Question about 1996 Dodge Dakota

Open Question

How to remove the rear axle?

How to remove the rear axle on dodge dakota 96 3.9?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: rear differential axle removal

remove the 'locking bolt', once the pin is out the c-clips shoud fall out unless this is a floating axle in which the axles are attached at the hub.

Posted on Sep 12, 2008

Ad
  • 59 Answers

SOURCE: Broken rear slideing glass window on a dodge dakota 2001.

on this truck the rear window is glued in with urethane, if I was cutting it out I would use a special power tool designed to do this. I am sorry but this will not be easy with out it, the only thing I could see is you bending and cut the frame off with a scraper and hammer. (bad picture in my mind) might be worth a stop at an auto glass shop and ask them to remove.

Posted on Feb 27, 2009

  • 14036 Answers

SOURCE: 96 dakota p1391 error

intermittent loss of ckp or cmp.problem is in the distributor.make sure rotor not loose or distributor hold down bolt loose.camsensor on the distributor.also check to see if crank sensor is loose and out of adjustment.

Posted on Jun 07, 2009

redhaze89
  • 854 Answers

SOURCE: how do you remove the rear glass on a 1997 dodge

You can start by pulling the interior back by the rear window. There are two tabs on both ends on the bottom frame, you can bend them straight.Try to pull the bottom of the window out and watch out for the hinges to carefully lift up the window itself.

Posted on Sep 24, 2009

  • 14036 Answers

SOURCE: how to remove rear axle to replace axle seal?

YOU NEED A HAYNES OR CHILTON REPAIR MANUAL.TO REMOVE REAR AXLE YOU HAVE TO REMOVE REAR DIFFERENTIAL COVER AND GASKET.YOUR DIFFERENTIAL HAS EITHER PINION SHAFT LOCKING SCREWS OR C - LOCKS.THEY HAVE TO REMOVED BEFORE AXLE SHAFT WILL COME OUT.

Posted on Mar 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I change rear axle seal on 1991 dodge Dakota 4×4?


Remove the wheel and tire.

Remove the drum.

Drain the rear and remove the cover.

Locate the 8mm bolt locking in the center pin and remove it.

Slide the pin out 1/2 way. DO NOT SPIN EITHER AXLE WHILE THE PIN IS OUT.

Push the axle in from the outside. You will hear the "c" clip fall in the rear. Put the center pin back in the rear and thread the bolt a couple turns.

Slide the axle out.

Remove the outer seal and install the new one.

Reverse the procedure REMEMBERING to put the "C" clip back in.

(Slide the center pin 1/2 way out. Install the axle FULLY. install the "C" clip and pull the axle from the outside to insure the clip is in. DO NOT SPIN THE AXLE until the center pin is reinstalled and the retaining bolt is in.)

May 31, 2015 | Dodge Cars & Trucks

1 Answer

How do you replace a cv joint on a 1989 dodge dakota?


Unbolt the axle from diff & remove the outer
end from the steering knuckle & replace the
entire axle

Nov 12, 2012 | 1990 Dodge Dakota

1 Answer

Dodge dakota lug nut removal on rear axle


Lugs are reversed on Chrysler products.

Apr 30, 2012 | Dodge Dakota Cars & Trucks

1 Answer

How to replace rear main seal on a 96 dodge Dakota 3.9l 2wd?


96 ? engine out ,is it worth this amount of work ?

Jan 05, 2012 | 1996 Dodge Dakota

1 Answer

1988 dodge dakota front diff will not lock in


Remove the two vacuum hoses on front axle
Apply vacuum with a hand held pump and check for
the vacuum actuator, pulling in the right front axle.
If okey,go back to the transfer shifter and check vac sw and hoses.

Nov 23, 2010 | 1988 Dodge Dakota

1 Answer

How many bearings are in a 1999 dodge dakota rear diff


There is an axle bearing on each axle, 1 differential bearing on each side of the differential, and 2 bearings on the pinion gear shaft. 6 total.

May 23, 2010 | 1999 Dodge Dakota

1 Answer

2003 Dodge Dakota lost speedo, reverse lights and ...


It's the speed sensor and it is located on the rear axle.

May 14, 2009 | 2003 Dodge Dakota Club Cab

1 Answer

I need a rear axle for my 97 dakota I found a 95 dakota are they the same?


if the gear ratio is the same in the used axle then yes u can use it, there is a tag on the diff with this info.

Mar 24, 2009 | 1997 Dodge Dakota

Not finding what you are looking for?
1996 Dodge Dakota Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...