Question about 1990 Jeep Cherokee Limited

Open Question

WHERE IS ECU ON 1990 CHEEROKEE - 1990 Jeep Cherokee Limited

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 76 Answers

SOURCE: my 1990 jeep cheerokee oil smells like theres gas in it

yes it could be but you should be getting oil in to the chamber also check your tail pipe if you have white smoke coming out that is oil if it is black that is to much fuel if you are getting alot of water then you definetlty have a bad head gasket you will get some water that is condensation built up in side the muffler but that should burn off quick have somebody hit the gas pedal while you watch the tail pipe if it starts blowing water then it is without doubt good luck hope for the best but prepare for the worst let me know if you need more help

Posted on Jun 25, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Toyota Camry 1990 V6 2.5L obd1 codes 11 and 14 Check Engine Light on. Codes 11 and 14. Hooked up a good pulled hopefully ECU and check engine light came on again after driving 1/5 of a mile.


code 14 - ignition signal. No IGF signal to ECU 4-5 times in succession.. need check: • Ignition circuit (+B, IGT, IGF) • Igniter • ECU

Jan 03, 2017 | 1990 Toyota Camry

2 Answers

What is the location of the ecu for 1990 geo prism?


Should be behind the glovebox or either in the passenger side kick panel.

Feb 20, 2015 | 1990 Geo Prizm

1 Answer

1990 c4 wont start


Check connections to ECU under pax seat I believe, possibly a failed ECU, make sure you buy a new coil as well if replacing ECU.

Mar 15, 2014 | 1990 Porsche 911 Carrera

1 Answer

Where is the ecm located in 1990 geo tracker 1.6l


old posts
same all tracker, vitara in 90s.
behind the left front speaker.
is this clear.?
or others searching i post facts.
http://www.fixkick.com/ECU/ECU.html#Removal_of_ECU:

Jan 31, 2014 | 1990 Geo Tracker

1 Answer

How to find ecu on toyota camry


On my 1990 it was directly behind the stereo. It is incased with black pastic and has 2 bolts holing it in. 1 on the right and 1 on the left under the carpet in each side.

Oct 31, 2012 | 1990 Toyota Camry

1 Answer

My jeep cherokee 1990 4.0l is not getting any current in the fuelinjektor


If the check engine light does NOT come on when cranking, at the times when it won't start, and the relays are clicking and buzzing, then your ECU is in need of repair. The engine will only start after the check engine light comes on and the ecu is what controls that. ECU is likely going bad, causing the delayed start problem typical of early 90's jeeps. Reasonably priced repair or replacement services for your jeep ECU are available on ebay.

Aug 08, 2012 | 1990 Jeep Cherokee Limited

1 Answer

How to replace ignition on 1990 jeep cheerokee


You have to disassemble the steering column in order to remove and replace the ignition key cylinder. Almost the entire innards of the column has to be removed to get to the clip holding the key cylinder in place. It's not a procedure that can be described....you will have to either locate a diagram of a disassembled column or have someone, who has done it before, replace it for you. Sorry to be the bearer of bad news.

Oct 13, 2011 | 1990 Jeep Cherokee Limited

1 Answer

My 1990 jeep cheerokee oil smells like theres gas in it


yes it could be but you should be getting oil in to the chamber also check your tail pipe if you have white smoke coming out that is oil if it is black that is to much fuel if you are getting alot of water then you definetlty have a bad head gasket you will get some water that is condensation built up in side the muffler but that should burn off quick have somebody hit the gas pedal while you watch the tail pipe if it starts blowing water then it is without doubt good luck hope for the best but prepare for the worst let me know if you need more help

Jun 25, 2009 | 1990 Jeep Cherokee Limited

1 Answer

Adjust fan belt 1990 jeep cheerokee


No diagrams available, but under the power steering pump, over on the right of the motor looking toward the back, there is a bolt 12mm head to the right. It is the tensioner bolt. Loosen the 2 bolts at the very back of the pump, and I think 2 through the pully. It should be easy then.

Dec 23, 2008 | 1990 Jeep Cherokee Limited

Not finding what you are looking for?
1990 Jeep Cherokee Limited Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...