Question about 2004 Chrysler Pacifica

Open Question

Motor mount I need to replace the front motor mount on a 2004 chrysler pacifica. Where is it at?

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Front motor mount needs replacement


front motor mount is the mount at the front of the engine not the front of the car

Jul 12, 2015 | 2005 Chrysler Pacifica AWD

1 Answer

My front blower stopped working in my 2004 Chrysler Pacifica. Where is the blower motor located so I can replace it?


BLOWER MOTOR IS LOCATED PASSENGER SIDE UNDER DASH. MIGHT HAVE A THIN PLASTIC TRIM COVER OVER IT

Jun 24, 2015 | 2004 Chrysler Pacifica

1 Answer

I have a 2004 Chrysler Pacifica that hestates upon take off if it reaches 3000 RPMs. I have to slowly drive till I get enough speed without reach 3,000 RPM so that it won't thump multiple times. M


Personal experience says you have a wiring harness that is grounding out and causing the codes...This is especially true if you have had the typical motor mount issues that are common on the Pacifica...Check the wiring harness behind the drivers side wheel...


Remove the front left wheel (drivers side)
-Remove the wheel well shield (just the front is all that is necessary...fold it back)


-Verify the vehicle ground is still intact (when the motor mount gives there is not enough slack in the ground wire and the wire will pull out of the grounding lug)


-Inspect the wiring harness that is around the transmission that goes to the PCM (when the motor mounts give they can crush and then rest on the harness and wear through the casing and then affect the individual wires...throwing codes...)

Nov 08, 2012 | 2004 Chrysler Pacifica

1 Answer

2004 Chrysler Pacifica Blower won't work


Usally when a blower motor resistor goes bad the fan still runs on high. The resistor lowers the voltage going to the fan to make it run slower. The high setting usually goes straight thru. Resistors are usually easy to get to, under good on the firewall or under dash passenger side. Cost about $24 at parts store. Replace with new if that doesn't work return it.

Aug 29, 2012 | 2004 Chrysler Pacifica

1 Answer

My 2004 Pacifica won't start


Connect a jumper cable from negative on the battery and the other end to the engine block. If it starts look for a broken ground wire under air cleaner box from engine to motor mount or directly in the center front of the engine. The ground in front has a wire attached to it.
Good luck

Jul 12, 2012 | 2004 Chrysler Pacifica

1 Answer

How to change front wiper motor on 2004 Pacifica?


  1. Disconnect and isolate the battery negative cable.

110569875 Front Wiper Module - Remove/Install

  1. Remove the wiper module.

110569873 Front Wiper Motor Mounting

  1. With wiper module on bench, pry apart the socket and ball joint at the end of the bell crank .
  2. Remove the three front wiper motor mounting bolts and remove motor from module/linkage.
INSTALLATION
  1. Position the wiper motor into wiper module and install the three front wiper motor mounting bolts.
  2. Press the socket and ball joint together on end of bell crank.
  3. Install the wiper module.
  4. Connect the battery negative cable.
  5. Verify vehicle and system operation.
  6. Close hood.
11_29_2011_8_57_53_pm.gif11_29_2011_8_58_14_pm.gif

Oct 16, 2011 | 2004 Chrysler Pacifica

2 Answers

Are there any other parts that need to be removed in order to change the front engine mount of a 2005 chrysler pacifica?


are there any other parts i need to move, in replacing front motor mounts for 2005 pacifica

Nov 05, 2010 | 2005 Chrysler Pacifica

1 Answer

Need motor mounts for 2004 Chrysler Pacifica


I'm thinking it has 1 motor mount and 2 dog bones. The mounts usually cost around $30 each and the dog bones $20-25 depending on the material their made of. You can replace these yourself, one at a time. The engine has to be jacked up just enough to take the weight off when you remove the mount. After you have it remove, install you new one/ones and tighten. After removing jack, torque the bolts to spec. Same thing is done with the dog bones. It a type of Motor mount that prevents the engine from leaning weight. These are usually located, one front/top engine area and one on bottom engine area.

Jan 13, 2010 | 1995 Mercury Sable

3 Answers

The peice of steel that holds the engine up in a 2004 pacifica is cracked


and? If you are asking what to do, have it welded before it gets worse.

Aug 07, 2009 | 2005 Chrysler Pacifica

2 Answers

I own a 2004 chrysler pacifica. when i accelerate i hear a noise like you just went over a small bump or hill in the front drivers side. could you tell me what that is and how much it is to fix. thank...


you need to get the motor mounts changed as i had the same problem before....two of them had broke so anytime my car accelerated or slowed down the transmission going through its gears would cause the motor to jump....i would recommend taking it to a mechanic

Jul 25, 2008 | 2004 Chrysler Pacifica

Not finding what you are looking for?
2004 Chrysler Pacifica Logo

Related Topics:

295 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...