Question about 2003 Hummer H2

Open Question

The rear bar in back of the rear axle is snapped in half what is the name of the support looking bar..I have a H2 Hummer

Posted by on

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hummer h2 troubleshooting

Check the airsuspension bags might be leaking and may need to be replaced.Recently changed mine on the 2005 Hummer H2

Aug 11, 2014 | 2009 Hummer H2

1 Answer

Level sensor h2 hummer

attached to the frame just to the right of your rear tire on passenger side. just to the left of rear tire on driver side. there are two of them that look like a little hinge. best of luck.

May 10, 2014 | 2004 Hummer H2

1 Answer

2006 hummer h2 axle seal

Did you jack up the rear end, remove the rear tires and brakes, turn the half shaft and through the hole remove the bolts? there are 4 to 5 bolts holding the halfshaft in the housing

Dec 10, 2013 | Hummer Cars & Trucks

1 Answer

Does my 2003 H2 have air supenison or does it have springs and shocks

The H2 comes standard with rear five-link equipped with coil springs. The optional suspension (pictured here) is a self-leveling system that uses airbags. Hidden in the rear axle is an electronic rear locker manufactured by Eaton. Here is a picture of what the optional airbag suspension looks like. The easiest way for you to tell is to get the VIN, located on the drivers side, you can see it through the windshield on the dash or you can look on your insurance card and call the dealer and give it to them. They can use it to see what the vehicle came equipped with. Or you could crawl underneath the H2 and look at the suspension or check out the window sticker if you still have it. Hope that you found this information useful as that is my goal.


Jan 20, 2011 | 2003 Hummer H2

2 Answers

My 2003 h2 died this morning while driving. All

disconnect harness to the pump and jump with test light, turn key on and the light should go on for a few seconds

Nov 28, 2009 | 2003 Hummer H2

1 Answer

I need to remove the luggage racks from my 2007 Hummer h2 SUT

I have the same vehicle and was able to remove mine with the following steps: 1) remove light behind each rear of luggage rack rail using phillips screwdriver (one screw each side). 2) remove molding underneath each light using T20 torx driver (2 screws each side). 3) Loosen cross rails nobs. 4) Side cross rails off of roof.

Nov 27, 2009 | 2007 Hummer H2 SUT

2 Answers

Rear output shaft seal on transfer case is leaking hummer h2

How to remove axle shaft seal on hummer H2

Feb 20, 2009 | 2005 Hummer H2

1 Answer

Hummer h2 transfer case

Only way for this to happen on an H2 (AWD) is for something to break rearward of the lockup hub. Take a look at the splines between the intermediate shaft and centerdifferential or even the teeth on the forward sun gear and/or stepped pinion on the center diff.

As long as you have the t-case torn down for repair be sure to upgrade to the new aluminum mode fork (production upgrade to old plastic forks thru end of 2007 or so). You should also upgrade the rear half of the housing to the 2008 version which has a pressed-in rear prop bushing (better bushing and is also replaceable.

Aug 05, 2008 | 2004 Hummer H2

Not finding what you are looking for?
2003 Hummer H2 Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hummer Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Hummer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides