Question about 1998 Ford Windstar

1 Answer

How do i CAHNGE THE FUEL PUMP - 1998 Ford Windstar

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,776 Answers

Visit the autozone.com website and register your car information. It doesn't cost anything and you will get access to an online repair manual for your car. The steps for inspecting and replacing the fuel pump can be found there. The manual is a very nice resource that I think you will find helpful. Hope so anyway and best wishes.

Posted on Sep 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel filter location


it should be located on the driverside Chasis rail just below drivers door area . it may have a metal shield protecting it. you will need special disconnect tools to cahnge. wear goggles to protect your eyes the fuel line will be presurized and can squirt fuel

Dec 22, 2011 | 1999 Ford Expedition

1 Answer

1999 chevy tracker, no power, can't get over 50 mph. Changed fuel filter but no cahnge


I assume you have already checked your air filter and air inlet for clogging. Another simple diagnostic is to sniff the exhaust when the engine is cold. If it smells very dirty or like unburned gasoline, you either have too rich a mixture or ignition problems.

If that is not the issue, verify that your fuel system has adequate pressure, and that it holds pressure when the engine is accelerated. Most fuel injection systems have a Schrader valve somewhere under the hood for this purpose, and for safely releasing fuel pressure for service. You'll need to get a pressure gauge designed for this purpose - many auto parts stores have some sort of tool deposit/loan program so you don't have to buy it outright. Inadequate fuel pressure can be due to a faulty pressure regulator, failing fuel pump, dented or kinked fuel line, or clogged fuel pump inlet screen.
Another possible cause for poor high-speed performance is a slipping torque converter. However, there will be a noticeable difference between engine acceleration and vehicle acceleration in this case (engine RPM will jump, but the car will crawl).

Oct 01, 2011 | 1999 Chevrolet Tracker

1 Answer

I have 2006 Kia Sportage. I have been encountering hard start.


There is a check valve under the vehicle on passengers side of vehicle,near the axle,this is most likely the problem,it is allowing the fuel to drain back in the tank.This part is only available online,or at the Kia dealer.I hope this was helpful,and if so,please rate,thank you.

Jul 18, 2010 | 2006 Kia Sportage

1 Answer

I have a 1994 ford escort 1.9L i'm having trouble finding a cure. Trouble code 172 and a complete loss of power. I know 172 is lean mix but what is the common issue associated with this code and what needs...


I would check and clean the MAF sensor, check fuel pressure, and check fuel pressure regulator. be sure to run fuel pressure test with the regulator hook up and disconnected, if pressure is low cahnge fuel filter and retest, if still low may need to replace fuel pump. Also check the injectors to see that they spray a full cone of fuel. Hope this helps, let me know.

Jul 04, 2010 | 1994 Ford Escort

1 Answer

I am still having problems with my 2003 Hyundai Elantra making backfiring noises. I just had a fuel injection cleaning that cost nearly $90 performed and the problem is still there. Some of you have said...


Backfiring is caused by timing , bent or burnt valves. If the timing belt was replaced but not put on correctly, you will have this problem. The marks MUST be aligned correctly.

Aug 05, 2009 | Hyundai Motor 2003 Elantra

1 Answer

How to cahnge a fuel filter in a 2002 envoy


  1. Remove the fuel pump relay from the junction box
  2. Crank the engine.
  3. Allow the engine to start and stall.
  4. Crank the engine for an additional 3 seconds to ensure the relief of any remaining fuel pressure.
  5. Disconnect the negative battery cable in order to avoid re-pressurizing the fuel system.
  6. Install the fuel pump relay to the junction box .
  7. Tighten the fuel filler cap.

Jun 17, 2009 | 2002 GMC Envoy

1 Answer

Fuel pump problem


what do you want to know. i cahnge a lot of these, its common, if needs changing the tank has to come off. a meduim job, get everything from, drop a little then unplug, you get trouble with rusty jubilee clips and putting the filler kneck back on, get a mate to help, hope its low on fuel.

Jun 16, 2009 | 1997 Land Rover Discovery

2 Answers

1997 plymouth neon high line expresso


Have you had the fuel pressure checked? Fuel filter changed?

Oct 05, 2008 | 1997 Dodge Neon

Not finding what you are looking for?
1998 Ford Windstar Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...