Question about 1992 Ford Crown Victoria

Open Question

Looking for location of voltage regulator on 1992 ford crown victoria

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why my 2003 crown Victoria police interceptor start overheating after removing the battery to start another car

You have a voltage regulator that regulates the battery charge. When you removed it you probably bypassed the voltage regulator and your car was running with too many volts and causing it to overheat.

Oct 02, 2014 | 2003 Ford Crown Victoria

1 Answer

Need to find location of IAC valve on 1992 Ford Crown Vic

On rear of throttle body. There is a 2 wire connector and a big tube that goes from it to the air cleaner, it looks like a little motor and it is held in with 2 bolts

Aug 13, 2013 | 1992 Ford Crown Victoria

1 Answer

Where is the headlight fuse located on a 92 ford crown victoria?

If you are keeping this vehicle and do your own work on it, I 'd recomend going to ebay and buying a original Ford EVTM (electrical vacuum troubleshooting manual) for your specific vehicle. It is a very simple and well illustrated book to understand.
I have one for my 1992 crown vic. It show a 40 amp fuse in the engine compartment fuse box for the lights.

Mar 31, 2012 | 1992 Ford Crown Victoria

1 Answer

Battery voltage needle goes up and down when my 92 crown vic idles. As if car wants to shut off.. what causes this problem?

The most likely problem here would be the alternator itself. Either the brushs are wearing out or the regulator is going bad. It wouldn't hurt to check the tension on the drive belt. If it was fairly loose that could cause the problem too. Hope this hrlps.

May 29, 2011 | 1992 Ford Crown Victoria

1 Answer

Where is fuel regulator located on 1989 crown victoria

Hello k_woodard878,

the fuel pressure regulator is attached to the fuel injector rail. I've included a picture below It's item #6.
I hope this helps you.



Apr 11, 2011 | 1988 Ford Crown Victoria

1 Answer

Where is the fuse box located in a 1992 ford crown victoria?

Fuse junction box is located to the left of the steering column. remove the instrument panel steering column cover

Sep 10, 2010 | 1997 Ford Crown Victoria

2 Answers

Know anywhere to find a replacement front ford emblem with clips for a 1992 crown victoria?

hello there:
i would suggest going to a salvage yard to locate the emblem or you might even be able to find it on ebay motor but if no luck there you may need to go to the dealership and have one ordered hope this helps you out sincerely D.Jones

Jun 01, 2010 | 1992 Ford Crown Victoria

1 Answer

No dash lights ,now no running lights

Check the head light switch for out put voltage to the head lights,and also check for input to the head lights,most likely will find a burned out fusible link.The fusible link is a wire,that will burn out,if it is compromised ,in other words,if it is not tight,or to much voltage,or bad connection.Also a short will do this,it is located ,on the positive battery cable attached to the starter with the large cable,or it is attached where the positive cable is joined at a junction,most likely a stud,and could have a red plastic cap on it.

Jan 05, 2010 | 1992 Ford Crown Victoria

1 Answer

At stops battery votage goes up and down causing car to shake

you should check you altenator and get it tested.

Feb 26, 2009 | 1992 Ford Crown Victoria

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides