Question about 1983 Chevrolet Caprice

Open Question

Need the belt diagram for a 1983 chevrolet caprice classic

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Ad
  • 1 Answer

SOURCE: i need a serpentine belt assembly guide or diagram for a 2006 3.5 liter v6 chevrolet impala

Diagram 9-5 on this page:
http://www.daycoproducts.com/daycoweb.nsf/Serp%20Rout%20Guide%20Illus.pdf

Posted on Nov 14, 2009

  • 14036 Answers

SOURCE: I need the serpentine belt diagram for a chevy Express Van

DRIVE BELT DECAL SHOULD BE UNDER THE HOOD.OR YOU CAN GO TO DEALERSHIP GET ONE AUTO ZONE OR ADVANCE AUTO PARTS CAN GET YOU ONE.OR YOU CAN BUY A HAYNES REPAIR MANUAL IT HAS BELT DIAGRAM.

Posted on Mar 10, 2010

johnjohn2
  • 5763 Answers

SOURCE: what is the 94 Chevy Caprice Classic wiper arm

heres a wiper linkage asm diagram, the wiper washers are on the hood or on the cover to deck,then the hose runs through the wiper arm to a nozzle, if you remove the arms you can lift cover enough to look at the hose to washer connection,also check hose to arm they often break there good luck.2d8c418.gif

Posted on Mar 30, 2010

  • 1915 Answers

SOURCE: I need the spark plug wiring diagram for a 1994

firing order of a small block chevy engine is 1-8-4-3-6-5-7-2, clockwise-#1 on the front driver side (1,3,5,7 on driver sied, 2,4,6,8 on passenger side)-#1 should be about the 7 o'clock position, but to be certain, rotate the crank (loclkwise) until the 0 degree mark on the balancer lines up with the scale-look at the installed rotor-it is either pointed at the 7 o'clock position or the o'clock position-with the plug in #1 removed, rotate it again to see if the cylinder pushes air (compression)-that is where #1 plug wire belongs. just plug them in in order (18436572)-you will still have to time it to start, they usually need to be set a few degrees before top dead center.

Posted on Feb 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1991 Caprice Classic. Where can I get a serpentine belt diagram?


There will be a label in the engine compartment with a belt diagram.

May 13, 2015 | Chevrolet Cars & Trucks

2 Answers

Chevrolet caprice clasic brake line diagram-1994


do you have any experience bending brake lines? Can buy some lines pre bent if steel.

Jan 27, 2012 | 1994 Chevrolet Caprice Classic

1 Answer

I need diagram to replace serpentine belt for 5.7 engine


Below is the diagram you requested. Best of Luck!
Greg

1995 Chevrolet Caprice 5.7L

greg_margo_15.jpg

Jul 05, 2011 | 1995 Chevrolet Caprice Classic

1 Answer

My a/c compresser clutch went out on my 1994 chevy caprice classic with the 350 5.7l engine and i need to bypass it what size belt and whqt is the wiring diagram


Hi!!
The belt is already available at any auto parts store, the inside length is 36.81 in., the outside circumference is 37.47 in. The installation routing is exactly the same as the original just bypassing the AC compressor. The belt part # 5040368 on the Dayco brand.
Regarding the compressor clutch, all you need to do is unplug the electrical connector at the clutch.
Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa.

Dec 13, 2010 | 1994 Chevrolet Caprice Classic

1 Answer

How do you route a serpentine belt on a 1995 Chevrolet Caprice Classic without AC?


Buy proper belt for application.look under hood for dirgram.
I didn't think Caprice had a serpentine belt.

Sep 20, 2010 | 1995 Chevrolet Caprice

1 Answer

Firing order 1990 chev caprice, doesn't start


You have foru engine sizes there, check the next diagrams...


1990 Chevrolet Caprice 4.3 liter V-6 VIN "Z"

018b8cd.gif


1990 Chevrolet Caprice 5.0 liter V-8 (305)

d688e86.gif


1990 Chevrolet Caprice 5.0 liter V-8 (307)

1a7365e.gif


1990 Chevrolet Caprice Classic 5.7 liter V-8 VIN "7"

e7f6dda.gif


Hope helps with this (remember rated this).

Jul 26, 2010 | 1990 Chevrolet Caprice

1 Answer

1983 caprice classic


does the oil leak for the vaulve covers ? If so they need replaced.

Dec 28, 2008 | 1983 Chevrolet Caprice

2 Answers

Power windows


go to alldata.com and just register and ull be able to get it true themhope this is helpfull

Nov 18, 2008 | 1983 Chevrolet Caprice

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...