Question about 1993 Jeep Grand Cherokee

Open Question

93 grand Cherokee stalling

My 93 grand Cherokee stalls after it warms up I change the fuel filter and have no check engine light any one able to help?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: 1997 Jeep Grand Cherokee Stalling

Best thing to check is your fuel filter. After sitting for a little while, it will allow fuel through it but when you put a demand on the system, it cant supply enough and will sputter and die. Its easy to replace and very inexpensive. If it continues after that, you will at least know it was eliminated and can move from there.

Posted on Aug 24, 2008

Ad
teezay731
  • 1 Answer

SOURCE: rough idle stalls at low rpm's

check your transmission fluid,the motor will stall when fluid is low

Posted on Mar 24, 2009

  • 15 Answers

SOURCE: 93 accord stalled while driving....

pull one of the plugs out leave the plug wire on it and rest it on something metal on the car and have someone try to turn it over.if no spark can be seen try changing your crankshaft sensor

Posted on Mar 25, 2009

dttech
  • 4803 Answers

SOURCE: I have a 93 mercury topaz 4cyl 2.3L that stalls

It sounds to me like you replaced everything but the most likely cause of a stall while driving...The crank sensor.

Posted on Oct 11, 2009

  • 94 Answers

SOURCE: 2004 Jeep Grand Cherokee. Keeps stalling, engine

P0505 means the whole Idle Control system, not only the IAM. Check all related sensors (i.e. crankshaft sensor). Check with a voltmeter direct at the connector of the IAM if you get any signal. Remove the IAM from the TB, connect him, let someone switch your ignition key to ON. The IAM need to drive in/out for a short time to find the right position. Hold the IAM near a hard part, that they cant drive out completely! If IAM works fine, check the fuel pressure, check and clean your TB ( if not done yet). If that doesn't work, come back again please

Posted on Oct 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

96 grand cherokee starts& runs fine but then it goes into pig mode & over fuels dumping black sout out of exhaust


1996 jeep grand cherokee stalling at lights or stop signs - Forums ...

www.cnet.com > Forums > Car Tech

CNETJun 11, 2015 - My jeep grand cherokee 1996 has started stalling when at lights, stop signs, in park or ... It starts and drives but after stoping at the stores and parking when I came out I ... Mechanic changed already crank sensor, distributer pick up, fuel pump, idle .... Symptoms like the Jeep running fine, then stalling without warning usually ... 97 Jeep Grand Cherokee Laredo keep dying upon ignition
Jun 11, 2015
1996 Jeep Grand Cherokee just stopped while driving.
Jun 10, 2015
More results from www.cnet.com
Missing: pig

Nov 23, 2015 | 1996 Jeep Grand Cherokee

1 Answer

2004 jeep grand cherokee laredo . when engines warm, i step on the gas it chokes and stalls, but then it restarts again


When you step on the gas pedal the engine commands are to give more fuel,so obvoiusly you have a fuel pressure problem,from a neede fuel filter or even a new pump or both

Nov 11, 2012 | 2004 Jeep Grand Cherokee

1 Answer

My jeep will stall when I start it up then once it warms up it will go away. After the truck is driven a while the shaking and stalling continues. What can it be? I have replace the spark plugs 3 weeks...


You will need a multipoint check on the engine.
start with the fuel, fuel filter, fuel pump, fuel injectors and the fuel lines. Fuel problems are heat dependant and wil show up in cold or warm condition. check calibration of pump.
Now check the ignition circuit of the engine. start with the plugs- now being new- check the HT wires, the HT coils, the triggers to the coils- the ignition system.
Also check the fault condition of the ECU.

Jun 17, 2011 | 2003 Jeep Grand Cherokee

3 Answers

Where is the fuel filter located. Have 1999 Grand Cherokee. Engine will start, but rough idle and stalls out.










b9c4b7b.jpg
Here is a picture of the fuel filter location. If replacing filter does not fix the problem, check fuel pump pressure.

Don't forget to rate this post!!

Jul 13, 2010 | 1999 Jeep Grand Cherokee

2 Answers

Stalling/cutting out problem


Check the fuel pump,Clean the fuel pump sound like not getting continue fuel to the engine.

Feb 04, 2010 | 1997 Jeep Grand Cherokee

1 Answer

Engine runs fine, no problem want's tempature is


I had a similar problem with a Ford Excursion, it turned out to be intake manifold gaskets. It would stall then start right up again, it ran fine during warm up. But, once fully warmed up it would stall at stop lights and stuff like that. I did get a check engine light, the code was lean condition. I don't know on a Jeep, sorry I can't be of more help.

Dec 17, 2009 | 1998 Jeep Grand Cherokee

1 Answer

93 jeep cherokee stalls on acceleration


sounds like it is not getting enough fuel. remove fuel filter to see if it is clogged. if no fuel to engine, when giving it gas it will stall out. if it is getting gas then the injectors may have dirt in them, use a good injector cleaner.

Nov 08, 2009 | 1993 Jeep Grand Cherokee

1 Answer

1997 Grand Cherokee stalls at speed and at stop signs


Mine does the same thing when the oxygen senor goes out... About every 70k miles. doesn't always turn on check engine light

Jan 17, 2009 | 1997 Jeep Grand Cherokee

1 Answer

STALLING


I had a similar problem. After changing just about every sensor under the hood, I finally fixed it by replacing the CCV valve and the vaccuum hose harness and all the hoses: http://jeep.off-road.com/jeep/article/articleDetail.jsp?id=257985 . It ran a little better and then I tightened down the throttlebody. That did the final trick. To be safe, I ended up changing the TB gasket. All cheap fixes after spending a few hundred dollars listening to Mighty Mopar Men.

Dec 01, 2008 | 2000 Jeep Grand Cherokee

Not finding what you are looking for?
1993 Jeep Grand Cherokee Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...