Question about 2004 Honda Accord

1 Answer

Check engine light

My check engine sign stays on and then it blinks, and on top of that when I cut my a/c on the idals drop and the car cuts off is this a sensor promblem because I've just service my car

Posted by on

1 Answer

It is a computer code issue to start, as your check eng light came on. Now you need to put a scan tool on it and repair code related issues first. Idle may drop with A/C load but as you know the veh should run okey. I wonder about the recent work done and if some of the issues where not there before, you need answers not a new expense

Posted on Sep 28, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 jeep Cherokee 2.5crd engine cuts after removing foot from accelerator pedal . no warning lights come on. let the vehicle stand for 10 minutes then it starts up again. can it be injectors or ignition...


check all fuses.
cuts out hot or cold engine.????????
if it wont start and car gets 60k tuneup (?)
then connect scan tool and crank for 5 seconds.
see if you get scan DTC errors , cranking (release key) see em?
stalls are caused by over 50 reasons. guessing is impossible or very expensive.
enter: Diagnosis,
you take measurements, and find the failure path then work that path like bird dog.
2.5L 4cyl engine. I just sold min last week. with 5sp M/T
cuts out, does that mean the engine stalls?
we need to know what it really does.
1: stalls (engine rpm drops to 0 RPM)
2: engine rpm drops to 300rpm and shakes.
3: power loss from engine?
4: only stalls at stop signs...?
5: bogs all them time, same as #3
6: engine misfires (shake)
7: bogs only on throttle TIP-IN then recovers.
8: bogs only on hills.

i wait.
when dead, is spark lost?

Aug 21, 2013 | Jeep Liberty Cars & Trucks

2 Answers

1996 3.8l firebird stalling


check alternator,check battery connection,fuel filter,air filter,check coils and module,spark plugs,last thing crankshaft sensor.

Feb 12, 2013 | 1996 Pontiac Firebird

1 Answer

How do i turn off dash warning check engine light


cutting wires will not stop the engine light in fact you will never get it to off by cutting the wires as its not completing the circuit

Feb 01, 2012 | Cars & Trucks

1 Answer

Transmission light blinks numerous times then stays on and when accelerating engine sounds like it will cut off. I just bought this vehicle used. It sputters like it might have bad gas but it doesn't...


The blinking transmission light is trying to tell you there is a fault in your transmission control system. If the check engine light is on, there may be engine problems causing the transmission problems. The first thing that should be done is to scan your computer network for possible fault codes.

Sep 04, 2011 | 2004 Dodge Stratus

1 Answer

Dash lights are staying on/van cuts off after start


Vheck for a dashboard groung wire. It should be aon the passenger end screwew to the dash frame and the body ofthe vehicle. AND! There is a ground strap from the engine to the body. It is on a bolt on the top of the engine in a spot the engine is nearest to the body. Make sure all grounds are cleN AND SECURE, GOOD LUCK,_NED_

Oct 19, 2009 | 2002 Chrysler Town & Country

1 Answer

Car starts and engine running but then cuts out the yellow motor sign on the dashboard stays on


that dash ligfht is called the check engine light, this means a fault has occured in the electronic engine control system, there are many faults that trigger this light, well over 200, to find out what the problem is you will need to have the system tested for the trouble code that is stored in the computer, anytime the check engine light is on there is a code set in memory

Oct 02, 2009 | 2005 Hyundai Santa Fe

1 Answer

Check engine light stays on at all time seems to cut out fuel when you want to go fast


There is a fuel cutoff set by the cars computer that limits the RPM's of the engine to prevent engine damage. If its cutting out below say 5000 rpm, then theres a problem. The check engine light being on steady means one of the sensors detected something the computer doesnt like. Get the car to a good mechanic to scan the light and retrieve the trouble code. That will tell you what the problem is. Some auto parts stores, like Auto Zone, will scan the light for free.

May 24, 2009 | 2000 Volkswagen Jetta TDI

1 Answer

BMW 1988 325 Dashboard orange check light stays on while driving.


The orange light is probably the pads wear indicator showing that the pads are worn out and the cutting out probably you need your car serviced and tune.
Cheers

Apr 20, 2009 | 1988 BMW 3 Series

Not finding what you are looking for?
2004 Honda Accord Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...