Question about 1991 Jeep Cherokee Limited

Open Question

I have a 4x4 jeep cherokie its a 91..whene u put it in 4wheel drive front want lock in.is there a way to manueley lock in?

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I put my 1997 mits montareo into 4wheel drive.


Try putting it into neutral before trying to put it in 4x4. Check the front center hubs, sometimes you havto lock the wheels. It would look like a knob.

Sep 07, 2014 | Cars & Trucks

1 Answer

Will not shift into 4wheel drive


On these issue,there are few solved help links for troubleshooting the issue easily.-------

Click the link below:---
No 4x4 light on dash?

http://repairhelpcenter.blogspot.com/2011/12/no-4x4-light-on-dash.html

-----------
4X4 Truck makes roaring noise in the front end?

http://schematicsdiagram.blogspot.com/2012/01/4x4-truck-makes-roaring-noise-in-front.html

-------------
Car will not go into 4WD high or 4WD low?


http://schematicsdiagram.blogspot.com/2011/12/car-will-not-go-into-4wd-high-or-4wd.html

--------------
No 4x4 light on dash?

http://repairhelpcenter.blogspot.com/2011/12/no-4x4-light-on-dash.html

------------
4 wheel drive system will not disengage?

http://technoanswers.blogspot.com/2012/01/4-wheel-drive-system-will-not-disengage.html

----------
4WD light is flashing and beeping? NO 4WD high?

http://schematicsdiagram.blogspot.in/2012/02/4wd-light-is-flashing-and-beeping-no.html

----------
2002 Jeep Wrangler: 4WD Idiot Light is ON?

http://technoanswers.blogspot.in/2012/06/2002-jeep-wrangler-4wd-idiot-light-is.html

----------

Traction control switch will not engage on 4WD High or Low

http://whoisbyme.blogspot.com/2012/10/traction-control-switch-will-not-engage.html

-----------

4WD light flashing and 4WD will engage after few minutes

http://repairhelpcenter.blogspot.com/2012/10/4wd-light-flashing-and-4wd-will-engage.html

------------
2008 Toyota Tundra: 4x4 Wheel Drive Light is Flashing?

http://technoanswers.blogspot.in/2012/05/2008-toyota-tundra-4x4-wheel-drive.html

----------
4x4 front differential will not engage the axle on ford?

http://technoanswers.blogspot.in/2012/02/4x4-front-differential-will-not-engage.html

-------
4x4 will not engage on Ford F150? http://technoanswers.blogspot.in/2012/02/4x4-will-not-engage-on-ford-f150.html

-------------
Dodge Ram 4x4 light keeps flashing 4X4 LOW LIGHT IS FLASHING ON DASH

http://technoanswers.blogspot.in/2012/09/dodge-ram-4x4-light-keeps-flashing.html

----------
Ford 4x4 front wheels will not engage?

http://technoanswers.blogspot.in/2012/02/ford-4x4-front-wheels-will-not-engage.html

-------------

These details will help.

Thanks.

Nov 25, 2012 | 1996 Jeep Grand Cherokee

1 Answer

I have a 1998 explorer and the 4wheel drive will switch on like it should and the lights do not blink or anything but I can tell the rear end doea lock in low but never any power to front axle in any...


On these issue,there are few solved help links for troubleshooting the issue easily.-------

Click the link below:---
No 4x4 light on dash?

http://repairhelpcenter.blogspot.com/2011/12/no-4x4-light-on-dash.html

-----------
4X4 Truck makes roaring noise in the front end?

http://schematicsdiagram.blogspot.com/2012/01/4x4-truck-makes-roaring-noise-in-front.html

-------------
Car will not go into 4WD high or 4WD low?


http://schematicsdiagram.blogspot.com/2011/12/car-will-not-go-into-4wd-high-or-4wd.html

--------------
No 4x4 light on dash?

http://repairhelpcenter.blogspot.com/2011/12/no-4x4-light-on-dash.html

------------
4 wheel drive system will not disengage?

http://technoanswers.blogspot.com/2012/01/4-wheel-drive-system-will-not-disengage.html

----------
4WD light is flashing and beeping? NO 4WD high?

http://schematicsdiagram.blogspot.in/2012/02/4wd-light-is-flashing-and-beeping-no.html

----------
2002 Jeep Wrangler: 4WD Idiot Light is ON?

http://technoanswers.blogspot.in/2012/06/2002-jeep-wrangler-4wd-idiot-light-is.html

----------

Traction control switch will not engage on 4WD High or Low

http://whoisbyme.blogspot.com/2012/10/traction-control-switch-will-not-engage.html

-----------

4WD light flashing and 4WD will engage after few minutes

http://repairhelpcenter.blogspot.com/2012/10/4wd-light-flashing-and-4wd-will-engage.html

------------
2008 Toyota Tundra: 4x4 Wheel Drive Light is Flashing?

http://technoanswers.blogspot.in/2012/05/2008-toyota-tundra-4x4-wheel-drive.html

----------
4x4 front differential will not engage the axle on ford?

http://technoanswers.blogspot.in/2012/02/4x4-front-differential-will-not-engage.html

-------
4x4 will not engage on Ford F150? http://technoanswers.blogspot.in/2012/02/4x4-will-not-engage-on-ford-f150.html

-------------
Dodge Ram 4x4 light keeps flashing 4X4 LOW LIGHT IS FLASHING ON DASH

http://technoanswers.blogspot.in/2012/09/dodge-ram-4x4-light-keeps-flashing.html

----------
Ford 4x4 front wheels will not engage?

http://technoanswers.blogspot.in/2012/02/ford-4x4-front-wheels-will-not-engage.html

-------------

These details will help.

Thanks.

Nov 23, 2012 | Cars & Trucks

1 Answer

2002 jeep wont stay in 4wheel drive low


Your JEEP is only part time 4WHEEL DRIVE as you can't DRIVE on the STREET with it, its NORMAL and nothing is WRONG.


Part-Time and Full-Time 4x4 systems...

A part-time 4x4 system called Commandtrac is in all Wranglers together with low-end Cherokees and Liberties. A part-time 4x4 system locks the front and rear driveshafts together inside the transfer case so they drive the front and rear axles together in lock step. Because they are locked together, the front and rear tires must rotate at the exact same rpms. However, the front tires must rotate faster than the rear tires during any turn so a part-time system fights that... which makes a part-time system inappropriate on a paved road because the high level of traction on a paved road prevents the tires from slipping which would otherwise allow the front and rear tires to grudgingly rotate at different rpms. Offroad this is not a problem since the poor traction of an offroad trail allows the tires to slip as needed. But when they try to slip/rotate at different rpms on a high-traction surface, the entire drivetrain is stressed which is bad for it. This problem is called "wind-up".

In reality however, the front and rear axles really don't even turn exactly the same RPMs when you're in 4wd so you still get "wind-up" if you drove in 4wd on the street even if you drove in a perfectly straight line. Why? Because 1) you can't drive in a perfectly straight line and 2) the front and rear axle ratios are usually .01 different from each other. Like a 3.73 and 3.74, 4.10/4.11, etc.. Why the .01 ratio difference between the front and rear axles? Because the front and rear axles usually have different ring gear diameters which makes it nearly impossible for the gear manufacturers to economically make the front and rear axle ratios exactly the same. And no, they are not made .01 different on purpose to make the front or rear pull more when in 4wd, that is an old wive's tale.

Finally, a full-time 4x4 system like Selectrac is available on Grand Cherokees, Cherokees and Libertys couples the front and rear axles together, but they are not mechanically locked together like they are with a part-time 4wd system. The front-to-rear axle coupling can be done via either a differential like the Selectrac system uses (just just like what is in the center of an "open" axle) or a fluid (viscous) coupler. The benefit to a full-time 4wd system is that because the front and rear axles are not mechanically locked together, the front and rear tires/axles can rotate at different rpms from each other. This allows a vehicle with a full-time 4wd system to drive in 4wd "full time" on a paved road without problem since there is no 'wind-up' problem to harm the drivetrain. You cannot get a full-time 4x4 system in a Wrangler from the factory.



HOPE THIS HELPS.

Sep 08, 2012 | 2002 Jeep Wrangler

1 Answer

1995 grand cherokee rouring noise from front driver side when excelerating


Have the front CV joints inspected and lubricated if applicable. Most shops should inspect this for free. Hope this helps.

Dec 23, 2011 | 1995 Jeep Grand Cherokee

2 Answers

How can i use the 4 x 4 in my 2000 grand cherokee laredo (6 cyl) i dont have the owners manual and i dont know how to use my 4x4 on snow or something like that


With the Jeep in park, move the left shifter to 4 wheel drive. Proceed to put right shifter into drive, proceed to drive. Only use 4wheel drive when neccessary...ie...snow, mud, use 4 wheel lo in steep incline or when really bogged down.

Hope this helps

Jul 26, 2010 | 2000 Jeep Grand Cherokee

1 Answer

4wheel drive on 2004 jeep liberty shows 4 wheel high is on when lever is in 2 wheel high


this problem lyes within the faulty fuse for 4x4 or 2wd, to locate the fuses for these, they are under the hood in front of the battery labelled fusebox.

Jan 05, 2010 | 2004 Jeep Liberty

1 Answer

I have a 94 s10 4x4 when i put it in 4wd u can hear it clunk clunk trying to engage but front wheels wont pull


? are they manual locking hubs where you have to get out and lock them? if not you may have a vacuum leak to your actuaters .my spelling is terrible.another ? is the clunking sound only when you put in 4wheel or is it in 2 wheel also.if so you also may have a bad universal joint either in the front drive axle or the rear drive axle.

Nov 28, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

Auto locks for front 4x4 2007 f150 cant stop grinding noise


Are you under warranty? Make it the dealers problem if its eligible.

If the front hubs are grinding regardless of being in 2wheel or 4wheel drive it can be the hub bearings which turn regardless. If it grinds only when in 4x4 then the wheel shafts or differential or front driveshaft or transfer case is making the noise because all of these parts move when in 4wheel drive.

Nov 09, 2009 | Ford F-150 Cars & Trucks

2 Answers

4x4 not working 0n 91 chevy pickup k 1500


http://www.4x4posi-lok.ca/ this is a website that sells cable style actuators for the chevy pickups. this replaces the thermal actuator with a push pull cable they also sell permanant locks but be forewarned a permanant lock will hurt fuel economy a little. a cable also lets you put your transfer case into 4 LOW and lets you leave the axle disconnected if you need the extra power but do not need the 4wheel drive to work.

May 19, 2009 | 1991 Chevrolet K1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...