Question about 2001 GMC Yukon XL

Open Question

I have a 2001 gmc yukon need to replace some speakers, where can i get them at?

Posted by on

  • Eabi Shaji May 11, 2010

    Could you let me know the name and technical specification of the audio equipment used in your Yukon?

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

rockitman187
  • 2559 Answers

SOURCE: Thermostat for 2001 GMC Yukon XL

Not true,Although,it is located in the pump,You don't need to replace the pump if the thermostat is replace.See pix
338a358.jpg56f157c.jpg

Posted on Jan 08, 2009

  • 196 Answers

SOURCE: light replacement

Just reach behind the bumper and grab the light/electrical harness and twist is either way and then it should pull out put in a new 194 bulb and you are set.

Posted on Jan 08, 2009

  • 1596 Answers

SOURCE: Oil Pan Gasket Replacement - How to - GMC Yukon 2000








Removal Procedure

Important: The original oil pan gasket is retained and aligned to the oil pan by rivets. When installing a new gasket, it is not necessary to install new rivets.
DO NOT reuse the oil pan gasket. When installing the oil pan, install a NEW oil pan gasket.

Caution: Refer to Battery Disconnect Caution in Service Precautions.

  • Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure
  • Remove the front differential if equipped with four wheel drive. Refer to Differential Carrier Assembly Replacement in Front Axle.
  • Remove the under body shield from the vehicle
  • Remove the oil pan underbody shield.
  • Remove the cross brace if equipped.
  • Drain the engine oil and remove the engine oil filter. Refer to Engine Oil and Oil Filter Change
  • Remove the lower transmission-to-oil pan bolts
  • Disconnect the oil level sensor electrical connector.
  • Remove two front wiring harness retainer bolts.


10. Remove the engine wiring harness retainer bolts from the engine oil pan.
11. Remove the engine oil cooler pipe to oil pan bolt.
12. Remove the transmission oil cooler pipe retainer and the bolt from the oil pan.
13. Remove the starter motor. Refer to Starter Motor Replacement.
14. Remove the left closeout cover and bolt.
15. Remove the engine oil pan. Refer to Oil Pan Removal.

Installation Procedure

Important: The alignment of the structural oil pan is critical. The rear bolt hole locations of the oil pan provide mounting points for the transmission bellhousing. To ensure the rigidity of the powertrain and correct transmission alignment, it is important that the rear of the block and the rear of the oil pan must NEVER protrude beyond the engine block and transmission bellhousing plane.

Will Send Remainder in another this place dont take kindly to larg files Your Email Address would realy be Better Then I could send Pictures Also up to YOU

Posted on Jan 27, 2009

SOURCE: u-joint repalcement for 2001 yukon xl

Mark your drive shaft coincidenly with the rear axle and tranny. Remove drive shaft. Press out the old u joints and press in the new. You will need a torch for heat and a lot of patience. Have fun!

Posted on Jun 20, 2009

  • 27 Answers

SOURCE: problems with acceleration - 2001 Yukon

Most likely it is due t5o dirty fuel injectors or bad mass air flow sensor

Posted on Jul 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change cam sensor 2001 gmc yukon


how to change cam sensor gmc yukon model 2001

Jul 18, 2012 | 2001 GMC Yukon XL

1 Answer

Adjust Airconditioner belt tension on 2001 GMC Yukon


Some of these didnt have a tensioner, if yours does it will be spring loaded at all times, but some have no tensioner and the belt has to be rolled onto the pulleys by turning the engine over by hand.. If this is your style the belt is. One time install deal if you take it off you need to replace it!!

Jun 23, 2012 | 2001 GMC Yukon

1 Answer

I have A 2001 gmc yukon 1500 the rpm go up and down


The idle spped control needs replacing and I would change the plugs & wires as well if very old

Jun 30, 2010 | 2001 GMC Yukon

1 Answer

2001 GMC Yukon XL


YOU CAN GO DEALERSHIP OR THE SALVAGE YARD PROBABLY HAVE A WASHER FLUID TANK AND HOSES IN GOOD SHAPE.

Mar 23, 2010 | 2001 GMC Yukon XL

1 Answer

Replace door speaker


you will have to remove most likely the door panel and your arm rest to be able to get at the speaker and remove the cover for the speaker ...hope this was help ful .......

Jan 03, 2010 | 2001 GMC Yukon XL

1 Answer

I need color coming from car audio speakers


check speaker's . they run same color all the way on most

May 24, 2009 | 2001 GMC Yukon

1 Answer

Replacing horn need location of it on 2001 gmc yukon


It should be in front of the radiator.

Mar 30, 2009 | 2001 GMC Yukon XL

1 Answer

U-joint repalcement for 2001 yukon xl


Mark your drive shaft coincidenly with the rear axle and tranny. Remove drive shaft. Press out the old u joints and press in the new. You will need a torch for heat and a lot of patience. Have fun!

Jan 17, 2009 | 2001 GMC Yukon XL

1 Answer

Thermostat for 2001 GMC Yukon XL


Not true,Although,it is located in the pump,You don't need to replace the pump if the thermostat is replace.See pix
338a358.jpg56f157c.jpg

Jan 08, 2009 | 2001 GMC Yukon

Not finding what you are looking for?
2001 GMC Yukon XL Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...