Question about 2004 Honda CR-V
This is a common problem in honda's. the best way to fix is to disconnect the neg battery terminal and wait 5-10 min and put it back on this will reset the ecu and should fix the problem.
Posted on Oct 01, 2009
Yes, bad pressure switch, p/n 28610-ray-003 sw assy, at oil pr, this part is known as the 3rd pressure switch. cost 78.74, 1 hour labour to install. Also on bill was 90471-pw7-a00 packing 10mm, $5.37, I assume this is a washer or seal.
Posted on Aug 19, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Your emergency brake is a mechanical brake system that is indipendant of the regular hydrolic system. If the red brake light on the dash is on make sure it's the emerg. brake and not a problem with the fluid level or the calapers sticking. the best way to check the emerg. brake is to rase both rear wheels off the ground and spin them. If they spin, the emerg. brake is not locked up. If they don't spin, take the rear tires off and the brake drums. (you may have rear disk brakes.) check the springs to insure they are all hooked up properly. If there is no problem there, follow the parking brake cable to check for damage. The cable is like a brake cable on a bike, If the inner cable is binding inside the cable sleeve,the brake wont release. If you have rear disc, it's probly a bad calaper.The park brake cable is attached to the calapers. Rember if it wont run it's annoying but if it won't stop, it's deadly. DON"T experiment with brakes!!! If in doubt, take it to a pro.
Posted on May 12, 2009
the check engine lamp is not affected by things like tyres, brakes etc. It shows that the vehicles engine management system had detected a fault with the engine or engine sensors. Check the engine for broken or disconnected wiring (maybe it was disconnected during the replacing of the hoses but not reconnected). If you fail to locate anything, check the manual for the correct fault code retrieval procedure or take the vehicle to a professional. Tyres may affect your ABS system or Airbag systems but they usually have their own warning lamp and are unrelated to the check engine lamp..
Posted on Dec 15, 2009
Tips for a great answer:
Mar 22, 2014 | 2012 Honda CR-V LX 4dr SUV 2.4L 4-cyl....
Aug 14, 2013 | Honda CRV Cars & Trucks
Dec 05, 2012 | 2004 Honda CR-V
Jan 11, 2010 | 2004 Honda CR-V
Mar 07, 2017 | 2004 Honda CR-V
1,658 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: