Question about 1991 Nissan 300ZX

Open Question

What's the size of starter bolt for 1991 nissan 300zx?

Posted by on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What Or the starter Mounting Size on 1991 Nissan Maxima


after reading your question I`m guessing you want to know what the bolt size is. they are 13/14mm bolt heads.

May 06, 2015 | Nissan Cars & Trucks

1 Answer

Starter bolt stripped. Helicoil or tap?


Either way ,is a lot of work. First thing I would try is a little bit longer bolt. Take a screw driver and push into the stripped hole to determine how long you can go.Even 1/4 inch more threads might be enough to hold starter secure. A little sealer on threads would be good.. If all that fails ,try to oversize the bolt and retap.Make sure the oversize bolt will go through the starter. I have had good success with J B WELD [brand] to drill and retap. Just make sure the surface is clean

Feb 25, 2011 | 1991 Nissan 300ZX

1 Answer

Car won't start. Transmission was just replaced.


safty netural switch may be unpluged or bad will not start

May 04, 2010 | 1991 Nissan 300ZX

1 Answer

I have a 1991 nissan 300zx 5spd manual wont start i have full power in the dash i have check the clutch pedal for the safety switch and little activation button all is ok can you help


check the starter solenoid and the starter connections. if either of them burned up the car wouldnt start.... wait... is it turning over or no? if not then check your power transistor unit on the passenger side timing cover. could also cause it to not start..

Jan 31, 2010 | 1990 Nissan 300ZX

1 Answer

How to remove a 1989 nissan 300zx starter


Changing StarterIts easy, jack the car up, secure the car with in the up position do not just rely on the jack to hold it up and you will see the starter on the passenger side of the car, its held on with 2 bolts. Disconnect the battery first, then loosen and remove the 2 bolts holding the starter in place. Slide the starter out, disconnect the wires coming from the battery. Reverse the procedure to replace the starter.

Oct 05, 2009 | 1989 Nissan 300ZX

1 Answer

90-96 Nissan 300zx auto/5spd starter the same?


The starter should fit either an automatic or manual.

Jun 27, 2009 | 1991 Nissan 300ZX

1 Answer

Can't get the starter out of a 1991 Nissan pickup.


The second bolt is hidden way up and tucked in near the solenoid. You need to setup a ratchet with extensions/socket (14mm) combination that is just a little longer than the starter motor. If you just can't picture where the bolt is, then go down to the parts store and look at/purchase the replacement starter to see how it mounts up.
There are two bolts for the starter mount and one nut for the main starter power lead. There is one plug for the starter key switch.
Disconnect plug. Loosen lower bolt. Remover upper bolt. Remove lower bolt. Twist starter so you can remove main power cable nut (be sure to have disconnected the battery first!) Pull starter.

Apr 18, 2009 | 1991 Nissan Pickup

1 Answer

1991 Nissan 300ZX fuse box diagram needed


first here is the service manual http://www.300zx-twinturbo.com/cgi-bin/manual.cgi

next is the kick panel http://209.85.62.26/12640/0/upload/p979648.jpg

These should be right or very close .

Mar 27, 2009 | 1991 Nissan 300ZX

Not finding what you are looking for?
1991 Nissan 300ZX Logo

Related Topics:

192 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...