Question about 1995 Chevrolet Beretta
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
These 4.3L W motors are common for fuel leaking inside the plenum causing them to run rough and smell like raw fuel. The fuel pressure regulator leaks internally, also the injector spider leaks and the two fuel lines feeding the fuel to the spider. You have to remove the plenum and look for the clean spot. Where the fuel leaks it cleans the oil off. Before you try this check your EGR valve. The EGR valves on these get stuck open with carbon and cause a rough idle. Remove it and look for the plunger it is a small round piece that you can push in and out, make sure it closes fully. You can also clean it with carb clean and they make a replacement gasket with a screen in it to keep chunks out of it. Start with the EGR because it is easier. The parts for under the plenum are available at most any parts store. If you have any problems just ask, and if you can not find the parts I will give you part numbers. Let me know what you find I will be back tomorrow.
Posted on Jan 07, 2009
Check your o2 sensor voltage, those trucks are real bad for o2 sensors, and yes if one sensor is reading 0mv, the others will start to drop out, and the vehicle will run very, rough. You also may check fuel system pressure, should be almost 60p.s.i. If its alot lower, Id be looking into a fuel pump. If that vehicle is drive-by-wire (no throttle cable), the throttle bodies get very dirty and cause that concern also. Id start by having the vehicle scantested.
Posted on Feb 07, 2009
i would have it looked at. sounds like a blown head gasket. if so be careful when you start it. bump it a couple of times and see if it feels like it doesnt want to turn over. if you try to start it and the gaskets have leaked onto the piston it can blow the motor up.
Posted on Jan 13, 2010
Tips for a great answer:
Feb 05, 2016 | Ford Cars & Trucks
Oct 03, 2014 | 2002 Mazda Tribute
Jun 04, 2014 | 1996 Subaru Legacy
Jan 03, 2014 | 2004 Ford Taurus
Mar 28, 2017 | Cars & Trucks
Aug 06, 2009 | 1997 Volkswagen Golf
Jun 04, 2009 | 1997 Mitsubishi Galant
Dec 23, 2008 | 1989 Chevrolet Camaro
Apr 28, 2017 | 1995 Chevrolet Beretta
30 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: