Question about 1994 Toyota Camry

1 Answer

1992 toyota camry v6 le boggs down on acceleration

When reversing, or accelerating 1992 toyota camry le v6 the vehicle starts to go and as its going it completely cuts out all power and then power jolts back and the rpms fly up 3 or past, and then it starts speeding up, and cutting out. at idle it sits at 2000 or so when its usually 1000 to 1.5 thousand rpms i took the car down the road and when i got about a mile, it was refusing to go any further, and i had to restart the car several times during the K turn. once i got going forward again i punched it , and the car switched from bogging to accelerating constantly i pumped the gas pedal to get around turns and up hills, which it barley made. and then i got back to the house, and the car had stalled out, it was off now. i steered it back in the drive way the car was still off, and i parked it.

any ideas? i deliver pizza for a job, so i need my car to work ASAP

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 64 Answers

It sounds like you may have a vacuum leak. Your car should normally idle at about 700-750 RPM. You said that yours was at about 1000-1500, that is waaay to high. If you have a leak somewhere in the system the car will draw in extra air and it will want to idle much higher and will also be very erratic and hard to drive.

Posted on Oct 06, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Is there an Airbag Recall for a 2000 Toyota Camry LE?


The only recall items I could find for that vehicle were Headlights, and accelerator cable defects. Those are probably expired by now...14 yrs. later.

Oct 20, 2014 | 2000 Toyota Camry

1 Answer

I drive a 1991 toyota v6 camry le and i can find out why it doesnt have any power (slow acceleration speeds) the RPMs go up to about 5k and still cant feel the acceleration in it.


1. If you have the check engine light on then the emission control could be doing this because of bad oxygen sensor(s).

2. Check the transmission fluid. If the level is low then the transfer case would not transfer all the power from the engine to the transmission.

Mar 13, 2011 | 1990 Toyota 4Runner

1 Answer

Loss of power during acceleration in 1989 toyota camry v6 with dash board indicating check light


The "check engine" warning light advises that the vehicle is in "fail safe" mode. That means only some of the car's capabilities are operational, just enough to get you to the nearest service point. You probably should not drive it any further than that. Have your service man download and analize the fault codes from the ECM which will indicate what the problem is.

Apr 09, 2010 | 1992 Toyota Camry V6

1 Answer

1992 Toyota Camry V6-Accelerator Pedal Sticks


problem two-try bleeding the radiator to make sure no air locks in it check if radiator fan is connected up and working

Mar 25, 2010 | 1992 Toyota Camry V6

1 Answer

I have a 1992 toyota camry v6, and it was running fine, then all of a sudden it started shaking when i brake, and when i accelerate, it shakes less, and now the engine light turned on. any ideas what it...


Sounds like you may have a vacuum leak. In order to find the leak listen around the engine for a hissing noise. Make sure there is no hissing when you press on the brake

Oct 29, 2009 | 1992 Toyota Camry V6

1 Answer

Bogs down upon acceleration


You have coil over spark plug ignition and one of your coils is bad.You need to find the bad coil and replace it.

Aug 27, 2009 | Toyota Camry Cars & Trucks

1 Answer

I recently bought a 1992 model toyota camry SV21 and 3S-FE engine, it starts well exept that when you try to accelerate, the engine will miss and would like to stall, so just to bring it home I rev it high...


the fuel must be adjusted ,it loses the torque, when press the accelerator ,the engine need more torque when moving the car on 1st gear,compare on the motorway,check for the fuel man ,this will affect the engine on long period

Aug 22, 2009 | 1992 Toyota Camry V6

1 Answer

Loss of power on acceleration from a stop


I would think its a transmission problem. have you tried shifting it manually. starting out in low or 1st gear then 2nd and then drive?

Nov 21, 2008 | 1999 Toyota Camry

1 Answer

2000 camry le accelerator sticking


Spray some WD-40 down the accellerator cable, I'm willing to bet it is starting to rust up

Aug 07, 2008 | 2000 Toyota Camry

Not finding what you are looking for?
1994 Toyota Camry Logo

494 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...