Feb 13, 2010 | 1999 Jeep Wrangler

2 Answers

A/c - heater blower died, 2004 Wrangler Postal/Sport


THERE ARE 2 SETS OF FUSE BOX,1 UNDER THE HOOD AND ONE INSIDE,INSIDE IS WERE YOU WILL FIND THE BLOWER FUSE.BUT FIRST I WOULD JUST HIT THE BLOWER WITH A SAY SCREW DRIVER, JUST TO MAKE SURE ITS NOT THE BRUSHES INSIDE THE MOTOR ITSELF..JIM,PS MAKE SURE THE MOTOR IS TURNED ON BEFORE HITTNG IT

Aug 20, 2009 | 2004 Jeep Wrangler

2 Answers

Heater blower switch only works on high


I'd replace blower resistor, usually found under hood on firewall on passenger side, or on duct work, inside under dash on passenger side,close to blower motor.

Jun 01, 2009 | 2004 Jeep Wrangler

1 Answer

Defrost fan quit working.


Check it with a test light or Multimeter for power to blower motor first, with switch on high. If no power to motor, problem is elsewhere. Here's a link that will help you. Click on the pictures to expand.

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528008ac7f

Feb 12, 2009 | 1995 Jeep Wrangler

1 Answer

Wrangler jeep heater/AC fan


Usually, when the fan works only on high speed the issue is with the blower motor resistor. It will be located under the dash close to the blower motor itself. It will have a multi-wire plug and feeds signal to the blower motor. An updated resistor maybe available in which case a slightly larger hole will have to be cut for the new resistor. This is not a difficult proceedure, only a couple of screws are holding the resistor in place and most resistors are resonably priced. I recommend you buy the resistor at the dealer, this is a case where you get what you pay for.
Good luck, hope this helps.

Jan 18, 2009 | 2003 Jeep Wrangler

Not finding what you are looking for?
1995 Jeep Wrangler Logo

193 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...