The windshield washer resevoir is leaking on my

6ya staff

• 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

6ya - Get Instant Help

6ya.com

Need repair answers fast Use 6ya to...

Posted on Jan 02, 2017

SOURCE: Replace Cabin Filter in my 2002 C240 Mercedes Benz

after changing air filter and spark plugs engine still shakes ???

Posted on Jun 19, 2008

SOURCE: Replace Cabin Filter in my 2002 C240 Mercedes Benz

I have a 2002 C240 Mercedes and need to replace the cabin air filter. Problem, I don't know were it is located or how to replace it. Can you help me.

Posted on Mar 21, 2009

SOURCE: Removing the windshield washer reservoir in a 2002 Chrysler T&C

REMOVAL

1. Disconnect and isolate the battery negative cable.
2. Remove the engine fresh air housing inside the engine compartment.
3. Disconnect the washer hose at the in-line connector forward of the cowl grille so that the in-line connector remains with the washer hose from the fresh air plenum.
4. Disconnect the washer hose from the hose clip located on the front fender side shield.
5. Remove the filler tube screw.
6. Hoist and support vehicle on hoist or jack stands.
7. Remove the right front wheel and tire assembly.
8. Disconnect the left right front wheelhouse splash shield and move aside.
9. Drain washer fluid from the reservoir and into a suitable clean container. This can be done by disconnecting the windshield washer hose from the front (outboard) washer pump and allowing the washer fluid to drain into a container through a temporary jumper hose connected to the front washer pump.
10. Disconnect the electrical body harness connectors to the washer pump motors and the fluid level sensor. Slide the red lock on the connector to the release position, then, depress the black tab and pull the connector off the pump or sensor.
11. Remove the two reservoir mounting screws.
12. Disconnect the reservoir from the body mount by raising the reservoir upward slightly and then down so that the reservoir filler neck and front washer hose pull through the opening in the front fender side shield.

1. Push filler neck and front washer hose through the opening in the front fender side shield. Connect the reservoir to the body mount by lowering the reservoir down.
2. Install the two reservoir mounting screws. Torque screws to 8.5 - 11.3 Nm (75 - 100 in. lbs.) .
3. Connect the electrical body harness connectors to the washer pump motors and the fluid level sensor. Slide the red lock on the connector to the closed or locked position.
4. Assure that washer is properly routed to prevent pinching and possible inoperative washers.
5. Connect the left right front wheelhouse splash shield and move aside.
6. Install the right front wheel and tire assembly.
7. lower vehicle from hoist or jack stands.
8. Install the filler tube screw. Torque screw to 8.5 - 11.3 Nm (75 - 100 in. lbs.) .
9. Connect the washer hose to the hose clip located on the front fender side shield.
10. Connect the washer hose at the in-line connector forward of the cowl grille.
11. Install the engine fresh air housing inside the engine compartment.
12. Connect the battery negative cable.
13. Verify system operation.

Posted on Apr 01, 2009

gord storey

• 477 Answers

SOURCE: MY WILL NOT START THE CAR C240 MERCEDES BATTERY IS NOT DEAD

I am assuming that the engine won't even turn over. could be lots of different things. The simplist is to make sure the car in in PARK , won't start if not. Other things could be , Security imobilizer if you have one. Does your key have a electronic chip in it ? Try your other set of keys if you have one. Check if battery connections are clean and tight.

Posted on Jun 04, 2009

SOURCE: c240 mercedes wont start. after backing into a parking spot?

check for fuel pump operation.have someone turn ignition on while you go to rear of car where fuel tank is to listen for fuel pump operation.if not.check fuse and relay.if you hear fuel pump .check ignition system to make sure engine is getting spark.

Posted on Jun 06, 2009