Question about 2000 Mercedes-Benz M-Class

1 Answer

Ive just changed a fuel line on my 2000 ml 270 but now it wont start. Is it self bleedig? THanks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 784 Answers

There is a Hex screw on the Fuel distributor to do the bleeding if you want. When I changed mine, I had to crank up to 2 minutes continuously to have fuel filled up the line to have a start. Maybe you don't crank up long enough.

Posted on Oct 04, 2009

Testimonial: "Thanks, got it going by forcing fuel through the lines. "

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I've recently changed my inlet manifold on my Mercedes ml 270 2002 model since then I have not been able to get the car to run it will start but then seconds later cuts out. So I then changed two of the...


dont du any more--nevr evr asume the cure til u kno--bring it to a private mechanic that will du a datastream to pinpoint the issue--its a scan that shows whats occurin in the computer system--a code reader from a partstore wont du it!--also he can discover if its a mechanical problem also--b patient -if he gives knowledge for free-most likely he safe

Jun 27, 2014 | Cars & Trucks

1 Answer

My mx3 ower sucks petrol wen its hot engin and it dosnt want to start after haw to lew it for 30min. rpm is going up till 2000 and mor wail im driving.


pull your vacuum line off the fuel pressure regulator if it has gas in it its bad and if is bad wasting gas and flooding engine i would check that i would guess that is it ,if it is you'll need to change your oil i hope this helps you ive done so much research on these cars because i too have one and have had the issue my self ,good luck

Mar 06, 2011 | 1994 Mazda MX-3

1 Answer

I have vw type 25 diesel 1600 cc .it takes ages to start the fuel seems to **** back into the tank so ive got to keep trying to start the engine till the fuel gets ther


I would try changing your fuel filter. Inspect the fuel lines for leaks. Air getting in the line would cause fuel to flow back into the tank.
I really suspect that the long cranking time may be a problem not with the fuel system but with the glow plugs, You probably need to replace the plugs as they are not pre-heating the combustion chamber properly to allow ignition of the diesel fuel. To start a diesel motor with out glow plugs you have to crank the motor until enough heat is generated to ignite the fuel. Glow plugs are not very expensive and fairly easy to change your self.

Dec 12, 2010 | 1986 Volkswagen Wagon Camper

1 Answer

Error code P2203 on ml 270 cdi 04/2000


Component Y3/6N3 speed sensor 3 is faulty,That is a transmission code...the trans speed sensors are MADE into a printed circuit board that connects to the valve body...MB part number is 140-270-08-61.. LIST price in the USA is $225. TAKES about 1.5-2 hrs to install

Jun 12, 2009 | 2006 Mercedes-Benz ML-Class

3 Answers

My Mercedes ML 270 cdi ABS etc lights and gearbox.


  • you need a Brake safety switch replaced.This is located behind you brake pedal.it's a common problem. The warning lights will reset after a few engine starts.

May 18, 2009 | 2002 Mercedes-Benz M-Class

2 Answers

2000 chevy cavalier shut off while driving on the freeway , got it to start again drove home now engine turns over but wont start .


oh ok this is simple u need to put a new fuel filter on there it has a bad fuel filter on there try that out if not it is the fuel pump but try the fuel filter after that and the fuel pump if it still has a problem it is the gauge and try to put mid grade cause it causes less break downs for your car cause it doesnt mess up ur fuel filter

Apr 18, 2009 | 2000 Chevrolet Cavalier

1 Answer

2000 Chevy Blazer Cranks but wont start...


What about the fuel filter????? Have you changed it out??? If you can spary something like a started fluid, that means it is a fuel problem. My last check, it has to be above 50-psi on the fuel pressure to make it run right. I had 35psi, but whould not get over 30mph or down hill maybe 45mph. Check both filter & pressure, but check pressure with a New fule filter!!!!

Jan 18, 2009 | 2000 Chevrolet Blazer

Not finding what you are looking for?
2000 Mercedes-Benz M-Class Logo

Related Topics:

289 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75051 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...