Question about 1997 Chevrolet Blazer

2 Answers

How do you adjust the headlights on a 1997 chevy blazer (S-10) 4WD.

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 1,986 Answers

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Posted on Nov 04, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 269 Answers

Lift the hood and you will see the adjusting screws close to the headlamps.Usually two of them.One for up/down the other for left/right

Posted on Sep 29, 2009

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 47 Answers

SOURCE: need to replace rear brakes on 1997 chevy blazer

disk or drum?

Posted on Jun 23, 2009

  • 1986 Answers

SOURCE: How to adjust headlights on 1995 chevy blazer

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Posted on Nov 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you tighten transmission bands in a 1997 Chevy Blazer


These bands are no adjustable by turning an adjuster there are adjusted by a measurement once fully applied and the apply pin come in different lengths.

May 23, 2014 | 1997 Chevrolet Blazer

1 Answer

I have a 1997 chevy blazer that blows the #3 PK- LRS fuse as soon as the headlight and parking light switch is turned on replaced the headlight switch didnt fix it can find a break where it is groundi


make sure fuse is the right size if not check size it calls for if that doesn't work check for shortages in the wiring in dash and bad contact on wire into the switch

Feb 26, 2013 | 1997 Chevrolet Blazer

1 Answer

Can you take the left front signal cover off on a 1997 chevy blazer to change the signal bulb


No. Unfortunately you have to remove the whole headlight assembly. There are two long screws holding it in. You access them from under the hood. Once they are removed you will be able to get the headlight assembly out and be able to get to the turn signal bulb.

Dec 10, 2010 | 1997 Chevrolet Blazer

1 Answer

Automatic transmission band adjustment in a 1997 chevy blazer


I have a 1995 Chevy 1500 4.3 v6 trans bands need to be adjusted I have two out of the four gears. Reverse tends to slip but works. How do I adjust the bands. And what side are they on. I baught it as is.

Sep 20, 2010 | 1997 Chevrolet Blazer

1 Answer

Where are the horn and headlamp relays for a 1997 chevy blazer? My headlights/highbeams will not turn on.


the horn relay is located behind the glovebox in relay center, the highbeam doesnt have a relay, check the bulbs and also check the highbeam switch located on steering column. hope this helps,

Jan 11, 2010 | 1997 Chevrolet Blazer

1 Answer

1997 chevy blazer headlights come on when started but are dim and the brights wont work at all and i have checked all the headlamps


Just to make sure, You do know that the 97 Blazer has daytime running lamps. Right? They will come on when you start it.

Nov 09, 2009 | 1997 Chevrolet Blazer

1 Answer

Replace headlight bulbs on a 2000 chevy blazer LT.


Yes, you can. Just take off the front grill, and the
headlights assembly. Don't tinker with the head-
light assembly adjusting nut, as this would change your headlight level. Take headlight bulb
off and change it. Replace the headlight, then, the
grill, and it's done.

Sep 21, 2009 | 2000 Chevrolet Blazer

1 Answer

Day lights


Yes there is, remove the DRL relay located underneath the hood in the fuse box. Hope this helps let me know if you need any farther assitance. Thank you for using fixya.com

Sep 29, 2008 | 1997 Chevrolet Blazer

1 Answer

1997 chevy blazer


Under the hood in the main power box

Aug 04, 2008 | 1997 Chevrolet Blazer

Not finding what you are looking for?
1997 Chevrolet Blazer Logo

994 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...