Question about 2002 Toyota Camry

Open Question

2002 camry front passenger seatbelt doubled over on itself. How do I restore it to the normal position? The slot it too thin to manipulate the belt.

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 gmc envoy passenger seat belt locked,how do I un lock


When they stick/lock. It is usually because something has dropped into the latch part. Coins are the worst. Food is next. What happens is these get lodged in it and won't let them work. The plastic housing just pops apart. But you need something some and thin to dig out whatever is in the latch. Small paper clips work well for this. But it is work to dislodge the stuff in it. Good luck. btw, very rarely does the spring break in them. but they can. replace the belt if this happens.

Feb 05, 2014 | 2002 GMC Envoy XL

2 Answers

Seat belt alarm wont stop beeping


Check for wire disconnected where you plug your seatbelt into. it will probably go under the carpet a bit, but it is there. If it is broken/disconnected, the alarm will continue to sound. There is one in the passenger side too, but should only sound when a passenger is seated unless you have more than one problem here...

Oct 09, 2010 | 1987 Toyota Camry

1 Answer

'06 Volvo V50 drivers seat belt is jammed, there is no play in the belt and the ratchet locks immediatly no matter how gently it's pulled. Same problem with passenger side the day before but it righted...


I solved this on my 95 volvo 850 glt as follows:

pull the seatbelt pilar cover off from the door jamb. this runs vertically up the pilar between the front an back door (beside the front seats. Once opened loosen the belt by gently pulling the belt upward toward the roof. You'll have to do this sometimes in small increments. Once the seatbelt is pulled out all the way, spray small amount of lubricant into the joint where at the top of the belt spool. Also use a screw driver to push spool upward while pulling the belt. At first it's only going to release a little but eventually the lubricant will work its way into the seam at the top of the belt spool and loosen up the stuck inertia catch. Until it completely loosens you might have to remove the pilar cover again and work the seatbelt out (also use the screw driver technique described above) in order to use the seatbelt. When parking, I would relatch the seatbelt and pull the slack up around the back of the head rest. After a day or so it worked normally.

good luck and don't give up.

Feb 07, 2010 | 2008 Volvo V50

1 Answer

91 Camry Seat belt and power winodws on Passenger side Inop


More than likely, you have a broken wire or two between the body and the driver side front door. This is a very common issue with those cars when tey get older.

Oct 09, 2009 | 1991 Toyota Camry

1 Answer

What do i do?


there is a cable that the auto-seatbelt pulls and pushes from...after a while the cable gets worked into the groove and gets itself jammed and then burning up the motor that operates it. Some of the older Ford Escorts have the same problem. i haven't seen a Colt Vista's door but on the Escort i saw the slot in which the cable moved the seat-belt from the top after i removed the plastic cover. I immediately saw where it was jammed..shoved it in with a screw driver. then i removed the cover where the motor was (near the floor behind the driver's seat) and i manually cranked it to the closed position. The seat-belt was capable of being undone like a normal seat belt at the top. so i had to do that and clasp the bottom lap belt by hand for the lifetime of that car. i could have made it operational so it can jam up again but just kept it sationary to prevent that. At least i wouldn't get a ticket for no seatbelt. hope this helps.

Mar 23, 2009 | 1993 Plymouth Colt Vista

2 Answers

1991 Toyota Camry Automatic seatbelt harness


http://www.toyotanation.com/forum/showthread.php?t=300887
Full version about Automatic Seatbelt troubleshooting for 87-91 Camry written by Professor Oleg Turkin

Jan 26, 2009 | 1991 Toyota Camry

1 Answer

Seatbelt holds passenger tight in seat all the time, 2002 tahoe


There is no fix for this, u will need to replace the seat belt.

Dec 18, 2008 | 2000 Chevrolet Tahoe

1 Answer

2002 Toyota Solara Convertible seat belts not retracting


The front seatblet retractor springs have weakened. Unfortunatly, there are no "user serviceable parts" on them. They would have to be replaced. How many miles is on it? If you have low mileage, the Toyota Customer Experience Center may provide you some assistance, as the belt replacements are quite expensive. I'd call the CEC and explain your dilemma. Here is the number: 1-800-331-4331

Sep 22, 2008 | 2002 Toyota Camry Solara

Not finding what you are looking for?
2002 Toyota Camry Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...