Question about 2005 Ford Focus

1 Answer

How do u fit altenator belt on a 1.6 2005 focus is there a adjuster

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 166 Answers

You need a special tool that only the dealer has there is no tenshioner

Posted on Sep 29, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 ford expedition. Does the altenator whistle when it goes out?


Spray same water on the belt to see if whistle goes out that means loose belt. 2nd remove belt and check shaft for any gaps in and out and up and down start for a minute to see if the squeaky noise cam from there.if is noise stop is your alternator bearings to Replace then fit the belt and adjust .

Sep 12, 2012 | Cars & Trucks

1 Answer

01 focus ztec..battery light comes on car runs the runs poorly then shuts off..let cool will start and run again for a while the repeats!


have you checked the fan/ serpentine belt to make sure that it isn't broke? if this just started happening, it is most likely the belt ( altenator and water pump run off the same belt)

Mar 04, 2011 | 2001 Ford Focus

1 Answer

How do u fiT a fan belt on a 55 plate ford focus


Loosen the adjustment bolt on the alternator, remove old belt, fit new one and stretch it slightly with the adjustment of the alternator until you have 2mm of deflection. Tighten up the bolt and take her for a run to charge the battery properly.

Jun 22, 2010 | 2005 Ford Focus

1 Answer

How to change altenator rib belt


there should be an idler pulley that also adjust the tension the tool usually used is a 3\8 or 1\2 ratchet

Jun 05, 2010 | 2000 Lexus ES 300

1 Answer

How to fit a belt on alternator on a ford focus 1.6 16v t reg car


go to a car service center isnt so expensive.if something goes wrong even damages to altenator or water pump or worst to the ac compressor or power steering pump can happen!

Apr 12, 2010 | 2000 Ford Focus

1 Answer

Battery light came on,and stirring became hard toturn.sterring


battery light will come on if there is a prob with your altenator or your battery...

firstly check if you still have a fanbelt, it may have come off and this will cause both of these problems and eventualy cause your car to overheat aswell

if there is a problem with the altenator seizing etc it may effect your power steering pump causeing steering to be hard to turn, observe if there is anything abnormal about the drive belt opperation (noise, vibration, spinning slowly, or appears buckled etc...) if so then you will need to remove the belt and check all the pulleys (prob start with the altenator)

Feb 10, 2010 | 2000 Ford Focus

1 Answer

Change moter alt belt keeps breaking


Hi the altenator belt? if it keeps snapping then your altenator is rather starting to seize up or its not fitted correctly, normally if its squeking its to loose.

Spin the altenator by hand and see what it sounds like, if its hard to turn or noisey that the fault.

hope this helps.

Jan 16, 2010 | 2000 Kia Sephia

1 Answer

Need diagram for sepentine belt on a 2000 ford focus with a zetec dohc motor


havent got a pen facility here this end ,but its not difficult to work out ,round bottom pulley going right side of pulley up to idler back round ac ,another idler then power steering and round altenator ,or was it ac to power steering then idler and on to altenator?? cant remember now ,quickest way is to look for one for sale on a forecourt then look interested and ask to lift teh bonnet

Sep 15, 2009 | 2000 Ford Focus

3 Answers

The axcillary belt needs replacing but it dont seem to have tension release when i loosen the belt ..yours sincerly jane fryer


Change the tensioner and the belt,,tensioner sizes up and its better to replace it,,it happened to me and had to cut the old belt,,,cost about $80

Apr 11, 2009 | 2001 Ford Focus

Not finding what you are looking for?
2005 Ford Focus Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...