Question about 1993 Honda Accord

1 Answer

Hard to start and do not stabilize on iddle rev. less than 1000 in park

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 90 Answers

Sounds like a bad idle air motor located on the rear of the intake manifold.

Posted on Sep 28, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2000 ford focus wont stay on idle. hard to start, seems like rich fuel mixture


Did you check to see if you have any codes in ECM or an engine light on ? If it's been sitting for that long, might have other issues which cause this problem.

Nov 27, 2016 | Ford Cars & Trucks

1 Answer

My `94 toyota camry 2.2L, in the morning starts fine the RPM is at 1100, then when it gets warm it goes dowm to 800 RPMs is that normal or it should stays at least between 900 or 1000RPMs, please somebody...


high idle on starting is normal as it is the same as a choke being on. When it drops back it should be around 900. However tacos in cars are not real accurate under a 1000 rpms so have it checked manually with a rev counter. Run the fault codes to check for a problem.

Feb 27, 2015 | 1994 Toyota Camry

1 Answer

Overheating


I had a similar problem i used this head gasket repair but try a supplier in america though :)

Apr 25, 2013 | Cars & Trucks

1 Answer

Iddle too fast when cold,then it iddle fast and low from 2000 rpm and a 1000


Throttle position sensor bad or idle motor bad try unplug idle motor swing buy auto zone for a free scan they will find it

Mar 05, 2011 | Ford Explorer Cars & Trucks

1 Answer

Engine cuts out and sputters at 4000 rpm. sometimes hard starting. Quad 4


cutting out and sputtering at 4000 rpms are normal, its the rev limiter kicking in, all of them do it, as far as hard starting, is it just sense its been cold?? might want to put some fuel stabilizer in it.

Nov 29, 2010 | 1995 Pontiac Grand Am

1 Answer

Over iddles in park


For the high rpm part, have you looked to see if there is a vacuum leakage or possibly a fault in the Idle Air Control motor.

With overheating since jeeps are single belt driven it could be possible the fan is starting up when driving slow or parked because the belt is moving right. Or look for leaks in the coolant maybe it's not getting enough coolant.

fluid in the glove box though, can you be more specific with that one.

May 21, 2009 | 2002 Jeep Grand Cherokee

1 Answer

'89 Camry Engine Revving in Park


You either have an intake manifold leak, a defective trottle position sensor or a stuck idle speed control valve.

Oct 11, 2008 | 1989 Toyota Camry

1 Answer

07 pacifica 3.8 eng. with 4 speed At low rpm's 1200 to 2000 it shudders and has a jerky feeling. It runs great at 70 mph at 2200 rpm and has good floor board acceleration . 4 dealers fail to acknowledge...


Well there is a rev limiter built into the pcm on your car. It is much lower rpm's in park and neutral. When u hit the rev limit of a particular gear selection, the pcm starts cutting out the injectors(fuel). This is normal. As far as the jerky feeling, the only thing I know of is a service bulletin that may apply to your car. It involves a revised torque converter for the transmission. It would only apply if your feeling this at speeds of approx 35 mph or higher when the torque converter lockup engages after a shift. Ask your dealer about a possible tsb for this if you think this may sound like your problem or search for tsb's(technical service bulletin's) yourself on the internet.

Aug 05, 2008 | 2004 Chrysler Pacifica

1 Answer

Automatic choke stopped working- difficulty start- revs dropping low at stop


Quick and easy attempt to fix might be to try some fuel injector cleaner,the purple bottle stuff I put in, is only about $3 a bottle, and seems to eliminate similiar symptoms brought on by bad gas.

Jun 12, 2008 | 1990 Honda Accord

Not finding what you are looking for?
1993 Honda Accord Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...