Question about 2007 Mazda CX-7 Grand Touring

1 Answer

I have a small oil leak on a cx7 mazda 2007 it comming from a small round part oppisite from the battery on the passanger side above the tire hub its conneted to where you put the oil in the carand next to the serpentine belts side it has a black cap and silver canister type bottom

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 7,353 Answers

Power steering fluid??????

Posted on Sep 28, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Shakes at 65mph had tires balanced also I cant feel it in the steering wheel it feels like it's coming from the back passanger side or middle


put tires from rear up front and front to rear and see if tires cause a shake also make sure no debris on hub so rim sits flush if no change and still vibration check drive shaft and u joints

Jul 27, 2016 | 2003 Chevrolet Tahoe

1 Answer

Mazda CX7 front bumper removal


start with the small screws on the bottom, then take off the splash shields running in front of the tires. open the hood and pop the center out of the two big clips by the headlamps, the two big Philips screws on the rad support and finally get someone to help you pull it off. Slowly start from one side and make sure to unplug all of the lights before any tension gets on them. have some carboard or a tire ready to place it on without scratching it

Jul 13, 2013 | Mazda CX-7 Cars & Trucks

1 Answer

Replacing struts on Mazda CX7


There are 3 Nuts inside the Engine Compartment, There is one Bolt on the Lower Arm and you have to remove the ABS and Torsion Rod. You need a Spring Compressor to do this job.

Apr 15, 2013 | 2007 Mazda CX-7

1 Answer

2000 Mazda Protege 1.6L big oil leak passanger side. No oil in timing belt area. All over firewall & steering rack. What is leaking?


probably gaskets are not sealed properly you have to redo it or try and cleaned it remove all the oil that sorrounds the engine and try to seal with a high temp silicon

Jan 17, 2013 | Mazda 323 Cars & Trucks

1 Answer

I have 131,000 miles on my 2007 Mazda CX7. Runs great, timing chain/belt has never been changed nor recommended to me by dealer (had fallout at 109,000) & just oil changes since. Preparing for 14 hour...


it should have be changed at about 750000 mi ,belt...and for the most part look things over your self even before u go check fluids, serp..belt, check for cracks ..proper air in tires ...and so on

Dec 15, 2010 | 2007 Mazda CX-7 Grand Touring

1 Answer

I have a major oil leak on my 2000 mazda protege on the passanger front side


This is a leak from the OIL SUMP tank and it will need replacing you local garage can do it or you can attempt it yourself

Always dispose of old oil appropriately.

Jun 22, 2010 | 2000 Mazda Protege

2 Answers

How do I change the bulb in the low beam headlight in my 2007 Mazda CX7?


Removing the bulb in a CX7 is a real PITA. If replacing the right bulb, turn the steering wheel all the way to the right, or do the opposite for the left side. (or you can opt to remove the entire wheel on the corresponding side) You'll need to remove 3-4 of the fender well clips with a phillips screwdriver being careful not to break them. Once the screws are removed, pry back the wheel well cover to access the back of the headlamp to change the bulb.

Nov 04, 2009 | 2007 Mazda CX-7 Grand Touring

1 Answer

'94 Mazda MX-6 leaking antifreeze from passanger side engine


Don't drive while it is over heating, cast aluminum doesn't like heat and will warp. Should take it to a repair shop if your not sure what is wrong with your vehicle. Your problem sound like the water pump is shot you may have all ready caused major damage if you have drove your vehicle for a while.

May 11, 2009 | 1994 Mazda MX-6

Not finding what you are looking for?
2007 Mazda CX-7 Grand Touring Logo

928 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...